Poulan PB1638LT manual Service and Adjustments, To Remove Mower See Fig, To Install Mower See Fig

Page 19

SERVICE AND ADJUSTMENTS

WARNING: TO AVOID SERIOUS INJURY, BEFORE PERFORMING ANY SERVICE OR ADJUST- MENTS:

•Depress clutch/brake pedal fully and set parking brake.

•Place gearshift lever in neutral (N) position.

•Place attachment clutch in “DISENGAGED” position.

•Turn ignition key to “STOP” and remove key.

•Make sure the blades and all moving parts have completely stopped.

•Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with plug.

TRACTOR

TO REMOVE MOWER (See Fig. 13)

Mower will be easier to remove from the right side of trac- tor.

•Place attachment clutch in “DISENGAGED” position.

•Move attachment lift lever forward to lower mower to its lowest position.

•Roll belt off engine pulley.

•Remove small retainer spring, and remove clutch spring off pulley bolt.

•Remove large retainer spring, slide collar off and push housing guide out of bracket.

•Disconnect anti-swaybar from chassis bracket by re- moving retainer spring.

•Disconnect suspension arms from rear deck brackets by removing retainer springs.

•Disconnect front links from deck by removing retainer springs.

•Raise lift lever to raise suspension arms. Slide mower out from under tractor.

IMPORTANT: IF AN ATTACHMENT OTHERTHANTHE MOWER DECK IS TO BE MOUNTED ON THE TRACTOR, REMOVE THE FRONT LINKS AND HOOK THE CLUTCH SPRING INTO SQUARE HOLE IN FRAME.

TO INSTALL MOWER (See Fig. 13)

•Raise attachment lift lever to its highest position.

•Slide mower under tractor with defl ector shield to right side of tractor.

•Lower lift lever to its lowest position.

•Connect front links to mower deck and secure with retainer springs..

•Connect suspension arms to rear deck brackets and secure with retainer springs.

•Connect anti-swaybar to chassis bracket and secure with retainer spring.

•Push clutch cable housing guide into bracket, slide col- lar onto guide and secure with large retainer spring.

•Place fl at washer and clutch spring on idler pulley bolt and secure with small retainer spring.

•Make sure belt is inside the belt keeper at the idler and on both sides of the wire belt keeper as shown.

•Install belt onto engine pulley.

IMPORTANT: CHECK BELT FOR PROPER ROUTING IN ALL MOWER PULLEY GROOVES.

SMALL RETAINER SPRING

 

 

FLAT WASHER

 

WIRE BELT KEEPER

 

 

CLUTCH SPRING

 

 

SUSPENSION ARMS

 

 

 

BELT KEEPER

 

 

 

 

 

SQUARE HOLE

RETAINER SPRING

 

 

ENGINE PULLEY

ANTI-SWAY BAR

 

 

 

 

FRONT LINK

COLLAR

 

 

 

 

 

HOUSING GUIDE

 

 

RETAINER SPRINGS

 

 

 

(BOTH SIDES)

LARGE

BRACKET

02845

 

 

DEFLECTOR SHIELD

RETAINER

CLUTCH SPRING

SPRING

 

FIG. 13

19

Page 18 Page 20
Image 19
Page 18 Page 20
Contents Always Wear EYE Protection During Operation PB1638LTII. Slope Operation Safety RulesSafe Operation Practices for Ride-On Mowers General OperationIV. Towing ServiceGeneral Service III. ChildrenTable of Contents Contents of Hardware Pack Before Removing Tractor from Skid AssemblyTools Required for Assembly To Remove Tractor from CartonCheck Battery See Fig Check Brake System Check Tire PressureCheck Deck Levelness Check for Proper Position of ALL BeltsOperation Know Your Tractor HOW to USE Your Tractor To Transport Reverse Operation System ROSTo Operate Mower See Fig To Operate on HillsTo Start Engine See Fig Before Starting the EngineCheck Engine OIL Level ADD GasolineMowing Tips General Recommendations MaintenanceBlade Removal See Fig TractorTo Sharpen Blade See Fig Transaxle Cooling BatteryEngine BeltsMuffler CleaningClean AIR Screen AIR FilterTo Install Mower See Fig Service and AdjustmentsTo Remove Mower See Fig Belt Removal To Level Mower HousingBelt Installation To Replace Mower Blade Drive Belt See FigTo Check Brake To Check and Adjust Brake See FigTo Adjust Brake To Replace Motion Drive Belt See FigFront Wheel TOE-IN/CAMBER Transaxle Gear Shift Lever NEUTRAL- Adjustment See FigTo Adjust Steering Wheel ALIGN- Ment To Start Engine with a Weak Battery See FigTo Replace Headlight Bulb To Adjust Throttle Control CableTo Adjust Choke Control To Adjust CarburetorEngine OIL StorageOther Fuel SystemProblem Cause Correction Troubleshooting PointsEngine dies when Limited Warranty Policy Only Ride UP and Down Hill Not Across Hill Degrees MAX Suggested Guide for Sighting Slopes for Safe OperationParts and Service

PB1638LT specifications

The Poulan PB1638LT is a highly regarded leaf blower designed to tackle various outdoor tasks with efficiency and ease. This powerful outdoor tool is particularly favored among homeowners and professionals alike for its combination of power, versatility, and user-friendly features.

At the heart of the PB1638LT is its robust 38cc, 2-cycle engine, delivering impressive air speeds that can reach up to 200 miles per hour. This substantial air velocity enables users to quickly clear debris, leaves, and grass clippings from lawns, driveways, and patios, making yard maintenance an effortless task. The leaf blower's vacuum and mulcher capabilities further enhance its functionality, allowing users to not only blow away debris but also to collect and shred leaves into fine mulch, which can be used to enrich garden beds.

One of the standout features of the Poulan PB1638LT is its lightweight design, weighing in at just 11 lbs. This manageable weight ensures reduced fatigue during extended use, promoting comfort even when tackling larger areas. The inclusion of a shoulder strap also aids in distributing weight evenly, making the blower easier to maneuver during operation.

The ergonomic design of the PB1638LT cannot be overlooked. It incorporates a comfortable grip and easy-to-reach throttle control, enabling users to operate it smoothly with one hand. This functional design is particularly beneficial for those who may have limited strength or mobility, as it simplifies the operation without sacrificing power.

Poulan's commitment to technology is evident in the PB1638LT's Advanced Fuel System. This feature enhances fuel efficiency while reducing emissions, making it a more environmentally friendly choice compared to conventional blowers. The system helps maintain optimum engine performance and longevity, ensuring that the PB1638LT remains a reliable tool for years to come.

To sum it up, the Poulan PB1638LT leaf blower stands out as a versatile and powerful tool suitable for various outdoor cleaning tasks. With its formidable engine performance, vacuum and mulching capabilities, lightweight design, and user-friendly features, it is an excellent investment for anyone looking to maintain a tidy yard or garden effortlessly. Whether you're a homeowner wanting to keep your property looking pristine or a professional landscaper in need of a dependable blower, the PB1638LT is a name to consider.
Top Page Image Contents