Poulan PPG 6000 General Maintenance, CLEANING/REPLACING AIR Filters, Changing Engine OIL

Page 17

MAINTENANCE

WARNING:

When servicing, use only identical Poulan Pro replacement parts. Use of any other parts may create a hazard or cause product damage.

Only the parts shown on the parts list are intended to be repaired or replaced by the customer. All other parts should be replaced at a Poulan Pro Authorized Service Center.

GENERAL MAINTENANCE

Keep the generator in a clean and dry environment where it is not exposed to dust, dirt, moisture, or cor- rosive vapors. Do not allow the cooling air slots in the generator to become clogged with foreign material such as leaves, snow, etc.

Do not use a garden hose to clean the generator. Water entering the fuel system or other internal parts of the unit can cause problems that will decrease the life of the generator.

To clean the unit:

Use a soft bristle brush and/or vacuum cleaner to loosen and remove dirt and debris.

Clean air vents with low pressure air that does not exceed 25 psi.

Wipe the exterior surfaces of the generator with a damp cloth.

CLEANING/REPLACING AIR FILTERS

See Figure 13.

For proper performance and long life, keep air filters clean:

Release the upper and lower retaining clips and remove the air filter cover.

Remove the outer filter element and the inner precleaner element.

If the filter elements are dirty, clean with warm, soapy water. Rinse and let dry.

Apply a light coat of engine oil to the elements, then squeeze it out.

Put the filter elements back together and replace in the air filter compartment, being careful to place the outer filter element closest to the air filter cover.

Replace the cover and snap retaining clips back in place to secure.

NOTE: Do not run the generator without the air filters. Rapid engine wear will result.

CHANGING ENGINE OIL

See Figure 14

Remove the oil dipstick.

Place a container underneath the oil drainage bolt to collect used oil as it drains.

Unscrew the oil drainage bolt and remove.

Allow oil to drain completely.

Fig. 13

OIL FILL

TUBE

OIL DRAINAGE

BOLT

OIL DIPSTICK

Fig. 14

Reinstall the oil drainage bolt and tighten securely.

Refill with oil following the instructions in the “Checking/Adding Oil” section on page 14.

NOTE: Disposal of used oil should be at an approved disposal site. See your local oil retailer for more information.

17

Image 17
Contents Model PPG Introduction Table of ContentsGenerator produces powerful voltage Safety RulesUnintentional sparking can result in fire or electric shock Symbol Name DESIGNATION/EXPLANATION SymbolsSymbol Signal Meaning ServiceHOT Specifications FeaturesKnow Your Generator Engine SwitchGrounding Terminal ReceptaclesUnassembled Parts AssemblyPacking List Installing Handle AssemblyInstructions Installing Foot Assembly Installing Wheel AssemblyGrounding the Generator OperationBefore Operating the Unit ApplicationsCHECKING/ADDING OIL CHECKING/ADDING FuelStopping the Engine Starting the EngineCapacity Power ManagementElectrical General Maintenance MaintenanceCLEANING/REPLACING AIR Filters Changing Engine OILMaintenance Schedule Cleaning Fuel Sediment CUPSpark Plug Maintenance Storage Problem Possible Cause Solution TroubleshootingPage KEY Part Description Portable Electric GENERATOR- -MODEL NO. PPG6000 DecalsKEY Part Description KEY Part Description KEY Part Description KEY Part Description EPA Emissions Control Warranty Statement Emissions Maintenance Schedule and Warranted Parts List WarrantyLimited Warranty Service Notes Service Notes HOW to Order Repair Parts Service Model NO. and Serial no