Poulan 427159, 96042007201 manual Install belt on engine pulley M

Page 19

SERVICE AND ADJUSTMENTS

•ATTACH MOWER SIDE SUSPENSION ARMS (A) TO CHASSIS - Position hole in arm over pin (B) on outside of tractor chassis and secure with retainer spring.

•Repeat on opposite side of tractor.

A

B

Fig. 24

•ATTACH REAR LIFT LINKS (C) - Lift rear corner of mower and position slot in link assembly over pin (D) on rear mower bracket and secure with washer and retainer spring.

•Repeat on opposite side of tractor.

C

D

Fig. 25

•Insert end of link (E) into hole in front mower bracket and secure with washer and retainer spring (J).

E

FJ

H

Fig. 26

•Hook end of clutch cable spring (Q) into hole in idler arm (R).

•Push clutch cable housing guide (P) into bracket, slide collar (L) onto guide and secure with retainer spring (K).

•Install belt on engine pulley (M).

M

Fig. 27

IMPORTANT: CHECK BELT FOR PROPER ROUTING IN ALL MOWER PULLEY GROOVES.

•Raise attachment lift lever to highest position.

•If necessary, adjust gauge wheels before operating mower as shown in the Operation section of this manual.

•ATTACH FRONT LINK (E) - Work from left side of trac- tor. Insert rod end of link assembly through front hole in tractor front suspension bracket (F).

B

MF

Q R

AE

P

K

C

D

L	Fig. 28

19

Image 19

Contents XT195H42LT II. Slope Operation Safety RulesSafe Operation Practices for Ride-On Mowers General OperationIV. Towing ServiceGeneral Service III. ChildrenTable of Contents Steering Wheel Unassembled PartsBefore Removing Tractor from Skid AssemblyTools Required for Assembly To Remove Tractor from CartonCheck Tire Pressure To Adjust SeatCheck Deck Levelness Operation ROS on Know Your TractorPosition To USE Throttle Control See Fig HOW to USE Your TractorTo SET Parking Brake See Fig Stopping See FigTo Operate Mower To Adjust Mower Cutting Height See FigTo Adjust Gauge Wheels See Fig Reverse Operation System ROSCheck Engine OIL Level Before Starting the EngineTo Operate on Hills Towing Carts and Other AttachmentsPurge Transmission Mowing TipsAutomatic Transmission Warm UP Schedule MaintenanceMaintenance General RecommendationsTractor BatteryBlade Removal See Fig Engine Muffler CleaningSpark Plugs To Install Mower See Figs Service and AdjustmentsTo Remove Mower See Fig Install belt on engine pulley M To Level Mower To Replace Motion Drive Belt See Fig Belt InstallationTo Replace Mower Blade Drive Belt See Fig To Check BrakeFront Wheel TOE-IN/CAMBER Transaxle Motion Control Lever Neutral Adjustment See FigTo Start Engine with a Weak Battery See Fig To Adjust Steering Wheel AlignmentTransmission Engine OIL StorageOther Fuel SystemProblem Cause Correction TroubleshootingTroubleshooting Points Suggested Guide for Sighting Slopes for Safe Operation Limited Warranty