Poulan 419764, 96042007300 manual To Replace Headlight Bulb, Interlocks and Relays, To Replace Fuse

Page 23

SERVICE AND ADJUSTMENTS

REPLACING BATTERY (See Fig. 30)

WARNING: Do not short battery terminals by allowing a wrench or any other object to contact both terminals at the same time. Before connect- ing battery, remove metal bracelets, wristwatch bands, rings, etc. Positive terminal must be connected first to prevent sparking from acci- dental grounding.

Lift seat pan to raised position.

Disconnect BLACK battery cable first then RED battery cable and carefully remove battery from tractor.

Install new battery with terminals in same position as old battery.

First connect RED battery cable to positive (+) terminal with hex bolt and keps nut as shown. Tighten securely. Slide terminal cover over terminal.

Connect BLACK grounding cable to negative (-) ter- minal with remaining hex bolt and keps nut. Tighten securely.

DISCARD TERMINAL

KEPS NUT

HEX BOLT

 

PROTECTIVE CAPS

 

 

 

TERMINAL

COVER

NEGATIVE

(BLACK) CABLE POSITIVE (RED)

CABLE

03037

FIG. 30

TO REPLACE HEADLIGHT BULB

Raise hood.

Pull bulb holder out of the hole in the backside of the grill.

Replace bulb in holder and push bulb holder securely back into the hole in the backside of the grill.

Close hood.

INTERLOCKS AND RELAYS

Loose or damaged wiring may cause your tractor to run poorly, stop running, or prevent it from starting.

Check wiring. See electrical wiring diagram in the Repair Parts section.

TO REPLACE FUSE

Replace with 20 amp automotive-type plug-in fuse. The fuse holder is located behind the dash.

TO REMOVE HOOD AND GRILL ASSEMBLY (See Fig. 31)

Raise hood.

Unsnap headlight wire connector.

Stand in front of tractor. Grasp hood at sides, tilt toward engine and lift off of tractor.

To replace, reverse above procedure.

HOOD

HEADLIGHT

WIRE

CONNECTOR

03075

FIG. 31

ENGINE

TO ADJUST THROTTLE CONTROL CABLE

The throttle control has been preset at the factory and adjustment should not be necessary. If adjustment is nec- essary, see engine manual.

TO ADJUST CHOKE CONTROL

The choke control has been preset at the factory and ad- justment should not be necessary. If adjustment is neces- sary, see engne manual.

TO ADJUST CARBURETOR

Your carburetor is not adjustable. If your engine does not operate properly due to suspected carburetor problems, take your tractor to an authorized service center for repair and/or adjustment.

23

Image 23
Contents Model XT195H46YTII. Slope Operation Safety RulesSafe Operation Practices for Ride-On Mowers General OperationIV. Towing ServiceGeneral Service III. ChildrenTable of Contents Unpack Carton AssemblyUnassembled Parts To Remove Tractor from CartonCheck Brake System Check Tire PressureCheck Deck Levelness Check for Proper Position of ALL BeltsOperation Know Your Tractor To USE Throttle Control D See Fig HOW to USE Your TractorTo SET Parking BRAKESee Fig Stopping See FigTo USE Cruise Control J See Fig To Adjust Gauge Wheels See FigTo Adjust Mower Cutting Height See Fig System CharacteristicsCheck Engine OIL Level Before Starting the EngineReverse Operation System ROS To Operate on HillsAutomatic Transmission Warm UP ADD GasolineTo Start Engine See Fig Purge TransmissionMowing Tips Schedule MaintenanceMaintenance General RecommendationsTires BatteryTractor Brake OperationEngine Muffler CleaningAIR Filter Engine OIL FilterTo Remove Mower See Fig Service and AdjustmentsTo Install Mower See -21 Install belt on engine pulley M, in belt keepers G Turn nut right Turn nut left To raise mower To lower mower To Level MowerTo Replace Motion Drive Belt See Fig To Replace Mower Drive Belt See FigTo Check Brake To Remove Wheel for Repairs See Fig To Start Engine with a Weak Battery See FigWeak or Dead Fully Charged Battery Front Wheel TOE-IN/CAMBERTo Replace Headlight Bulb To Adjust Throttle Control CableTo Adjust Choke Control To Adjust CarburetorEngine OIL StorageOther Fuel SystemProblem Cause Correction Troubleshooting PointsEngine dies when Suggested Guide for Sighting Slopes for Safe Operation L5V 3E4 HOPStevens Creek Road Terry Fox Way Augusta, GA 30907 USA Service Notes Parts and Service Changere DE Pièces LES ET L’ENTRETIEN Dentretien Remarques Initiale d’achat date la de compter à jours 90 dix Canada Au Pro PoulanAutorisé Garantie cette de exclus sont normal l’entretien etDegrés Correction Cause Problème Dépannage DE GuideLame de mandrin le Remplacez Tordu est lame de mandrin Un Tracteur EntreposageMoteur Carburateur LE Régler Pour Starter DU Commande LA Régler PourGAZ DES Commande LA DE Câble LE Régler Pour Reglages ET Revision29 .FIG Fig la Voir Tionsraparé LES Pour Roues LES Enlever PourAvant Roue LA DE PINCEMENT/CARROSSAGE27 .FIG Réglages ET RévisionFig la Voir D’ENTRAÎNEMENT Courroie a L Acer Rempl Pour Freins LES Vérifier Pour23 .FIG Tondeuse LA Niveau LE Ajuster Pour25 .FIG 24 .FIG18 .FIG 21 .FIG20 .FIG 19 .FIG17 .FIG Courroie LA ET Tondeuse LA InstallerFigs Voir D’ENTRAÎNEMENT Fig Voir Tondeuse LA Enlever Pour’ALLUMAGE Bougie EntretienNettoyage Fig la VoirLubrification ’AIR Tamis LE NettoyerSionmistrans LA DE Moteur Fluide Transmission LA DE RefroidissementEN Fonctionnement DE Système ET Fig la Voir Lame LA EnleverUtilisation Chaque Avant Recommandations LESGénérales Lubrification DE TableauDe conseille vous on surface, grande une tondre Pour UtilisationTondre DE Conseils 12 .FIGQueti Transmission LA PurgerMoteur LE Démarrer Pour ’ESSENCE Réservoir LE RemplirMoteur LE Démarrer DE Avant 10 .FIG Vitess DE Régulateur LE Utiliser CommentTondeuse LA Utiliser Pour Jauge DE Roues LES Régler PourMoteur GAZ DES Commande LA Utiliser PourFig la Voir Mentnetionsta DE Frein LE Engager Pour Reculer Pour ET Avancer PourUtilisation ’EMBRAYAGE LA DE Tracteur LE Retirer Pour MontageDesmancom des tionfonc la et Fig la Voir Siège LE Ajustez Montées NON PiécesToncar DU Tracteur LE Sortir Pour Fig la Voir Batterie LA VérifierProduit DE Spécifications SommaireClient DU Responsabilités Général Entretien EntretienRemorquage EnfantsTracteurs des sécurité toute en l’utilisation pour Conseils PentesLES Dans Fonctionnement Général FonctionnementAvertissement AUX Imprimé