MAINTENANCE
Cutting Blades
To attain the best mowing effect, it is important that the blades are well sharpened and not damaged.
Bent or cracked blades or blades with large nicks should be replaced.
IMPORTANT INFORMATION
The sharpening of blades should be carried out by an authorized service workshop.
Damaged blades should be replaced after hitting obstacles that result in a breakdown. A service workshop should decide whether the blade can be repaired/ground or must be replaced. Balance the blades after sharpening and check the blade mounts.
Blade replacement
1.Remove blade bolt by turning counter clockwise.
2.Install new or resharpened blade with stamped “GRASS SIDE” facing towards ground/grass (down) or “THIS SIDE UP” facing deck and cutter housing.
3.Install and tighten blade bolt securely.
4.Torque blade bolt to 90 ft/lbs (122 Nm).
IMPORTANT INFORMATION
The
Anti-scalp Rollers
IMPORTANT INFORMATION
Adjust
The
•Upper position 1½ to 2½" (38 to 64 mm) grass
•Middle position 2½" to 4" (64 to 102 mm) grass
•Lower position 4" to 6" (102 to 128 mm) grass.
The rollers should be approximately ¼" (6.5 mm) from ground. Do not adjust the rollers to support the deck.
WARNING!
Blades are sharp. Protect your hands with gloves and/or wrap blades with a heavy cloth when handling.
IMPORTANT INFORMATION
Special blade bolt is heat treated.
Replace with a PoulanPRO bolt if required.
Do not use lower grade hardware than specified.
3 |
1 |
2 |
1.Blade
2.Blade bolt (special)
3.Cutter housing
Blade attachment
40