Husqvarna CA 150 manuel dutilisation Bevel gear, Replacing the tine, Maintenance schedule

Page 10

MAINTENANCE

Bevel gear

The bevel gear is filled with the right quantity of grease at the factory. However, before using the machine you should check that the bevel gear is filled three-quarters (40g) full with grease. Use HUSQVARNA special grease.

CAUTION! The gear housing must not be filled completely with grease. The grease expands as the machine heats up during operation. If the gear housing was completely filled with grease it could damage the seals and lead to leakage of grease.

The grease in the bevel gear does not normally need to be changed except if repairs are carried out.

Replacing the tine

Loosen the split pin and cotter pin.

Remove the tine unit from the angle gear’s output axle.

Loosen the 3 screws holding the tine.

Replace the tine with a new and assemble in the reverse order.

Maintenance schedule

Below you will find some general maintenance instructions. If you need further information please contact your service workshop.

Daily maintenance

1

2

3

1Check that the guard is undamaged and not cracked. Replace the guard if it has been exposed to impact or is cracked.

2Check that the blades do not move when the engine is idling or when the choke is in the start throttle position.

3Check that the tines are undamaged and show no signs of cracking or other damage. Replace the tines if necessary.

Weekly maintenance

1

1Check that the bevel gear is filled three-quarters (40g) full with lubricant. Fill if necessary using special grease.

10 – English

Image 10
Contents GB FR ES KEY to Symbols SymbolsContents Personal protective equipment Safety InstructionsMachine′s safety equipment Cutting attachment guardGeneral safety precautions Safety instructions before starting workGeneral working instructions Basic safety rulesSafety instructions after completing work Basic working techniquesWhat is WHAT? What is what on the cultivator attachment?Fitting the bevel gear AssemblyAssembling the guard Starting and Stopping Check before startingBevel gear MaintenanceMaintenance schedule Replacing the tineTechnical Data Technical data1150001-20 ´z+RÆ,¶0n¨ ´z+RÆ,¶0n¨