TC electronic SDN BHD M3000 user manual Modulation

VSS™FP - FILM & POST

Lo Damp Freq

(20Hz - 200Hz) Sets the Lo Cut frequency for the next parameter, Lo Damp. Use these two parameters to take away any objectionable low frequencies entering the Reverb tail processor.

Lo Damp

(-18dB - 0dB) Sets the amount of cut in dBs. Used with the previous parameter, Lo Damp Freq.

Modulation

The Reverb Mod and the Space Mod work on the tail of the reverb and give you the ability to tweak the tail in different ways.

To isolate and listen only to the tail you should turn the Early level off; set the mix to 100% and then turn the Depth parameter all the way up.

Try changing the Type of Modulation and listen to its effect on the tail. Be aware that by using extensive modulation of the tail you might get a detuning effect of the source material. In that case reduce the Width and Depth.

Reverb Mod

Type

(Off, Smooth 1, Smooth 2, Perc, Wow, Vintage, Wild) Adjusts the type of modulation.

Rate

(-100, default, +100) Allows you to offset the speed of the LFO from the factory default assigned to each Type.

Width

(0% - 200%) Sets the Width of the modulation.

Space Mod

This group of parameters sets the way the sound moves about the room.

Type

(Off, Normal, Fast, Slow, MidFreq, Sync).

Rate

(-100, default, +100) Allows you to offset the speed of the LFO from the factory default assigned to each type.

Width

(0% - 100%) Sets the width of the modulation.

Depth

(-50, default, +50) Allows you to offset the amount of space modulation from the factory default.

41