You cannot use the NP-FV30 “InfoLITHIUM” battery pack with the camcorder.

In the default setting, the power turns off automatically if you leave your camcorder without any operation for about 2 minutes, to save battery power ([Power Save]).

Charging time

Approximate time (min.) required to fully charge a fully discharged battery pack.

Battery pack

AC Adaptor

NP-FV50 (supplied)

155

 

 

NP-FV70

195

 

 

NP-FV100

390

 

 

The charging times shown in the table above are measured when charging the camcorder at a room temperature of 25 °C (77 °F). It is recommended that you charge the battery in a temperature range of 10 °C to 30 °C (50 °F to 86 °F).

To remove the battery pack

Close the LCD screen. Slide the BATT (battery) release lever () and remove the battery pack ().

To use your camcorder continuously for a long time

Connect the AC Adaptor and the power cord (mains lead) to your camcorder and the wall outlet (wall socket). [Details]

By using the AC Adaptor, you can use your camcorder without worrying about the battery running out of charge.

Notes on the AC Adaptor

Do not short-circuit the DC plug of the AC Adaptor or battery terminal with any metallic objects. This may cause a malfunction.

Disconnect the AC Adaptor from the camcorder, while holding both the camcorder and the DC plug.

Related topics

Expected time of recording and playback with each battery pack Remaining battery indicator: Screen indicators

Using your camcorder abroad [Power Save]

Back to top

Copyright 2013 Sony Corporation

44

Page 44
Image 44
Sony PJ790V Charging time, To remove the battery pack, To use your camcorder continuously for a long time, Related topics