Image IMHS80081 manual Diagram of the Console Using the Console, SPA JET Unit Operation

Page 12

DIAGRAM OF THE CONSOLE

USING THE CONSOLE

Refer to the console diagram above. The function of each console control is explained below:

Primer: This opening allows you to prime the spa jet unit before operation (see PRIMING THE SPA JET UNIT on page 10).

Air Control: Determines the amount of air that is in the spa jet system during operation. If the control is turned to the left, the amount of air flowing through the jets will increase. If the control is turned to the right, the amount will decrease.

Thermostat: Controls the temperature of the water. The water heats at about 1.7¡F an hour with the cover on. The thermostat can be set to heat the water from

70¡F to 104¡F. Use a medical or other accurate ther- mometer to check the temperature of the water.

On/Off: Turns the spa jet unit on and off. When you first press the on/off button, the spa jet unit will run at low speed, providing gentle hydrotherapy. Press the button again and the jet unit will run at high speed, providing more intense hydrotherapy. Press the button a third time and the spa jet unit will shut off.

The spa jet unit also features an automatic mode, which heats and filters the water when the spa is left unattended. When the spa jet unit is first plugged in, or if the buttons on the console have not been used for longer than twenty minutes, the automatic mode will begin filtering or heating the water, as needed.

Note: to keep the filter and heat cycles from run- ning, the power cord must be unplugged.

SPA JET UNIT OPERATION

The spa jet unit features three hydro-therapy jets, a whirlpool jet, a suction vent, and a filter housing.

The whirlpool jet (B), located on the left side of the spa jet unit, directs the flow of the water to create a whirlpool action in the hydrotherapy spa.

The three hydro-therapy jets (A), located on the front of the spa jet unit, focus the water massage on your neck and back.

 

B

 

A

D

C

The suction vent (C), located on the right side of the spa jet unit, pulls the water into the spa unit, in order to operate the system. The suction cover should always be in place over the suction vent. Never operate the spa without the suction cover in place.

The filter (D), is locat- ed on the left side of the spa jet unit, behind the filter cover. The fil- ter can be removed for cleaning and replace-

C

Filter Cover

Screws

Filter Cover

D

12

Page 11 Page 13
Image 12
Page 11 Page 13
Contents QUESTIONS? Model No. IMHS80081 Serial NoCustomer HOT Line Table of Contents Limited WarrantyPage Page Page Before YOU Begin If you set up the hydrotherapy spa inside If you set up the hydrotherapy spa outsideChoosing a Location for the Hydrotherapy SPA Do not use an extension cord with the hydrotherapy spaAssembly Before beginning assembly, carefully readFollowing information and instructions Page Using the Hydrotherapy SPA Priming the SPA JET UnitPlugging in the Hydrotherapy SPA Testing and Treating the Water Starting the Hydrotherapy SPASecuring the SPA Cover Diagram of the Console Using the Console SPA JET Unit OperationMaintenance TROUBLE-SHOOTING Symptom the Water does not Heat Symptom the Water is not Being Cleaned by the FilterSymptom the Water Pulsates or There is Minimum Water Flow Symptom the SPA JET Unit Cavitates During USEOrdering Replacement Parts Part LISTÑModel No. IMHS80081 Key No. Qty Description
Top Page Image Contents