TROUBLESHOOTING
PROBLEM POSSIBLE CAUSE | SOLUTION | |
|
|
|
Engine starts, runs, | Carburettor requires adjustment. | Turn idling speed screw “T” clockwise to increase idling |
and accelerates but |
| speed. If chain turns at idle, turn idling speed screw “T” |
will not idle. |
| anticlockwise to decrease speed. Wear protective |
|
| equipment and observe all safety instructions. See |
|
| Figure 24. |
|
|
|
Engine starts and runs, | 1. | Chain oil tank empty. |
but chain is not rotating. | 2. | Check chain tension for overtight |
| ||
|
| condition. |
| 3. | Check for oiler function. |
1.Oil tank should be filled every time fuel tank is filled.
2.Tension chain per instructions in “Maintenance – Adjusting the Chain Tension” earlier in this manual.
3.Run at half throttle 30 to 45 seconds. Stop saw and check for oil dripping from
a Ryobi service dealer.
Bar and chain running hot and smoking.
1.Chain brake engaged.
2.Chain tension too tight.
3.Check guide bar and chain assembly.
4.Check guide bar and chain for damage.
1.Release chain brake, refer to “Operation – Operating Chain Brake” earlier in this manual.
2.Tension chain per instructions in “Maintenance – Adjusting the Chain Tension” earlier in this manual.
3.Refer to “Maintenance – Assembling the Bar and Chain” earlier in this manual.
4.Inspect guide bar and chain for damage.
NOTE: The carburettor adjustment needle(s) are equipped with plastic cap(s) which prevent anticlockwise rotation from the original factory adjustment. If your product exhibits specific performance problem(s) where the Troubleshooting Section recommends an anticlockwise needle adjustment and you have made no adjustments since the original purchase, take the product to a factory authorised service dealer for repair. In most cases, the needed adjustment is a simple task for the factory trained service representative.
WARRANTY
GUARANTEE – STATEMENT
(RTSA / RTUK / RTG)
All Ryobi products are guaranteed from defects in material and workmanship, for a period of
Defects caused by normal wear and tear, unauthorised/improper maintenance/handling or overload are excluded from this guarantee as are accessories such as battery packs, bulbs, blades and bits,etc.
In the event of malfunction within the guarantee period, please return the assembled product with proof of purchase to your dealer or nearest Ryobi Service Centre.
Your statutory rights in respect of defective products remain unaffected by the warranty.
Ryobi Technologies GmbH, Itterpark 7,
Ryobi Technologies, Customer Services, Anvil House, Tuns Lane,
Ryobi Technologies, BP 50012 - 95945 Roissy CDG Cedex – FRANCE
Ryobi Technologies Australia PTY Limited,
19 | UK |