Programming
(for example, _is displayed even when the handset is near the base unit), re- register the handset.
1Handset:
8i {#}{1}{3}{0}
2Base unit:
Press and hold {x} for about 5 seconds, until the registration tone sounds.
L If all registered handsets start ringing, press the same button to stop. Then repeat this step.
L The next step must be completed within 90 seconds.
3Handset:
Wait until “Base PIN” is displayed. iEnter the base unit PIN (default: “0000”). i M
L If you forget your PIN, contact an authorised service centre.
L When the handset has been registered successfully, w is displayed.
Deregistering a handset
A handset can cancel its own registration that is stored to the base unit. This allows the handset to end its wireless connection with the system.
18i {#}{1}{3}{1}
2{V}/{^}: Select the handset you want to cancel. i M
3{V}/{^}: “Yes” i M
L A confirmation tone sounds.
L The handset does not beep when cancelling its own registration.
4{ic}
Increasing the range of the base unit
You can increase the signal range of the base unit by using a DECT repeater. Please use only the Panasonic DECT
repeater noted on page 4. Contact your Panasonic dealer for details.
Important:
L Before registering the repeater to this base unit, you must turn the repeater mode on.
L Do not use more than one repeater at a time.
Setting the repeater mode
18i {#}{1}{3}{8}
2{V}/{^}: Select the desired setting. i Mi {ic}
Note:
L After turning the repeater mode on or off, _is displayed on the handset momentarily. This is normal and the handset can be used once w is displayed.
29
