Explanation of Graphical Symbols

Applicable for Reference Series Models 209 and 208, model numbers SP3557 and SP3556

WARNING

TO REDUCE THE RISK OF FIRE OR ELECTRICAL SHOCK, DO NOT EXPOSE

THIS APPLIANCE TO RAIN OR MOISTURE

CAUTION

RISK OF

ELECTRIC SHOCK

DO NOT OPEN

CAUTION: TO REDUCE THE RISK

OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK).

NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL

The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated “dangerous voltage” within

the product’s enclosure that may be of a sufficient magnitude to constitute a risk of electrical shock to persons.

The exclamation mark within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance.

•A combined mains power input lead and country specific mains plug is provided.

•Check before connecting to your local mains supply that the local supply voltage is the same as that marked on the rear panel. If it is not, check with your supplier before proceeding.

WARNING:

Due to the mains switch being located on the rear panel, the apparatus must be located in an open area without anything obstructing access to the mains switch.

Because this is a Class 1 product it must be connected to the protective earth connection.

The mains plug or power connector must be readily accessible to allow the power to be removed from this product.

CAUTION:

•To prevent electric shock, do not open the rear panel.

•This product is for indoor use only.

•This electrical apparatus should not be exposed to dripping or splashing and care should be taken not to place objects for holding liquids, such as a vase or drinks container, on top of this apparatus.

•Do not install near any heat source such as radiators, stoves or other appliances that produce heat.

•Ensure that the power plug and cord are correct for your sockets. Do not use if they show any signs of damage.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following conditions:

(1)this device does not cause harmful interference, and (2) this device will accept any interference received, including interference that may cause undesired operation.

The manufacturer is not responsible for any radio or TV interference caused by unauthorised modifications to this equipment. Such modifications could void the user authority to operate the equipment.

NOTE:

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause detrimental interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures:

•Reorient or relocate the receiving antenna.

•Increase the separation between the equipment and receiver.

•Connect the equipment into an outlet on a circuit different from that to which the receiver is needed.

•Consult the dealer or an experienced radio/TV technician for help.

1	Part No.: K290225E
	Issue 1: December 2007