8. Attach the matching Left Bottom Handgrip (82) with three | 8 |
|
|
|
1/2” Screws (33). |
|
|
| |
|
|
|
| |
Attach the Right Top Handgrip and the Right Bottom |
|
|
|
|
Handgrip (not shown) as described above. |
|
|
| 82 |
|
|
|
| |
|
| 33 |
|
|
9. Attach a Wheel (58) to the right side of the Base (116) | 9 |
|
|
|
with a Wheel Bolt (56) and a Nut (3) as shown. |
|
|
| |
|
|
|
| |
Attach a Wheel to the left side of the Base (not shown) in |
|
|
|
|
the same way. |
|
|
|
|
|
| 3 |
| 116 |
|
|
|
| |
|
| 58 |
| 56 |
10. Carefully lower the Uprights (55, 64) as shown. | 10 | 114 | 40 | 37 |
| ||||
Press the Console Back (40) onto the back of the |
|
|
| 114 |
Console Base (38). Make sure that Console Back and | 39 |
|
| 50 |
Console Base are mated correctly and that no wires |
|
|
| |
|
|
|
| |
are pinched. Tighten two 1/2” Silver Screws (114) into |
|
|
|
|
the indicated holes. Tighten 3/4” Screws (37) into the |
|
|
|
|
other holes in the Console Back. |
|
|
|
|
Make sure that the left side of the Left Upright (64) is flush |
|
|
|
|
with the left side of the Base (116). Firmly tighten, but do |
|
|
| 38 |
not overtighten, the two Upright Bolts (112) in the left side |
| 55 |
| |
|
| 64 | ||
of the Base. Then, make sure that the Right Upright (55) |
|
|
| |
is flush with the right side of the Base. Tighten the two |
|
|
|
|
Upright Bolts (not shown) in the right side of the Base. |
|
|
|
|
Insert the Left and Right Cup Holders (39, 50) into the |
| 37 |
|
|
large holes in the Console Base (38). If there is a small |
|
|
| |
hole under each Cup Holder, the two Small Clamps (117) |
|
|
|
|
should be attached. Refer to the inset drawing. Loop a |
|
|
|
|
Small Clamp through the hole in the bottom of a Cup |
|
|
| 112 |
Holder and attach it with a 3/4” Screw (37). Attach a Small | 117 |
|
| 116 |
Clamp to the other Cup Holder in the same manner. |
|
| ||
|
|
| ||
Raise the Uprights (55, 64) back to the vertical position. |
|
|
|
|
11.Make sure that all parts are properly tightened before you use the treadmill. Note: There may be hard- ware left over after assembly is completed. Keep the included allen wrench in a secure place; the allen wrench is used to adjust the walking belt (see page 25). To protect the floor or carpet from damage, place a mat under the treadmill.
8
