Windsor 10080480 operating instructions Maintenance-Troubleshooting, Problem Cause Solution

MAINTENANCE-TROUBLESHOOTING

PROBLEM	CAUSE	SOLUTION
No Power, Nothing	Is the cord plugged in.	Plug in cord.
	Circuit breaker tripped in building.	Reset breaker.
Runs
	Faulty switch.	Call for service.
	Faulty power cord or pigtail.	Call for service.
	Vacuum circuit breaker tripped.	Reset breaker.
Vacuum Motor Will Not	Faulty main vacuum switch.	Call for service.
Run	Loose wiring.	Call for service.
	Faulty vac motor.	Call for service.
	Debris lodged in vac shoe.	Remove debris from vac shoe.
Vacuum Motor Runs	Dome gasket defective or missing.	Replace as necessary.
But Suction Is Poor	Vacuum hose cracked or hose cuff loose.	Replace or repair as necessary.
	Recovery tank full / float ball stuck in the	Turn off vac motor. Drain and rinse
	up position.	recovery tank.
	Pump switch in intermittent position.	Turn to continuous or use buttons on
Poor Or No Water Flow		handle
(Carpet Is Streaky)	Jets clogged or missing.	Clean using a vinegar /water solution or
		replace.
	Solution filter clogged.	Drain solution tank and clean solution
		filter.
	Faulty solenoid.	Call for service.
Brush Does Not Spin	Main switch off or in hand tool mode.	Turn main switch to machine mode.
	Brush circuit breaker tripped.	Reset circuit breaker.
	Brush belt broken.	Replace as necessary.
	Faulty brush motor.	Call for service.

4-8 86302100 CLIPPER DUO 10/02/07