Husqvarna 235e, 240e manuel dutilisation Fuel Handling, Fueling, Fuel safety

Page 14

FUEL HANDLING

Fuel

Note! The machine is equipped with a two-stroke engine and must always be run using a mixture of gasoline and two-stroke oil. It is important to accurately measure the amount of oil to be mixed to ensure that the correct mixture is obtained.When mixing small amounts of fuel, even small inaccuracies can drastically affect the ratio of the mixture.

 

!

WARNING! Always ensure there is

 

adequate ventilation when handling fuel.

 

 

 

 

 

Gasoline

•Use good quality unleaded gasoline.

•The lowest recommended octane grade is 87 ((RON+MON)/2). If you run the engine on a lower octane grade than 87 so-called knocking can occur. This gives rise to a high engine temperature and increased bearing load, which can result in serious engine damage.

•When working with continuous high revs (e.g. limbing) a higher octane is recommended.

Running-in

Avoid running at a too high speed for extended periods during the first 10 hours.

Two-stroke oil

•For best results and performance use HUSQVARNA two-stroke engine oil, which is specially formulated for our air-cooled two stroke-engines.

•Never use two-stroke oil intended for water-cooled engines, sometimes referred to as outboard oil (rated TCW).

•Never use oil intended for four-stroke engines.

Mixing ratio

1:50 (2%) for all engines.

Gasoline, litre

Two-stroke oil, litre

 

 

 

2% (1:50)

 

 

5

0,10

 

 

10

0,20

 

 

15

0,30

 

 

20

0,40

 

 

US gallon

US fl. oz.

 

 

1

2 1/2

 

 

2 1/2

6 1/2

 

 

5

12 7/8

 

 

Mixing

•Always mix the gasoline and oil in a clean container intended for fuel.

•Always start by filling half the amount of the gasoline to be used. Then add the entire amount of oil. Mix (shake) the fuel mixture. Add the remaining amount of gasoline.

•Mix (shake) the fuel mixture thoroughly before filling the machine’s fuel tank.

•Do not mix more than one month’s supply of fuel at a time.

•If the machine is not used for some time the fuel tank should be emptied and cleaned.

Chain oil

•We recommend the use of special oil (chain oil) with good adhesion characteristics.

•Never use waste oil. This results in damage to the oil pump, the bar and the chain.

•It is important to use oil of the right grade (suitable viscosity range) to suit the air temperature.

•In temperatures below 32°F (0°C) some oils become too viscous. This can overload the oil pump and result in damage to the oil pump components.

•Contact your service agent when choosing chain oil.

Fueling

WARNING! Taking the following

!precautions, will lessen the risk of fire:

Do not smoke and do not place any hot objects in the vicinity of fuel.

Always stop the engine and let it cool for a few minutes before refuelling.

When refuelling, open the fuel cap slowly so that any excess pressure is released gently.

Tighten the fuel cap carefully after refuelling.

Always move the machine away from the refuelling area before starting.

Clean the area around the fuel cap. Clean the fuel and chain oil tanks regularly. The fuel filter must be replaced at least once a year. Contamination in the tanks causes malfunction. Make sure the fuel is well mixed by shaking the container before refuelling. The capacities of the chain oil tank and fuel tank are carefully matched. You should therefore always fill the chain oil tank and fuel tank at the same time.

WARNING! Fuel and fuel vapor are

! highly flammable. Take care when handling fuel and chain oil. Be aware of the risks of fire, explosion and those associated with inhalation.

Fuel safety

•Never refuel the machine while the engine is running.

•Make sure there is plenty of ventilation when refuelling or mixing fuel (gasoline and 2-stroke oil).

•Move the machine at least 10 ft (3 m) from the refuelling point before starting it.

•Never start the machine:

1If you have spilled fuel or chain oil on the machine.Wipe off the spillage and allow remaining fuel to evaporate.

2If you have spilled fuel on yourself or your clothes, change your clothes. Wash any part of your body that has come in contact with fuel. Use soap and water.

3If the machine is leaking fuel. Check regularly for leaks from the fuel cap and fuel lines.

14 – English

5451546-92 Rev.3 2007-12-19

Page 13 Page 15
Image 14
Page 13 Page 15
Contents 235e 240e 5451546-92 Rev.3 OFF Half Full 5451546-92 Rev.3 Retreat path Introduction Symbols on the machineThank you for using a Husqvarna product Dear customerWhat is what on the chain saw? Contents For Canada General Safety PrecautionsBefore using a new chain saw Personal protective equipment Machine′s safety equipmentAlways use common sense Chain brake and front hand guardCutting equipment Cutting equipment designed to reduce kickback Sharpening your chain and adjusting depth gauge settingGeneral rules BarTensioning the chain Lubricating cutting equipmentFitting the bar and chain General Safety Precautions / AssemblyHappen when the chain touches the operator Chain drive sprocketFuel Fuel safetyFuel Handling FuelingFuel Handling / Starting and Stopping Starting and stoppingBefore use Basic safety rulesWorking Techniques General working instructionsBasic cutting technique Tree felling techniqueFreeing a tree that has fallen badly Carburetor adjustment Working Techniques / MaintenanceHow to avoid kickback GeneralAir filter MaintenanceMuffler Spark plugMaintenance schedule Daily maintenance Every 5-10 hTechnical Data Technical dataRecommended cutting equipment for Canada Bar ChainFederal Emission Control Warranty Statement Your Warranty Rights and ObligationsKickback safety precautions American Standard Safety PrecautionsSafety precautions for chain saw users Other safety precautionsWarranty Statement
Related manuals
Manual 68 pages 3.51 Kb

240e, 235e specifications

The Husqvarna 235E and 240E are two popular models in the world of lightweight chain saws, designed to deliver excellent performance for both novice and experienced users. Ideal for homeowners and professionals alike, these models are perfect for tasks such as cutting firewood, pruning, and handling small trees.

One of the standout features of the Husqvarna 235E and 240E is their lightweight construction. Weighing in at around 10.3 pounds, these chainsaws are easy to maneuver, reducing fatigue during extended use. The ergonomic design enhances comfort, making it easier for users to maintain a firm grip, especially during challenging cutting tasks.

These models are equipped with the powerful X-Torq engine technology, which provides a significant increase in efficiency. The X-Torq engine reduces fuel consumption by up to 20%, allowing users to work longer without the need for frequent refueling. Additionally, the engine's design minimizes harmful emissions, making the 235E and 240E more environmentally friendly.

Another important characteristic is the chainsaw’s emissions control system. Husqvarna has integrated an efficient air filtration system in both models, ensuring that dirt and debris are kept away from the engine for extended periods. This results in less maintenance and longer operational life.

Ease of starting is also a highlight of these models. The Smart Start technology ensures that the chainsaw can be started with minimal effort, allowing users to get to work quickly. The combined choke and stop control further simplify the starting process, ensuring a smooth operation every time.

Safety features are not overlooked in the Husqvarna 235E and 240E. Each model comes with a chain brake that responds quickly to stop the chain in case of kickback, which is essential for preventing accidents during operation. The low-vibration design reduces strain on the hands and arms, fostering a safer and more comfortable user experience.

Overall, the Husqvarna 235E and 240E offer a combination of power, efficiency, and user-friendly features that set them apart in their category. With a focus on performance and safety, these chainsaws are an excellent choice for anyone looking to tackle cutting, trimming, and pruning tasks with ease and confidence. Whether you are a homeowner looking to manage your yard or a professional seeking reliable equipment, the 235E and 240E are worthy contenders.
Top Page Image Contents