Chapter 4
BIOS Configuration
PCI1 to PCI0 Access
Set this option to Enabled to enable access between two different PCI buses (PCI1 and PCI0). The settings are Enabled or Disabled.
Method of Memory Detection
This option determines how your system will detect the type of system memory you have installed. Options are Auto+SPD or Auto only.
DRAM Integrity Mode
This option sets the type of system memory checking. The settings are:
Setting | Description |
|
|
Non ECC | No error checking or error reporting is done. |
|
|
EC | Errors are detected, but no corrections will be made. |
|
|
ECC Hardware | Errors are detected, and single bit errors are corrected. |
|
|
DRAM Refresh Rate
This option specifies the interval between refresh signals to DRAM system memory. The settings are 15.6 us (microseconds), 31.2 us, 62.4 us, 124.8 us, or 249.6 us.
Memory Hole
This option specifies the location of an area of memory that cannot be addressed on the ISA bus. The settings are Disabled,
SDRAM RAS# to CAS# Delay
This option specifies the length of the a inserted between the RAS and CAS signals of the DRAM system memory access cycle if SDRAM is installed. The settings are Auto, 2 SCLKs or 3 SCLKs. The Optimal default setting is Auto.
SDRAM RAS# Precharge
(CHANGE) This option specifies the length of the RAS precharge part of the DRAM system memory access cycle when SDRAM system memory is installed in this computer. The settings are Auto, 2 SCLKs, or 3 SCLKs.
Power Down SDRAM
If this option is set to Enabled, the SDRAM Power Down feature is enabled. The settings are Enabled or Disabled.
http://www.tyan.com
52
