SECTION3: ASSEMBLINGYOURLAWNMOWER
LoosePartsin Carton
Grass Catcher Assembly.
Owner's Manual (not shown).
Hardware Pack.
Upper and Lower Handle w/Guide Rod. Wheel Assemblies (4)
Repeat this step for all wheels, being certain that all four wheels are in the same height position for an even cut. Refer to Figure 1 for cutting height positions.
Also, be certain the smaller front wheels and the larger rear wheels are mounted correctly to the front and rear of the mower as shown in Figure 1.
ToolsRequired
Phillips head screwdriver.
Adjustable wrench, a wrench set or socket set.
AttachingWheels
The wheels for your mower will not require tools to install. Notice that there are two large wheel assemblies
and two smaller wheel assemblies. The large wheels fit on the rear and the small wheels are for the front of the
mower. To install the wheels:
F | le ! |
Hubcap Assembly
Hubcap
Right Front View
Cutting Height Positions
Low
Medium
High
Figure 1
Rest the mower on its side or place supporting blocks under one side of the mower.
Refer to Figure 1 and insert the hubcap assembly through the wheel and thread the complete assembly into the desired height adjustment position by hand.
NOTE: It is recommended to use the highest cutting position initially to avoid scalping of the grass.
By putting fingers into the grooves in the hubcap assembly, tighten firmly.
AssemblingHandle
InstallingtheLower Handles
Insert long end of the lower handle into the handle base. Make certain the small hole in the end of the
handle is lined up with the hole in handle base. Using one of the two longer self tapping screws from the hardware pack, insert the screw through the tooth washer, flat washer, and the handle cap as shown in Figure 2.
Align the handle cap so it rests flush against the handle base, and tighten the screw into the lower handle using a phillips screwdriver.
Repeat this step for the remaining lower handle. Once both lower handles are installed, insert the lower handle plugs into the upper ends of the lower handles as shown in Figure 2.
Installingthe Upper Handle
Standing behind the lawnmower with the upper handle, make certain the two holes that wilt hold the
blade / motor control are on the right hand side. See Figure 2 for proper alignment of upper handle.
Blade / Motor Control
Washer Head Screw \
Upper Handle ._
Lower Handle PI_
iut
Cord Insulator
Hq
Base
. Handle Cap
j Flat Washer
Washer
Self Tapping
Screw
Figure 2