Poulan SM4018 Limited Warranty, Load Adjustment Engine, Empty fuel tank and refill with

Page 16

TROUBLESHOOTING TABLE

WARNING: Always stop unit and disconnect spark plug before performing all of the recommended remedies below except remedies that require operation of the unit.

 

TROUBLE

CAUSE

REMEDY

 

 

 

 

 

Engine will not

1. Ignition switch off.

1. Move ignition switch to ON.

 

start or will run

2. Engine flooded.

2. See “Difficult Starting” in

 

only a few

 

 

 

Operation Section.

 

seconds after

3. Fuel tank empty.

3. Fill tank with correct fuel mixture.

 

starting.

4. Spark plug not firing.

4. Install new spark plug.

 

 

5. Fuel not reaching

5. Check for dirty fuel filter; replace.

 

 

 

carburetor.

 

Check for kinked or split fuel line;

 

 

 

 

 

repair or replace.

 

 

 

 

 

 

Engine will

1.

Carburetor requires

1. See “Carburetor Adjustment” in the

 

not idle

 

adjustment.

 

Service and Adjustments Section.

 

properly.

2.

Crankshaft seals worn.

2. Contact an authorized service dealer.

 

 

 

 

 

 

 

Engine will not

1.

Air filter dirty.

1.

Clean or replace air filter.

 

accelerate,

2.

Spark plug fouled.

2.

Clean or replace plug and regap.

 

lacks power,

3.

Chain brake engaged.

3.

Disengage chain brake.

 

or dies under

4.

Carburetor requires

4.

Contact an authorized service dealer.

 

a load.

 

adjustment.

 

 

 

 

 

 

 

Engine

1. Too much oil mixed with

1. Empty fuel tank and refill with

 

smokes

 

gasoline.

 

correct fuel mixture.

 

excessively.

 

 

 

 

 

Chain moves

1. Idle speed requires

1. See “Carburetor Adjustment” in the

 

at idle speed.

 

adjustment.

 

Service and Adjustments Section.

 

 

2. Clutch requires repair.

2.

Contact an authorized service dealer.

 

 

 

 

 

 

LIMITED WARRANTY

Poulan PRO warrants to the original pur- chaser that each new Poulan PRO brand gasoline chain saw is free from defects in material and workmanship and agrees to re- pair or replace under this warranty any de- fective gasoline chain saw as follows from the original date of purchase.

2YEARS - Parts and Labor, when used for Household purposes.

60DAYS - Parts and Labor, when used for Commercial, Professional, or Income Pro- ducing purposes.

30DAYS - Parts and Labor, if used for rental purposes.

This warranty is not transferable and does not cover damage or liability caused by im- proper handling, improper maintenance, or the use of accessories and/or attachments not specifically recommended by Poulan PRO for this chain saw. Additionally, this warranty does not cover damage caused by improper handling, improper maintenance, or if the saw is altered in any way which in our judgement affects its condition or operation. This warranty does not cover tune--up, spark plugs, filters, starter ropes, starter springs, chain sharpening, bars, chains, and other parts which wear and require replacement with reasonable use during the warranty pe- riod. This warranty does not cover predeliv-

ery set--up, installation of guide bar and chain, and normal adjustments explained in the instruction manual such as carburetor adjustments and chain tension adjustments. This warranty does not cover transportation costs.

THIS WARRANTY GIVES YOU SPECIFIC LEGAL RIGHTS, AND YOU MAY HAVE OTHER RIGHTS WHICH VARY FROM STATE TO STATE.

NO CLAIMS FOR CONSEQUENTIAL OR OTHER DAMAGES WILL BE ALLOWED, AND THERE ARE NO OTHER EXPRESS WARRANTIES EXCEPT THOSE EXPRESS- LY STIPULATED HEREIN.

SOME STATES DO NOT ALLOW LIMITA- TIONS ON HOW LONG AN IMPLIED WAR- RANTY LASTS OR THE EXCLUSION OR LIMITATIONS OF INCIDENTAL OR CONSE- QUENTIAL DAMAGES, SO THE ABOVE LIMITATIONS OR EXCLUSION MAY NOT APPLY TO YOU.

The policy of Poulan PRO is to continuously improve its products. Therefore, Poulan PRO reserves the right to change, modify, or discontinue models, designs, specifications, and accessories of all products at any time without notice or obligation to any purchaser.

16

Page 15 Page 17
Image 16
Page 15 Page 17
Contents Manual de Instrucciones Manuel d’Instructions 545123649 8/25/06Safety Rules Identification of SymbolsPlan Ahead Operate Your SAW Safely Maintain Your SAW in Good Working OrderHandle Fuel with Caution KickbackKickback Safety Features Reduce the Chance of KickbackMaintain Control Avoid Obstructions Clear The Working AreaChain Brake and CKA Angle Computed kickback angle CKA TableCKA without chain brake SM4018Assembly Inside view Chain Brake Adjustment located on Chain BrakeAttaching the BAR & Chain If not Already attachedCutters Adjusting the tensionDrive Links Place chain onto the sprocket ON/STOP Switch Know Your SAWThrottle Trigger Throttle LockoutStarting Fueling EngineBAR and Chain Lubrication Important Points to RememberStarting a Warm Engine Cutting MethodsImportant Points Tree Felling Techniques Felling Large TreesNotch CUT and Felling the Tree Ger than 30 seconds at full throttleBucking Using a LOG or Support Stand Cutting a Fallen TreeTypes of Cutting Used for Bucking Bucking Without a SupportService PruningLimbing and Pruning Important Points LimbingCleaning the air filter Cleaning the Spark ARREST- ING ScreenCarburetor Adjustment Inspect Muffler and Spark Arresting ScreenNeed ASSISTANCE? Load Adjustment Engine Limited WarrantyEmpty fuel tank and refill with Your Warranty Rights and Obliga Tions The U.S. Environmental ProtectionIntermediate 125 hours Extended 300 hours

SM4018, 545123649 specifications

The Poulan 545123649 SM4018 chainsaw is a powerful tool designed for both professionals and homeowners who require a reliable and efficient cutting solution for their outdoor tasks. Recognized for its robust design and advanced features, this chainsaw is ideal for felling trees, limbing, and cutting firewood.

One of the main features of the SM4018 is its 40cc engine, which provides ample power for cutting through even the toughest wood. With a high-performance engine, users can expect quick acceleration and reduced emissions, making it an environmentally friendly option. The powerful engine ensures that the chainsaw delivers consistent performance over extended periods, ideal for demanding projects.

Another standout characteristic of the Poulan 545123649 is its 18-inch bar and chain. This length strikes a perfect balance, allowing users to tackle both small and sizable tasks with ease. The chain is precision-engineered to deliver smooth and efficient cutting, helping users achieve their desired results with minimal effort.

The chainsaw is equipped with an automatic lubrication system, which continually oils the chain during operation. This feature significantly reduces wear and tear, prolonging the life of both the chain and the bar. Furthermore, the convenient oil reservoir is easily accessible, allowing for quick refills when necessary.

Comfort and usability are top priorities in the design of the SM4018. The chainsaw features an ergonomic handle with anti-vibration technology, which reduces user fatigue during prolonged use. This makes it a suitable tool for both novice users and seasoned professionals who need to work for extended periods without discomfort.

Safety is paramount when operating any power tool, and the Poulan SM4018 doesn’t fall short in this regard. It comes equipped with a chain brake system that stops the chain immediately in case of kickback, protecting the user from potential injuries. Additionally, the easy-access air filter ensures that the engine remains clean, maximizing its performance and longevity.

Overall, the Poulan 545123649 SM4018 chainsaw combines power, precision, and safety to deliver an exceptional cutting experience. With its advanced features and user-friendly design, it is a reliable choice for anyone looking to invest in a high-quality chainsaw for their outdoor needs.
Top Page Image Contents