Poulan 195018 Cleaning, Clean Air Screen, Air Filter, Engine Oil Filter, Muffler, Spark Plugs

Page 18
CLEAN AIR SCREEN

MAINTENANCE

Unlock drain valve by pushing inward and turning counterclockwise.

To open, pull out on the drain valve.

After oil has drained completely, close and lock the drain valve by pushing inward and turning clockwise until the pin is in the locked position as shown.

Remove the drain tube and replace the cap onto to the bottom fitting of the drain valve.

Refill engine with oil through oil fill dipstick tube. Pour slowly. Do not overfill. For approximate capacity see “PRODUCT SPECIFICATIONS” section of this man- ual.

Use gauge on oil fill cap/dipstick for checking level. Be sure dipstick cap is tightened securely for accurate reading. Keep oil at “FULL” line on dipstick.Tighten cap onto the tube securely when finished.

CLEAN AIR SCREEN

Air screen must be kept free of dirt and chaff to prevent engine damage from overheating. Clean with a wire brush or compressed air to remove dirt and stubborn dried gum fibers.

AIR FILTER

Your engine will not run properly using a dirty air filter. Service air cleaner more often under dusty conditions. See Engine Manual.

ENGINE OIL FILTER

Replace the engine oil filter every season or every other oil change if the tractor is used more than 100 hours in one year.

MUFFLER

Inspect and replace corroded muffler and spark arrester (if equipped) as it could create a fire hazard and/or dam- age.

SPARK PLUGS

Replace spark plugs at the beginning of each mowing season or after every 100 hours of operation, whichever occurs first. Spark plug type and gap setting are shown in “PRODUCT SPECIFICATIONS” section of this manual.

IN-LINE FUEL FILTER (See Fig. 14)

The fuel filter should be replaced once each season. If fuel filter becomes clogged, obstructing fuel flow to carburetor, replacement is required.

With engine cool, remove filter and plug fuel line sec- tions.

Place new fuel filter in position in fuel line with arrow pointing towards carburetor.

Be sure there are no fuel line leaks and clamps are properly positioned.

Immediately wipe up any spilled gasoline.

CLAMP

CLAMP

FUEL FILTER

FIG. 14

CLEANING

Clean engine, battery, seat, finish, etc. of all foreign matter.

Keep finished surfaces and wheels free of all gasoline, oil, etc.

Protect painted surfaces with automotive type wax.

We do not recommend using a garden hose or pressure washer to clean your tractor unless the engine and trans- mission are covered to keep water out. Water in engine or transmission will shorten the useful life of your tractor. Use compressed air or a leaf blower to remove grass, leaves and trash from tractor and mower.

18

Image 18
Contents OPERATORS MANUAL MODELIMPORTANT MANUAL LAWN TRACTORI. GENERAL OPERATION SAFETY RULESSafe Operation Practices for Ride-On Mowers II. SLOPE OPERATIONV. SERVICE III. CHILDRENIV. TOWING TABLE OF CONTENTS PRODUCT SPECIFICATIONSCUSTOMER RESPONSIBILITIES Seat UNASSEMBLED PARTSSteering Wheel Slope SheetINSTALL SEAT See Fig ASSEMBLYTOOLS REQUIRED FOR ASSEMBLY TO REMOVE TRACTOR FROM CAR- TONCHECK BATTERY See Fig CHECK FOR PROPER POSITION OF ALL BELTS CHECK TIRE PRESSURECHECK DECK LEVELNESS CHECK BRAKE SYSTEMOPERATION KNOW YOUR TRACTOR TO SET PARKING BRAKE See Fig HOW TO USE YOUR TRACTORTO ADJUST MOWER CUTTING HEIGHT See Fig STOPPING See FigREVERSE OPERATION SYSTEM ROS TO ADJUST GAUGE WHEELS See FigTO OPERATE MOWER See Fig TO OPERATE ON HILLSCHECK ENGINE OIL LEVEL BEFORE STARTING THE ENGINETO TRANSPORT See Figs. 4 and ADD GASOLINEMOWING TIPS PURGE TRANSMISSIONGENERAL RECOMMENDATIONS MAINTENANCELUBRICATION CHART BEFORE EACH USETRACTOR BLADE REMOVAL See FigTO SHARPEN BLADE See Fig V-BELTS BATTERYENGINE TRANSAXLE COOLINGAIR FILTER CLEANINGCLEAN AIR SCREEN ENGINE OIL FILTERTO LEVEL MOWER HOUSING SERVICE AND ADJUSTMENTSTO INSTALL MOWER See Fig TO REMOVE MOWER See FigTO REPLACE MOWER BLADE DRIVE BELT See Fig TO REPLACE MOTION DRIVE BELT See Fig TO CHECK AND ADJUST BRAKE See FigTRANSAXLE MOTION CONTROL LEVER NEUTRAL ADJUSTMENT See Fig WITH PARKING BRAKE “ENGAGED”TO START ENGINE WITH A WEAK BATTERY See Fig TRANSMISSION REMOVAL/REPLACEMENTTO ADJUST STEERING WHEEL ALIGN- MENT FRONT WHEEL TOE-IN/CAMBERTO ADJUST THROTTLE CONTROL CABLE REPLACING BATTERY See FigTO REMOVE HOOD AND GRILL ASSEMBLY See Fig TO ADJUST CHOKE CONTROLFUEL SYSTEM STORAGEOTHER ENGINE OILCAUSE TROUBLESHOOTING POINTSPROBLEM CORRECTIONEngine dies when LIMITED WARRANTY SERVICE NOTES SUGGESTED GUIDE FOR SIGHTING SLOPES FOR SAFE OPERATION ONLY RIDE UP AND DOWN HILL NOT ACROSS HILL 15 DEGREES MAXPARTS AND SERVICE