Partner Tech T330+ Declaration of Conformity, Troubleshooting Table Cause Remedy

TROUBLESHOOTING TABLE

WARNING: Always stop unit and disconnect spark plug before performing all of the recommended remedies below except remedies that require operation of the unit.

TROUBLE	CAUSE		REMEDY
Engine will not	1. ON/OFF switch in OFF		1.	Move ON/OFF switch to ON position.
start.		position.
	2. Engine flooded.		2.	See “Starting a Flooded Engine” in
	3. Fuel tank empty.			Operation Section.
			3.	Fill tank with correct fuel mixture.
	4. Spark plug not firing.		4.	Install new spark plug.
	5. Fuel not reaching		5.	Check for dirty fuel filter; replace.
		carburetor.		Check for kinked or split fuel line;
	6. Carburetor requires			repair or replace.
			6.	Contact an authorized service dealer.
		adjustment.
Engine will	1. Carburetor requires		1.	See “Carburetor Adjustment” in
not idle		adjustment.		Service and Adjustments Section.
properly.	2. Crankshaft seals worn.		2.	Contact an authorized service dealer.
	3. Compression low.		3.	Contact an authorized service dealer.
Engine will not	1.	Air filter dirty.	1. Clean or replace air filter.
accelerate,	2. Spark plug fouled.		2. Clean or replace plug
lacks power,	3.	Carburetor requires		and regap.
or dies under			3. Contact an authorized service dealer.
a load.	4.	adjustment.	4. Contact an authorized service dealer.
		Carbon build-up on
		muffler outlet screen.
	5.	Compression low.	5. Contact an authorized service dealer.
Engine	1.	Choke partially on.	1.	Adjust choke.
smokes	2.	Fuel mixture incorrect.	2.	Empty fuel tank and refill with
excessively.	3.	Air filter dirty.		correct fuel mixture.
			3.	Clean or replace air filter.
	4.	Carburetor requires	4.	Contact an authorized service dealer.
		adjustment.
Engine runs	1. Fuel mixture incorrect.		1. Empty fuel tank and refill with
hot.	2. Spark plug incorrect.			correct fuel mixture.
			2. Replace with correct spark plug.
	3. Carburetor requires		3. Contact an authorized service dealer.
		adjustment.
	4. Carbon build-up on		4. Contact an authorized service dealer.
		muffler outlet screen.

DECLARATION OF CONFORMITY

relating to 2000/14/EC

EC Declaration of Conformity relating to 2000/14/EC

We, Electrolux Home Products, Inc., Texarkana, TX, 75501, USA, Tél. : +1 903 223 4100, declare under sole responsibility that the Partner model T330+ brushcutter was assessed in accordance with Annex V of the DIRECTIVE and from serial numbers 2005--335N00001 and onwards, conforms to the provisions of the DIRECTIVE. The cutting width is 431 mm. The measured sound power is 108 dB and the guaranteed sound power is 114 dB.

Texarkana 05--12--01

Michael S. Bounds, Director

Product Safety and Standards

18