Poulan 271490 manual To Remove Mower, To Install Mower

Page 20

SERVICE AND ADJUSTMENTS

WARNING: TO AVIOD SERIOUS INJURY, BEFORE PERFORMING ANY SER- VICE OR ADJUSTMENTS:

1.Depress clutch/brake pedal fully and set parking brake.

2.Place gearshift lever in neutral (N) position.

3.Place attachment clutch in “DISENGAGED” position.

4.Turn ignition key to “STOP” and remove key.

5.Make sure the blades and all moving parts have completely stopped.

6.Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with plug.

TRACTOR

TO REMOVE MOWER

Mower will be easier to remove from the right side of tractor.

1.Place attachment clutch in “DISEN- GAGED” position.

2.Move attachment lift lever forward to lower mower to its lowest position.

3.Roll belt off engine pulley.

4.Remove small retainer spring, and lift clutch spring off pulley bolt.

5.Remove large retainer spring, slide collar off and push housing guide out of bracket.

6.Disconnect anti-sway bar from chassis bracket by removing retainer spring.

7.Disconnect suspension arms from rear deck brackets by removing retainer springs.

8.Disconnect front links from deck by removing retainer springs.

9.Raise lift lever to raise suspension arms. Slide mower out from under trac- tor.

IMPORTANT: If an attachment other than the mower deck is to be mounted on the tractor, remove the front links and hook the clutch spring Into square hole in frame.

TO INSTALL MOWER

1.Raise attachment lift lever to its highest position.

2.Slide mower under tractor with deflec- tor shield to right side of tractor.

3.Lower lift lever to its lowest position.

4.Connect front links to mower deck and secure with retainer springs.

5.Connect suspension arms to rear deck brackets and secure with retainer springs.

6.Connect anti-sway bar to chassis bracket and secure with retainer spring.

7.Push clutch cable housing guide into bracket, slide collar onto guide and secure with large retainer spring.

8.Install belt onto engine pulley.

 

 

Suspension

 

 

 

Arms

 

 

Small Retainer

 

Square Hole

Clutch Spring

Spring

 

Engine

 

 

Pulley

 

 

 

Retainer Spring

 

 

Front Link

 

 

 

Anti-Sway Bar

 

 

Retainer Springs

 

 

(Both Sides)

 

 

 

Collar

 

 

 

Housing

Large

 

 

Guide

Bracket

Deflector

 

Retainer

Shield

 

Spring

 

 

 

 

20

Image 20
Contents Model no Table of Contents IV. Service III. ChildrenWash hands after handling Product Specifications Customer ResponsibilitiesAPI-SF-SJ U1RUnassembled Parts Before Removing Tractor from Skid Tools Required for AssemblyTo Remove Tractor from Carton Install Seat Check Tire Pressure Check for Proper Position of ALL BeltsCheck Deck Levelness Check Brake SystemOperation Know Your Tractor HOW to USE Your Tractor Before Starting the Engine To Start Engine ADD GasolineMowing Tips General Recommendations Lubrication Chart Before Each USETractor Clean AIR Screen EngineTransaxle Cooling BeltsCleaning To Install Mower To Remove MowerTo Level Mower Housing SIDE-TO-SIDE AdjustmentTo Replace Mower Blade Drive Belt Belt RemovalTo Replace Motion Drive Belt Belt InstallationTo Adjust Brake To Adjust Steering Wheel ALIGN- Ment Replacing BatteryFront Wheel TOE-IN/CAMBER To Remove Wheel for RepairsTo Adjust Carburetor Battery StorageTroubleshooting Chart Problem Cause CorrectionExcessive Mower blades will Limited Warranty Suggested Guide for Sighting Slopes for Safe Operation