Porter-Cable PCV2250 instruction manual Quick Facts, Call 1-800-888-2468 EXT

Page 20

QUICK FACTS

CALL 1-800-888-2468 EXT 2

TO FIND A LOCAL AUTHORIZED SERVICE CENTER NEAR YOU FOR REPAIRS AND SERVICE PART PURCHASES.

GAS

OIL

WATER

PRESSURE

ADJUSTMENT

PUMP

BY-PASS MODE

THERMAL

RELIEF VALVE

HOSE

ENGINE

SOAP/CHEMICALS

NOZZLE

MAINTENANCE

SCHEDULE

STORAGE OR

WINTERIZING

Use fresh high quality gas.

Add stabilizer to fuel tank and run engine for 5 minutes before storage.

Engine oil: Refer to engine manual supplied with this unit.

Some units are equipped with a low oil sensor and adequate oil must be added or the unit will not start.

Use only cold water.

Don't operate unit with clogged or missing water filter/screen.

Don't operate unit without adequate water supply to pump. Adequate water supply is a minimum of 20 psi and 5 gpm.

The pressure setting is preset at the factory to achieve optimum cleaning. If you need to lower the pressure setting, refer to the owners manual for proper procedure.

Pull gun trigger every 2 minutes while engine is running. Don't allow water to freeze in pump.

Siphon RV antifreeze into pump for cold weather storage or long term storage.

Never leave unit running for more than 2 minutes without pulling gun trigger; doing so will destroy pump and void warranty.

Pump is equipped with a thermal relief valve. If the water overheats, this valve will open and allow a gush of water to escape. Once the water is released, the valve closes allowing the pump to operate normally.

Don't allow hoses to contact the HOT engine muffler during or after use. Never pull the hose to move the unit.

Do not adjust or attempt maintenance without consulting engine manual or an authorized engine service center.

Add stabilizer to fuel tank and run engine for 5 minutes before storage. Always turn on the water before starting the engine.

Use only soaps and chemicals designed for pressure washer use.

Keep nozzle unclogged. Refer to manual for cleaning procedures. Chemical/soap cannot be siphoned in high pressure setting. Only in low setting.

Follow recommended maintenance schedule for engine & pump. Refer to manuals.

Draw clean water through chemical inlet.

Add stabilizer to fuel tank and run engine for 5 minutes before storage. Don't allow water to freeze in pump, gun, wand or hoses.

Siphon RV antifreeze into pump for cold weather storage or long term storage.

ALWAYS REFER TO THE MANUALS SUPPLIED WITH THIS UNIT

D25802

20- ENG

Image 20
Contents Instruction General Information Safety Guidelines / Definitions Important Safety InstructionsRisk to Breathing Risk Unsafe Operation Carton Contents Assembly Instructions Operating Instructions Basic Elements of a Pressure WasherPressure Washer Terminology Pressure Washer Operating FeaturesBasic Elements of Engine HOW to USE Wand To change quick connect nozzlesHOW to Siphon Chemicals and Cleaning Solvents Starting Maintenance Engine WandHOW to Clean the Water Inlet Filter Storage Engine PumpTrouble Shooting Guide Problem Cause CorrectionWill not draw Limited Warranty Responsibility of Original Purchaser initial UserENG D25802 Quick Facts Call 1-800-888-2468 EXT