Sanyo DSR-C100 Connections, Basic connections, Hold-up switch B Suspicion switch

CONNECTIONS

Carefully read the documentation which is provided with each of the components being connected. Be careful to connect components correctly, as incorrect connections could cause fire or other damage.

Basic connections

(A) Hold-up switch (B) Suspicion switch	(C) Warning signal check output
	(connect a lamp or similar device)

1

2

3

13.8 V DC

Coaxial cable

To VIDEO IN

TV monitor

(sold separately)

Connect all required devices to the control terminals before turning on the power.

(A)Connect a commercially-available hold-up switch (H/GND).

(B)Connect a commercially-available suspicion switch (S/GND).

(C)Connect a commercially-available monitoring lamp to the warning signal output terminal.

This will light or flash in the same way as the warning indicator on the rear of the camera for checking purposes.

Connecting the power supply

1Connect a commercially-available cable to the relay connector (supplied), and then connect the cable to the power supply connector (13.8 V/GND) of the camera.

2Insert the plug of the AC adaptor (supplied) into the relay connector terminal.

3Insert one end of the power cord (supplied) into the AC adaptor, and insert the other end into a wall outlet.

Note:

•The cable that is connected to the relay connector can be up to a maximum of 30 meters in length, but it should not be bound up with any other cables.

•Use UL NISPT-2 (2/18AWG, 105˚CM, VW-1) cables which are listed in UL as the connection cables.

English 13