
3.Insert the pillow (47) into the lounge seat recepta- cle. Rotate the pillow 180º to change its position.
3 |
47 |
4. The hydrotherapy spa operates on a | |||
fault circuit interrupter (GFCI) installed in your home. This procedure must be performed by a qualified | |||
electrician. A wiring diagram is found on the inside of the electronics pack as a reference. Under no | |||
circumstances should the spa be wired by someone other than a qualified electrician. Before you have | |||
the spa wired, make sure that it is in the position you want and that it can be easily serviced, if needed. | |||
5. Make sure that a qualified electrician has wired the | 5 | 3 | |
spa to a | |||
|
| ||
Remove the two warning decals (see page 5) from |
| Fill to Here | |
|
| ||
the spa shell. Using a damp cloth, wipe the spa shell |
|
| |
clean. Before filling the spa, make sure that it is |
| 5 | |
in the desired position and that there is room to |
| ||
|
| ||
easily service it. Once the spa is filled, it will |
|
| |
have to be drained before it can be moved. |
|
| |
Insert a garden hose into one of the filter housings, |
|
| |
begin filling the spa. Do not use soft water. The |
|
| |
spa may be filled with cold water; however, if warm |
|
| |
or hot water is used, the spa will be ready for use |
|
| |
sooner. Fill the spa until the water is at the level |
|
| |
shown at the right. Do not overfill the spa. |
|
| |
Refer to the inset drawing. Set the Filters (5) into the |
| Garden Hose | |
filter housings. Next, screw the Filter Covers (3) into |
| ||
|
| ||
the filter housings until they are fully seated. |
|
| |
6. Pull down one of the straps on the Spa Cover (11) | 6 |
| |
and hold the Buckle (26) against one of the premium |
| ||
| Strap | ||
cedar panels on the spa. (Note: To position the |
| ||
| 11 | ||
Buckle correctly, have a second person hold the |
| Latch | |
strap on the opposite side of the Spa Cover snug.) |
| ||
|
| ||
The Spa Cover must be snug. Do not place the |
| 26 | |
Buckle over the grooves between the premium |
| ||
|
| ||
cedar panels. Refer to the inset drawing. Remove |
|
| |
the latch from the Buckle (26). Attach the Buckle to |
|
| |
the premium cedar panel with two #4 x 3/4” Screws |
| 27 | |
(27). |
| ||
|
| ||
Attach the other three Buckles (26) to the premium |
| Strap | |
|
| ||
cedar panels in the same way. |
|
| |
Remove the Spa Cover (11) from the spa. |
| 26 | |
|
|
9