T h e U n i f i e r
Erasing All Settings
Should you wish to make a clean start, you can reset the Unifier to its factory default settings by pressing and holding both the POWER OFF button and the STOP button for ten seconds. Continue to hold both buttons as the display flashes ERASE nine times, then CLEAR.
POWER 
OFF
Button
STOP
Button
The Unifier displays a self testing routine for a few seconds, then returns to normal operating mode.
Recalling Pre-Programmed Settings
If you wish to recall a previously programmed code number so that you can write it down, follow these steps:
1 | Press and hold both the DEVICE button you want to |
| identify and the MUTE button. Keep holding them |
| down until the display says SET. |
2 | Press the INFO button.The Device Name will |
| appear (blink twice) followed by the three digit |
number.
22
