ASSEMBLY
UNPACKING
This product requires assembly.
Carefully remove the tool and any accessories from the box. Make sure that all items listed in the packing list are included.
Inspect the tool carefully to make sure no breakage or damage occurred during shipping.
Do not discard the packing material until you have care- fully inspected and satisfactorily operated the tool.
If any parts are damaged or missing, please call
PACKING LIST
Cultivator
Drag Bar
Pull Pin
Hitch Pins (2)
Felt Washers (2)
Inner Tines (2)
Outer Tines (2)
Ryobi Exact Mix
Wheel Assembly (Accessory)
Operator’s Manual
WARNING:
If any parts are damaged or missing do not operate this tool until the parts are replaced. Failure to heed this warn- ing could result in serious personal injury.
WARNING:
Do not attempt to modify this tool or create accesso- ries not recommended for use with this tool. Any such alteration or modification is misuse and could result in a hazardous condition leading to possible serious personal injury.
WARNING:
To prevent accidental starting that could cause serious personal injury, always disconnect the engine spark plug wire from the spark plug when assembling parts.
POSITIONING THE HANDLEBAR
See Figure 2.
Loosen the two handlebar knobs.
Unfold the handlebar into operating position.
NOTE: Do not use force. If there is binding, continue to loosen the knobs. Do not allow throttle cable to become pinched when raising the handlebar.
Retighten the handlebar knobs.
| HANDLEBAR |
HANDLEBAR | KNOBS |
|
Fig. 2
8