Husqvarna 966004001, 115 145727, 525 88 56-01 manual Husqvarna S Obligations Under the Warranty

Page 16

Refer to Section 3 for items not covered by this warranty

*All consumer product use must have been limited to the owners residence. Warranted for noncommercial, nonprofessional, noninstitutional and nonincome producing use.

**HUV 2 Year or 2,000 Hour Powertrain (The engine assembly, unitized transaxle assembly (gasoline vehicle), motor, and main frame assembly are warranted with respect to parts and labor against defects in material and workmanship or a period of two years or 2000 hours of operation, whichever first occurs, from the date of purchase.) & 1 Year or 1,000 Hour Body Warranty (All remaining components of the vehicle not specified otherwise and all other original equipment options and accessories supplied by Husqvarna are warranted with respect to parts and labor against defects in material and workmanship for a period of one year or 1000 hours of operation, whichever first occurs, from the date of purchase.)

HUVs Gas & Diesel Powered Battery: 0 – 6 months free replacement and 7 – 12 months prorated

HUVs Electric Powered – 4 year or 16,000 Energy Unit Limited Warranty Period

***Husqvarna safety apparel warranty is from the date of the customers original purchase for defects in material and workmanship. Normal wear, tear or abuse is not covered under warranty. All care and maintenance instructions must be followed as stated by the manufacturer on the care label. The fit of the protective apparel/boot is not covered under warranty.

****Battery 1 Year prorated limited warranty with 100% replacement during the first 6 months.

Lifetime Warranty (Parts and Labor): All tiller tines and trimmer shafts against breakage. Proof of purchase required.

Lifetime Warranty (“PARTS ONLY” after initial warranty expiration): Ignition coils and modules on handheld product. Proof of purchase required.

SECTION 2: HUSQVARNAS OBLIGATIONS UNDER THE WARRANTY

Husqvarna will repair or replace defective components without charge for parts or labor if a component fails because of a defect in material or workmanship during the warranty period.

SECTION 3: ITEMS NOT COVERED BY THIS WARRANTY

The following items are not covered by this warranty:

(1)Normal customer maintenance items which become worn through normal regular use, including, but not limited to, belts, blades, blade adapters, bulbs, clutches, clutch drums, filters (fuel line, fuel filters, air filters, oil filters), sprockets, guide bars, lubricants, rewind springs, saw chain, spark plugs, starter ropes and tiller tines;

(2)Natural discoloration of material due to ultraviolet light;

(3)Engine and drive systems not manufactured by Husqvarna; these items are covered by the respective manufacturers warranty as provided in writing with the product information supplied at the time of purchase; all claims must be sent to the appropriate manufacturer.

(4)Lawn and garden attachments that are covered by a third party which gives a warranty, all claims for warranty should be sent to the manufacturer.

(5)Commercial or consumer mowing decks with sand abrasion damage.

(6)Emission Control System components necessary to comply with CARB-TIER II and EPA regulations which are manufactured by third party engine manufacturer.

SECTION 4: EXCEPTIONS AND LIMITATIONS

This warranty shall be inapplicable to defects resulting from the following:

(1)Accident, abuse, misuse, negligence and neglect, including stale fuel, dirt, abrasives, moisture, rust, corrosion, or any adverse reaction due to incorrect storage or use habits;

(2)Failure to operate or maintain the unit in accordance with the Owners/Operators manual or instruction sheet furnished by Husqvarna;

(3)Alterations or modifications that change the intended use of the product or affects the products performance, operation, safety, or durability, or causes the product to fail to comply with any applicable laws; or:

(4)Additional damage to parts or components due to continued use occurring after any of the above.

REPAIR OR REPLACEMENT AS PROVIDED UNDER THIS WARRANTY IS THE EXCLUSIVE REMEDY OF THE PURCHASER. HUSQVARNA SHALL NOT BE LIABLE FOR ANY INCIDENTAL OR CONSEQUENTIAL DAMAGES FOR BREACH OF ANY EXPRESS OR IMPLIED WARRANTY ON THESE PRODUCTS EXCEPT TO THE EXTENT PROHIBITED BY APPLICABLE LAW. ANY IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE ON THESE PRODUCTS IS LIMITED IN DURATION TO THE WARRANTY PERIOD AS DEFINED IN THE LIMITED WARRANTY STATEMENT. HUSQVARNA RESERVES THE RIGHT TO CHANGE OR IMPROVE THE DESIGN OF THE PRODUCT WITHOUT NOTICE, AND DOES NOT ASSUME OBLIGATION TO UPDATE PREVIOUSLY MANUFACTURED PRODUCTS.

Some states do not allow the exclusion of incidental or consequential damages, or limitations on how long an implied warranty lasts, so the above limitations or exclusions may not apply to you. This warranty gives you specific legal rights, and you may also have other rights which vary by state.

SECTION 5: CUSTOMER RESPONSIBILITIES

The product must exhibit reasonable care, maintenance, operation, storage and general upkeep as written in the maintenance section of the Owners/Operators manual. Should an operational problem or failure occur, the product should not be used. Failure caused by continued use is not covered by warranty. Product should be delivered, at owners expense, as is, to an authorized Husqvarna Servicing Retailer for evaluation. Proof of purchase, as explained in section 6, rests solely with the customer.

SECTION 6: PROCEDURE TO OBTAIN WARRANTY CONSIDERATION

It is the Owners and Retailers responsibility to make certain that the Warranty Registration Card is properly filled out and mailed to Husqvarna. This card should be mailed within ten (10) days from the date of purchase in order to confirm the warranty and to facilitate post-sale service. Proof of purchase must be presented to the authorized Husqvarna retailer in order to obtain warranty service. This proof must include date purchased, model number, serial number, and complete name and address of the selling retailer. To obtain the benefit of this warranty, the product believed to be defective must be delivered to an authorized Husqvarna retailer in a timely manner, no later than thirty

(30)days from date of the operational problem or failure. The product must be delivered at the owners expense. Downtime, pick-up and delivery charges are not covered by this warranty. An authorized Husqvarna retailer can be located by calling 1-800-HUSKY-62 or visiting www.husqvarna.com

Subject to change without notice.

IR

HUSQVARNA 7349 Statesville Road, Charlotte, NC 28269

Part Number 525 88 56-01

 

Image 16
Contents Operator and Parts Manual Contents Safety Rules Safe Operation Practices for RIDE-ON MowersGeneral Operation Slope OperationService Safe Operation Practices for RIDE-ON Mowers ChildrenSafety Rules Container Contents Parts IdentificationUnpacking Instructions Tools Required1INSTALL Plate and Hanger AssemblyInstalling Spacer Plug Container Installation 5LOWER Chute InstallationChute / Hood Installation 6UPPER Chute InstallationLeveling Mower Deck Operation Improved Bagging TipsGeneral Recommendations StorageParts QTY Description Item Part no Parts QTY Description Limited Warranty Husqvarna S Obligations Under the Warranty 115 145727 IR 05/20/09

525 88 56-01, 966004001, 115 145727 specifications

The Husqvarna 966004001, 115 145727, and 525 88 56-01 are among the most reliable products in the Husqvarna lineup, showcasing advanced technology and superior performance in outdoor power equipment. These models are designed to meet the needs of both professional landscapers and avid gardening enthusiasts, providing exceptional power and efficiency for various tasks.

The Husqvarna 966004001 is a versatile chainsaw characterized by its robust build and ergonomic design. This chainsaw features a powerful engine that enhances cutting performance while maintaining fuel efficiency, making it ideal for heavy-duty tasks such as felling trees and cutting firewood. One notable aspect of this model is its LowVib technology, which reduces vibrations for greater user comfort and control during operation, minimizing operator fatigue. Additionally, the easy-start system ensures that users can quickly and effortlessly start the engine, even in cold conditions.

The Husqvarna 115 145727 is designed for users looking for a lightweight yet powerful trimmer. This model is equipped with a reliable engine that delivers efficient performance while being easy to maneuver in tight spaces. Its innovative auto-return stop switch and ergonomic handle make it simple to operate, ensuring that users can tackle tasks such as trimming grass and clearing weeds with ease. The trimmer head features a semi-automatic line feed, allowing the user to quickly and efficiently feed new line while working, enhancing productivity and reducing downtime.

The Husqvarna 525 88 56-01 is a professional-grade brushcutter that stands out for its durability and performance. It offers a robust power-to-weight ratio, making it suitable for heavy brush clearing and landscape maintenance. This model includes advanced balance and ergonomics, allowing users to work for extended periods without discomfort. The 525 88 56-01 also features a heavy-duty cutting head for enhanced efficiency and cutting precision. The smart start technology simplifies starting, ensuring that professionals can rely on it for their daily tasks without unnecessary delays.

In summary, the Husqvarna 966004001, 115 145727, and 525 88 56-01 exemplify quality, technology, and user-centered design in outdoor power equipment. Each model incorporates features that enhance performance, comfort, and ease of use, making them exceptional choices for tackling outdoor projects with confidence and efficiency. Whether you are a professional or a homeowner, these tools are engineered to handle tough jobs with reliability and precision.