Ryobi 170r, 180r, 190r manual Before Operating, For Safe Operation

SAFETY WARNINGS

•CORD SETS: Make sure your cord set is in good condition. When using a cord set, be sure to use a cord that is heavy enough to carry the current that your unit will draw.

An undersized cord set will cause a drop in line voltage resulting in loss of power and overheating. The table shows the correct size to use depending on the cord length and nameplate amperage rating. If in doubt, use the next heavier size line gauge. The smaller the gauge number, the heavier the cord. To reduce the possibility of disconnection of the unit from the cord set during operation, see Fig. 14, page 10.

MINIMUM WIRE SIZE FOR EXTENSION CORDS

FOR 120 VOLT APPLIANCES

Cord length (ft)	25	50	100		150
Amperage Rating		Wire size (AWG)
6 to 10 amps	18	16	14		12
10 to 12 amps	16	16	14		12
12 to 16 amps	14	12		NOT
			RECOMMENDED

•A nameplate on your unit indicates what voltage it uses. Never connect the unit to an AC voltage that differs from this voltage.

•Inspect all extension cords and the unit power connection periodically. Look closely for deterioration, cuts or cracks in the insulation. Also inspect the connections for damage. Replace the cords if any defects or damage appear.

•Avoid dangerous environments. Never operate your unit in damp or wet conditions. Moisture is a shock hazard.

•Do not use the unit in the rain.

•Do not handle the plug or Blower/Vacuum with wet hands or standing on any

wet surfaces.

BEFORE OPERATING

•Read the instructions carefully. Be familiar with the controls and proper use of the unit.

•Children and adolescents must not manipulate units, except for adolescents in training and under the supervision of a specialist.

•Before each use, thoroughly inspect your Blower/Vacuum for loose or damaged parts. Do not use until adjustments or repairs are made.

•All guards and safety attachments must be installed properly before operating the unit.

•Use the unit only in daylight or good artificial light.

•Keep all bystanders, especially children and pets, at least 30 feet (9.2 m) away from the unit during operation.

•Inspect the area before starting the Blower/ Vacuum. Remove all debris and hard or sharp objects such as glass, wire, etc.

FOR SAFE OPERATION

•Do not leave the Blower/Vacuum plugged in when not in use, changing attachments, or while being serviced.

•Do not allow this product to be used as a toy.

•Use the right tool. Do not use unit for for any job except that for which it is intended. Use only the manufacturer’s recommended attachments.

•Avoid accidental starting. Do not carry plugged-in unit with your finger on the switch. Be sure switch is off when plugging in.

•Do not abuse the power cord. Never carry the unit by the cord or yank the plug out of the receptacle. Keep the cord away from heat, oil and sharp edges.

•Do not unplug by pulling on the cord. To unplug, grasp the plug, not the cord.

•Always remain alert. Use common sense. To prevent injury to yourself and others, do not operate this unit if you are fatigued.

•Do not operate the unit while under the influence of drugs, alcohol or medication.

•Wear goggles or safety glasses at all times when operating this Blower/Vacuum.

•Use a face mask or dust mask if operation is dusty.

•Do not overreach or use the unit from unstable surfaces such as ladders, trees, steep slopes, rooftops, etc. Keep proper footing and balance at all times.

•Dress properly. Do not operate this Blower/Vacuum when barefoot or wearing open sandals. Always wear sturdy, rubber-soled footwear. The use of gloves, ear/hearing protection and long pants are recommended.

4