Husqvarna CT16 owner manual Contents of Shipping Carton To Remove TILLER/CULTIVATOR, From Carton

Page 3
PARTS
TABLE OF CONTENTS

OWNER'S INFORMATION

Record the following information about your unit so that you will be able to provide it in case of loss or theft.

MODEL NUMBER:

 

 

PURCHASE DATE:

/

/

DEALER'S NAME AND ADDRESS:

CITY:

(Enter complete 8 digit number from model plate on unit)

CODE NO.:

 

SERIAL NO.:

STATE:TELEPHONE:

WARNING: This unit is equipped with an internal combustion engine and should not be used on or near any unimproved forest- covered, brush-covered or grass-covered land unless the engine's exhaust system is equipped with a spark arrester meeting applicable local or state laws (if any). If a spark arrester is used, it should be maintained in effective working order by the operator. In the State of California the above is required by law (Section 4442 of the California Public Resources Code). Other states may have similar laws. Federal laws apply on federal lands. A spark arrester for the muffler is available through your nearest engine authorized service dealer.

SAFETY RULES

2

MAINTENANCE

10-11

TABLE OF CONTENTS

3

SERVICE AND ADJUSTMENTS

12-13

OWNER'S INFORMATION

3

STORAGE

14

CONTENTS OF PARTS BAG

3

TROUBLESHOOTING

15

ASSEMBLY

4-5

REPAIR PARTS

16-21

OPERATION

6-9

WARRANTY

Back Cover

CONTENTS OF SHIPPING CARTON

TO REMOVE TILLER/CULTIVATOR

1

- 10 inch Tiller/Cultivator completely assembled

FROM CARTON

 

except for the handles and throttle control assembly

Remove plastic parts bag for tiller/cultivator from

1

- Upper Handle

carton.

1

- Left Hand Lower Handle

Remove handles from the carton.

1

- Right Hand Lower Handle

 

1

- Owner's Manual (Not Shown)

Remove remainder of packing material from carton.

1

- Bag of Assembly Parts (See below)

Lift the tiller/cultivator out of carton and place on

 

 

TOOLS REQUIRED FOR ASSEMBLY

a hard, level surface.

Remove packing material from around tines.

2

- 7/16 inch Wrenches (or adjustable wrenches)

 

1

- Regular Screwdriver

PARTS BAG

1

- Pair Scissors

 

 

 

CONTENTS OF PARTS BAG (shown actual size)

1- 10-16 x 1-1/2 Inch Washer Head Tap Screw

1 - Tie Strap

1 - Shut-Off Switch and Parts

California Proposition 65 WARNING!

The engine exhaust from this product contains chemicals known to the State of California to cause cancer, birth defects or other reproductive harm.

3

Image 3
Contents CT16 Before USE Safety RulesFuel Safety Operating SafetyContents of Shipping Carton To Remove TILLER/CULTIVATOR Tools Required for AssemblyFrom Carton To Install the Handle Assembly AssemblyTo Install the Throttle CON Trol AssemblyTo Install the Remote SHUT-OFF Switch Know Your TILLER/CULTIVATOR OperationTo Stop TILLER/CULTIVATOR To Operate CultivatorBefore Starting Engine Fill GAS Gasoline and OIL Mixture To Start the EngineMix gasoline and oil as follows Tilling Hints Cultivating HintsDepth rod on the back of the tiller/cultivator Check Transmission Grease Level MaintenanceGeneral LubricationEngine can be worn out in a very Engine AIR CleanerSpark Plug Cylinder Exhaust PortsTine Replacement Service & AdjustmentsSERV&ADJ Carburetor AdjustmentOther StorageTILLER/CULTIVATOR EngineTrouble Cause Correction Trouble Shooting