Ryobi Outdoor 875r manual California Emission Regulations, Spark Arrestor

Page 3

CALIFORNIA EMISSION REGULATIONS

This engine meets U.S. EPA PH1 and 2000 model year and later California emissions regulations for small off-road engines. These units are identified by the label on the engine of your product. A typical identification label is shown.

To ensure that your unit continues to meet these regulations, refer to the following information and instructions in this operator’s manual.

California Proposition 65 Warning:

WARNING

THE ENGINE EXHAUST FROM THIS

PRODUCT CONTAINS CHEMICALS

KNOWN TO THE STATE OF CALIFORNIA

TO CAUSE CANCER, BIRTH DEFECTS

OR OTHER REPRODUCTIVE HARM.

SPARK ARRESTOR

NOTE: For users on U.S. Forest Land and in the states of California, Maine, Oregon and Washington. All U.S. Forest Land and the state of California (Public Resources Codes 4442 and 4443), Oregon and Washington require, by law that certain internal combustion engines operated on forest brush and/or grass-covered areas be equipped with a spark arrestor, maintained in effective working order, or the engine be constructed, equipped and maintained for the prevention of fire. Check with your state or local authorities for regulations pertaining to these requirements. Failure to follow these requirements could subject you to liability or a fine. This unit is factory equipped with a spark arrestor. If it requires replacement, ask your LOCAL SERVICE dealer to install the Accessory Part #180890 Spark Arrestor Screen.

FOR QUESTIONS, CALL 1-800-345-8746 IN U.S. OR 1-800-265-6778 in CANADA

WARNING!

Read the Operator’s Manual(s) and follow all warnings and safety instructions. Failure to do so can result in serious injury to the operator and/or bystanders.

3

Image 3
Contents OPERATOR’S Manual Introduction Table of ContentsSpark Arrestor California Emission RegulationsBefore Operating Symbol MeaningSafety Warnings for GAS Trimmers Rules for Safe OperationWhile Operating Other Safety WarningsUnleaded Fuel Safety and International SymbolsSymbolmeaning Safety Alert Symbol For Service INFORMATION, CallON/OFF Stop Control HOT Surface WarningSharp Blade Choke Control Applications Know Your UnitAdjusting the J-HANDLE Assembly InstructionsOIL and Fuel Information Recommended OIL TypeAdding OIL to Crankcase Initial USE Fueling Unit Using Blended FuelsUsing Fuel Additives Recommended Fuel TypeCold Start First Start of the Day or Engine Ran Out of Fuel STARTING/STOPPING InstructionsStarting Instructions Stopping InstructionsRemoving the Cutting Attachment or Add-Ons Installing the Cutting Attachment or Add-OnsOperating Instructions Operating the CLICK-LINKSYSTEMAdjusting Trimming Line Length Holding the TrimmerTips for Best Trimming Results Decorative Trimming Maintenance and Repair InstructionsMaintenance Schedule Frequency Maintenance Required Refer toWinding the Inner Reel With New Line Line Installation for the SpeedspoolReleasing the Inner Reel Installing a Prewound ReelCleaning the Speedspool Speedspool Replacement PartsChanging the OIL Checking the OIL LevelCleaning the Air Filter AIR Filter MaintenanceCheck Fuel Carburetor AdjustmentClean Air Filter Adjust Idle Speed ScrewRemove the rocker arm cover and gasket Rocker ARM ClearanceRocker Arms Adjusting Nuts Feeler Gauge Gasket Spark Arrestor Maintenance ACCESSORIES/REPLACEMENT PartsReplacing the Spark Plug Long Term Storage Cleaning and StorageCleaning StorageTroubleshooting U S ET I O N Engine SpecificationsPage Manufacturers Warranty Coverage Owners Warranty ResponsibilitiesREV. a OPERATOR’S Manual Part no