Speco Technologies PC Pro Series user manual Recording Setting

4.3Recording Setting

In the Recording dialog box, click OK to accept the new settings, click Cancel to exit without saving, and click Default to revert back to original factory setting.

(1)
(2)	(9)

(3)

(4)

(5)

(6)

(7)

(10)

(8) (11)

(1) Camera Icons

Select the camera number you want to set the recording setting for. To select all the cameras, enable the ALL check box. To select more than one camera, Right click on the camera icon. To select one camera only, Left click on the camera icon. The camera icon turns red when it is selected.

(2) Recording Mode

The blocks from 00 to 23 represent the time in 24-hour clock. To record in full 24 hours, select the recording mode and click the ~ button. If you want to only record at a particular time, click the colored block beside the recording mode then click on the time blocks. When the system starts recording a red triangle mark would appear at the upper left corner of the screen. The recording modes are listed below:

-Always Recording

Record the video from the selected camera and save it to the designated storage path (see also Chapter 4.1 #1).

-Motion Recording

Start recording the video from the selected camera only when the system detects movement. Once a motion is detected, the system automatically saves the previous frames and stop based on the Start Record Prior and Stop Record After settings.

-Smart Recording

Automatically switch to record at the maximum frame rate setting once a motion is detected and if there is no motion, it records at the minimum frame rate setting Set the maximum and minimum frame rate setting in (7) Frame Rate section.

-Voice Detecting Recording

DVR system will record the sound when the voice exceeds the intensity value in Voice Detection setting.

52