Poulan 545212826, 952711826 instruction manual Maintenance, Service and Adjustments

Page 7

MAINTENANCE

WARNING: Always stop unit and dis- connect spark plug wire (or disconnect pow- erhead from power source) before performing maintenance.

CHECK FOR DAMAGED OR WORN PARTS

Contact an authorized service center for re- placement of damaged or worn parts.

STine Guard -- Discontinue use of cultivator if tine guard is damaged.

CHECK FOR LOOSE

FASTENERS AND PARTS

SClevis pins

SHitch pin clips

INSPECT AND CLEAN UNIT AND DECALS

S After each use, inspect complete unit for loose or damaged parts. Clean the unit and decals using a damp cloth with a mild deter- gent.

SWipe off unit with a clean dry cloth.

TINE MAINTENANCE

WARNING: The tines will continue to spin after the engine stops or after the throttle trigger has been released. To avoid serious injury, make sure the tines have stopped coasting and disconnect the spark plug (or disconnect powerhead from power source) before performing work on the tines.

WARNING: Always replace tines that are bent, warped, cracked, broken, or damaged in any other way. Never attempt to straighten and reuse a damaged tine. Use only specified replacement tines. Wear pro- tective gloves when handling or performing maintenance on the tines to help avoid injury.

SERVICE AND ADJUSTMENTS

TINE REPLACEMENT

WARNING: The tines will continue to spin after the engine stops or after the throttle trigger has been released. To avoid serious injury, make sure the tines have stopped coasting and disconnect the spark plug (or disconnect powerhead from power source) before performing work on the tines.

WARNING: Wear protective gloves when handling or performing maintenance on the tines to avoid injury. The tines become very sharp from use.

1. Remove the hitch pin clips and clevis pins.

2.Remove the tines and felt cushions from the shaft.

3.Clean and oil the shaft.

4.Replace the tines and the felt cushions.

Clevis Pin

 

5.

Repeat previous steps on opposite side.

 

6.

Reinstall clevis pins and hitch pin clips.

 

 

 

 

NOTE: When installed correctly, the hubs

 

Hitch Pin Clip

on the tines will face each other. The letters

 

“R” stamped on the tines will be on the right

 

 

 

 

side of the cultivator and the letters “L” will be

 

 

on the left side.

7

Image 7
Contents Manual de Instrucciones Manuel d’Instructions Safety Rules Identification of Safety SymbolsOperator Safety Wear hearing protection Do not smoke or allow smoking near fuel or the powerheadCord disconnecting from the unit during op- eration They can be caught in moving partsCultivating Safety UNIT/MAINTENANCE SafetyTransporting and Storage Tine Guard OperationKnow Your Cultivator Attachment Cutting TinesCultivating Installing AttachmentInstalling Attachment Hanger Operating PositionService and Adjustments MaintenanceCanada, contact Limited WarrantySeasonal Storage Statesville Road