Sanus Systems LA112 manual Route Cables, For Power Outlets Located Outside the Bellows

7: Route Cables

For Power Outlets Located Outside the Bellows

	[B]
Cable Tie Anchor
	Cable Loops

			[C]						IR Reciever
Cable Bar
									Plug
Cable Hole
Bellows
			No Cable	No Cable
			2” (5 cm)	2” (5cm)
[A]								Bottom Cross Bar
[26]
		AV Cables				Power
						to TV	[06]
		to TV			TV Power Outlet [07]
			AV Cables from				IR Reciever Eye
			Component		(outside bellows)
							CauTION
					Avoid potential property damage! Keep all cables away
					from the center beam of the arm assembly. Do not place
					cables closer than 5cm (2 in.) on either side of the beam.

Route the AV cables [A] over the bottom cross bar, through one of the cable loops [B], then through the cable access port at the back of the arm assembly. Route the power cord [07] over the bottom cross bar, through the opposite cable loop [B], then through the cable access port at the bottom of the arm assembly.

Disconnect the plug end of the IR receiver cable [06] and route the cable over the bottom cross bar, through one of the cable loops [B], then through the access port at thebottom of the arm assembly.

Secure the cables to the bottom cross bar with cable ties [26] as shown. Be sure to keep all cables at least 5cm (2 in.) away from the center beam!

Check that the cables are long enough to allow free movement of the arm assembly, but are not long enough to get caught in the mechanical parts of the arm assembly. Using the remote, adjust the arm up, down, and side to side through its full extension. Secure the cables to the cable bar [C] at the back of the arm assembly.

6901-100189 <01>