ASSEMBLY
HORIZONTAL ADJUSTMENT
•Slightly loosen the nuts securing the bagger RH and LH horizontal adjustment brackets. Loosen only enough so the brackets keep their position, but allow them to be moved.
•Move the brackets the amount forward or backward you wish the bag assembly to move. Retighten the nuts securely.
VERTICAL ADJUSTMENT
•Slightly loosen the nuts securing the vertical adjust- ment brackets. Loosen only enough so the brackets keep their position, but allow them to be moved.
•Move the brackets the amount up or down you wish the bag assembly to move. Retighten the nuts securely.
•Reinstall the bagger assembly and check the bagger to fender fit. If necessary, repeat the procedure until proper fit is attained.
•After proper fit is attained, remove bagger from trac- tor and install bagger latch (4) to tractor back plate as shown. Tighten securely.
•Install and carefully lower bagger to actuate latch.
•Measure distance between bagger and latch as shown.
|
| 6MM (1/4") - 9MM (3/8") |
HORIZONTAL | TOP SURFACES | |
EVEN | ||
ADJUSTMENT |
| |
BRACKET |
|
|
VERTICAL | FIG. 7 | |
ADJUSTMENT |
|
|
BRACKET |
|
|
|
| 02967 |
BAGGER |
|
|
LATCH |
|
|
FIG. 6
02983
10MM (7/16") - 16MM (5/8")
BAGGER
LATCH
FIG. 7
If distance is not 10mm - 16mm carefully remove bagger and repeat vertical adjustment as needed.
TO ASSEMBLE AND INSTALL MULCHER PLUG (See Fig. 8a)
•Remove spring retainer and pin from handle.
•Insert plug into handle. Make sure that the letter "A" on both the plug and handle are on the same side and that they can both be seen from the top when laying on the ground.
•Secure with pin and retainer spring provided. For in- stallation see "To Convert Mower" in Section 5 of this manual.
HANDLE
RETAINER
SPRING
PIN | A |
A
PLUG
02 2 1 4
FIG. 8a
ATTACH HOOD SCOOP (See Fig. 8b)
9 | Fig. 8b (step1, 2, 3) |