Poulan 403444 manual To Replace Headlight Bulb, Interlocks and Relays, To Replace Fuse

Page 23

SERVICE AND ADJUSTMENTS

REPLACING BATTERY (See Figs. 25 and 26)

WARNING: Do not short battery terminals by allowing a wrench or any other object to contact both terminals at the same time. Before connect- ing battery, remove metal bracelets, wristwatch bands, rings, etc.

Positive terminal must be connected first to prevent sparking from acci- dental grounding.

•Lift seat pan to raised position.

•Disconnect BLACK battery cable fi rst then RED battery cable and carefully remove battery from tractor.

•Install new battery with terminals in same position as old battery.

•First connect RED battery cable to positive (+) terminal with hex bolt and keps nut as shown. Tighten securely. Slide terminal cover over terminal.

•Connect BLACK grounding cable to negative (-) ter- minal with remaining hex bolt and keps nut. Tighten securely.

SEAT PAN

FIG. 25

TERMINAL

KEPS

NUT

COVER

 

HEX

BOLT

POSITIVE (RED)

NEGATIVE

CABLE

(BLACK) CABLE

FIG. 26

TO REPLACE HEADLIGHT BULB

•Raise hood.

•Pull bulb holder out of the hole in the backside of the grill.

•Replace bulb in holder and push bulb holder securely back into the hole in the backside of the grill.

•Close hood.

INTERLOCKS AND RELAYS

Loose or damaged wiring may cause your tractor to run poorly, stop running, or prevent it from starting.

•Check wiring. See electrical wiring diagram in the Repair Parts section.

TO REPLACE FUSE

Replace with 20 amp automotive-type plug-in fuse. The fuse holder is located behind the dash.

TO REMOVE HOOD AND GRILL ASSEMBLY (See Fig. 27)

•Raise hood.

•Unsnap headlight wire connector.

•Stand in front of tractor. Grasp hood at sides, tilt toward engine and lift off of tractor.

•To replace, reverse above procedure.

HOOD

HEADLIGHT

WIRE

CONNECTOR

01536

FIG. 27

ENGINE

TO ADJUST THROTTLE CONTROL CABLE

The throttle control has been preset at the factory and adjustment should not be necessary. If adjustment is nec- essary, see engine manual.

TO ADJUST CHOKE CONTROL

The choke control has been preset at the factory and ad- justment should not be necessary. If adjustment is neces- sary, see engne manual.

TO ADJUST CARBURETOR

Your carburetor is not adjustable. If your engine does not operate properly due to suspected carburetor problems, take your tractor to an authorized service center for repair and/or adjustment.

23

Page 22 Page 24
Image 23
Page 22 Page 24
Contents Always Wear EYE Protection During Operation HD20H42II. Slope Operation Safety RulesSafe Operation Practices for Ride-On Mowers General OperationIV. Towing ServiceGeneral Service III. ChildrenTable of Contents Slope Sheet Unassembled PartsSteering Wheel Seat Before Removing Tractor from Skid AssemblyTools Required for Assembly To Remove Tractor from CartonCheck Battery See Fig Check Brake System Check Tire PressureCheck Deck Levelness Check for Proper Position of ALL BeltsOperation Know Your Tractor HOW to USE Your Tractor To Operate on Hills Using the Reverse Operation SystemTo Operate Mower See Fig Reverse Operation System ROSTo Start Engine See Fig Before Starting the EngineCheck Engine OIL Level ADD GasolinePurge Transmission Mowing TipsBefore Each USE MaintenanceLubrication Chart General RecommendationsTo Sharpen Blade See Fig TractorBlade Removal See Fig Engine Cleaning To Remove Mower See Fig Service and AdjustmentsTo Install Mower See Fig To Level Mower HousingBelt Removal Belt InstallationTo Replace Mower Blade Drive Belt See Fig To Replace Motion Drive Belt See Fig To Check and Adjust Brake See FigTransaxle Motion Control Lever Neutral Adjustment See Fig To Adjust BrakeFront Wheel TOE-IN/CAMBER Transmission REMOVAL/REPLACEMENTTo Adjust Steering Wheel ALIGN- Ment To Start Engine with a Weak Battery See FigTo Replace Headlight Bulb To Adjust Throttle Control CableTo Adjust Choke Control To Adjust CarburetorEngine OIL StorageOther Fuel SystemProblem Cause Correction Troubleshooting PointsEngine dies when Limited Warranty Policy Only Ride UP and Down Hill Not Across Hill Degrees MAX Suggested Guide for Sighting Slopes for Safe OperationParts and Service

403444 specifications

The Poulan 403444 is a robust and reliable string trimmer designed for both residential and commercial use. Known for its power and efficiency, it stands out as a preferred choice among landscaping enthusiasts and professionals alike. This trimmer integrates advanced features and technologies, making yard maintenance an easier and more enjoyable task.

One of the main features of the Poulan 403444 is its powerful 28cc 2-cycle engine. This engine delivers ample power for cutting through tough vegetation and weeds. Its lightweight design allows users to maneuver the trimmer effortlessly, reducing fatigue during extended use. The engine's quick-start feature ensures that users can get to work without any hassle. With its easy-to-use start mechanism, the Poulan 403444 becomes operational within seconds.

Another notable characteristic of the Poulan 403444 is its dual-line cutting system. This feature helps enhance cutting efficiency, allowing users to trim more area in less time. The trimmer uses a bump feed spool, which enables users to easily advance the cutting line by tapping the head of the trimmer on the ground. This convenience means less downtime and more productivity, especially when tackling larger areas.

In addition to its power and efficiency, the Poulan 403444 offers ergonomic design elements that set it apart from competitors. Its adjustable handle provides a customized fit for users of various heights, ensuring maximum comfort during operation. The trimmer also features a lightweight design, reducing strain on the user's arms and back, making it suitable for prolonged use.

The Poulan 403444 is built with durability in mind. Made from high-quality materials, this trimmer is designed to withstand the rigors of regular usage. Its robust construction ensures that it not only performs well but lasts longer, providing excellent value for the investment.

Furthermore, the Poulan 403444 incorporates anti-vibration technology. This feature minimizes vibrations during operation, allowing users to work more comfortably and efficiently. The well-balanced design further contributes to reduced user fatigue, enhancing overall performance.

In conclusion, the Poulan 403444 is a formidable string trimmer that combines power, efficiency, and user-friendly features into a single package. With its advanced technologies and thoughtful design elements, it simplifies landscaping tasks, making it an excellent choice for anyone looking to maintain their outdoor space effectively.
Top Page Image Contents