Ryobi RY08576 manual Spark Arrestor, Cleaning the Exhaust Port and Muffler, Fuel CAP, Spark Plug

Page 14

MAINTENANCE

SPARK ARRESTOR

The muffler is equipped with a spark arrestor screen inside muffler body. After extended use the screen can become dirty and the screen may need to be replaced by an autho- rized servicing dealer.

WARNING:

To avoid a fire hazard, never run the blower without the spark arrestor in place.

CLEANING THE EXHAUST PORT AND MUFFLER

Depending on the type of fuel used, the type and amount of oil used, and/or your operating conditions, the exhaust port, muffler, and/or spark arrestor screen may become blocked with carbon deposits. If you notice a power loss with your gas powered tool, you may need to remove these deposits to restore performance. We highly recommend that only qualified service technicians perform this service.

FUEL CAP

The fuel cap contains a non-serviceable filter and a check valve. A clogged fuel filter will cause poor engine per- formance. If performance improves when the fuel cap is loosened, the check valve may be faulty or filter clogged. Replace the fuel cap if required.

WARNING:

A leaking fuel cap is a fire hazard and must be replaced immediately.

SPARK PLUG

This engine uses a Champion RCJ-6Y with 0.63 mm (0.025 in.) electrode gap. Use an exact replacement and replace annually.

STORAGE (1 MONTH OR LONGER)

Drain all fuel from the tank into a container approved for gasoline. Run engine until it stops.

Clean all foreign material from the blower. Store it in a well-ventilated place that is inaccessible to children. Keep away from corrosive agents such as garden chemicals and de-icing salts.

Abide by all Federal and local regulations for the safe storage and handling of gasoline. Excess fuel should be used up in other 2-cycle engine powered equipment.

14

Page 13 Page 15
Image 14
Page 13 Page 15
Contents OPERATOR’S Manual Save this Manual for Future ReferenceTable of Contents IntroductionGeneral Safety Rules ServiceSpecific Safety Rules RefuelingSymbols Symbol Name DESIGNATION/EXPLANATIONSymbol Signal Meaning Features Product SpecificationsFeatures AssemblyNozzle Upper Tube Throttle Control Assembling the Blower TubesElbow Tube Bellows Tube Clamp Throttle Cable Cable TIEOperation Adjusting Harness and Waist StrapsAdjusting Throttle Control Handle Mixing the FuelStarting and Stopping Engine Switch Throttle TriggerFilling the Tank Choke Chokelever LeverProper Operating Position Operating the BlowerTo engage the cruise control/throttle lock Throttle TriggerReplacing and Cleaning AIR Filter MaintenanceGeneral Maintenance To clean the air filterFuel CAP Cleaning the Exhaust Port and MufflerSpark Arrestor Spark PlugAccessories AccessoriesTroubleshooting Warranty Limited Warranty StatementMaintenance Requirements MANUFACTURER’S Warranty CoverageOWNER’S Warranty Responsibilities CoverageCarburetor Assy Emissions Maintenance Schedule and Warranted Parts ListAIR Filter Assy Fuel Tank AssyPage Service Model NO. and Serial no California Proposition
Top Page Image Contents