NETWORKING GUIDE
PREPARING YOUR COMPUTER FOR VIEWING THE DVR
SVAT ELECTRONICS
now you can see
Any computer that is accessing the DVR will need to be configured to install and run ActiveX controls and the Microsoft Visual C++ 2005 SP1.
(This will require you to be logged into the computer as an Administrator). Either of the following 2 methods will prepare your computer for this:
Method 1 (Recommended):
Add the DVR’s IP address to the Trusted Sites in Internet Explorer.
1.Open up Internet Explorer.
2.Click on Tools.
3.Click on Internet Options.
4.Click on the Security Tab.
5.Click on Trusted Sites.
6.Click on Sites.
7.Type in the IP address of the DVR in the following format: http://192.168.0.93 and click Add.
8.If “Require server verification (https:) for all sites” is selected you will need to uncheck the selection box.
*The IP address used in the example above is for internal network viewing. If you are trying to access the DVR from a location other than where the DVR is located than you will be adding the “External IP Address” to the trusted sites list (see “Finding your External IP Address”).
9.Now you need to change the default settings for the Trusted Sites zone. Click on Default level and change the security level of the zone to Low. This is done by sliding the slider security level to the bottom.
(This will allow ActiveX controls to be downloaded and installed on your computer).
10.Click Apply.
11.Click OK.
CLEARVU11 | 40 |
|
|
