Poulan CO20H46YT Before Starting the Engine, Reverse Operation System ROS, To Transport See Figs

Page 11

OPERATION

S

FIG. 10

REVERSE OPERATION SYSTEM (ROS)

Your tractor is equipped with a Reverse Operation System (ROS). Any attempt by the operator to travel in the reverse direction with the attachment clutch engaged will shut off the engine unless ignition key is placed in the ROS "ON" position.

WARNING: Backing up with the attachment clutch en- gaged while mowing is strongly discouraged. Turning the ROS "ON", to allow reverse operation with the attachment clutch engaged, should only be done when the operator decides it is necessary to reposition the machine with the attachment engaged. Do not mow in reverse unless absolutely necessary.

USING THE REVERSE OPERATION SYSTEM -

Only use if you are certain no children or other bystanders will enter the mowing area.

Depress brake pedal all the way down.

With engine running, turn ignition key counterclockwise to ROS "ON" position.

Look down and behind before and while backing.

Slowly depress reverse drive pedal to start move- ment.

When use of the ROS is no longer needed, turn the ignition key clockwise to engine "ON" position.

TO TRANSPORT (See Figs. 3 and 11)

When pushing or towing your tractor, be sure to disengage transmission by placing freewheel control in freewheeling position. Free wheel control is located at the rear drawbar of tractor.

Raise attachment lift to highest position with attachment lift control.

Pull freewheel control out and down into the slot and release so it is held in the disengaged position.

Do not push or tow tractor at more than two (2) MPH.

To reengage transmission, reverse above procedure.

NOTE: To protect hood from damage when transporting your tractor on a truck or a trailer, be sure hood is closed and secured to tractor. Use an appropriate means of tying hood to tractor (rope, cord, etc.).

Transmission Engaged

Transmission Disengaged

FIG. 11

TOWING CARTS AND OTHER ATTACHMENTS

Tow only the attachments that are recommended by and comply with specifications of the manufacturer of your trac- tor. Use common sense when towing. Too heavy of a load, while on a slope, is dangerous. Tires can lose traction with the ground and cause you to lose control of your tractor.

ROS "ON" POSITION

ENGINE "ON" POSITION

 

(NORMAL OPERATING)

02828

TO OPERATE ON HILLS

CAUTION: Do not drive up or down hills with slopes greater than 15° and do not drive across any slope.

Choose the slowest speed before starting up or down hills.

Avoid stopping or changing speed on hills.

If stopping is absolutely necessary, push brake pedal quickly to brake position and engage parking brake.

To restart movement, slowly release parking brake and brake pedal.

Slowly depress appropriate drive pedal to slowest set- ting.

• Make all turns slowly.

11

BEFORE STARTING THE ENGINE

CHECK ENGINE OIL LEVEL

The engine in your tractor has been shipped, from the factory, already filled with summer weight oil.

Check engine oil with tractor on level ground.

Remove oil fill cap/dipstick and wipe clean, reinsert the dipstick and screw cap tight, wait for a few seconds, remove and read oil level. If necessary, add oil until “FULL” mark on dipstick is reached. Do not overfill.

For cold weather operation you should change oil for easier starting (See “OIL VISCOSITY CHART” in the Maintenance section of this manual).

To change engine oil, see the Maintenance section in this manual.

Image 11
Contents Model CO20H46YTII. Slope Operation Safety RulesSafe Operation Practices for Ride-On Mowers General OperationIV. Towing ServiceIII. Children Table of Contents Unpack Carton AssemblyUnassembled Parts To Remove Tractor from CartonCheck Brake System Check Tire PressureCheck Deck Levelness Check for Proper Position of ALL BeltsOperation Know Your Tractor Ignition Switch Used for starting and stopping the engineTo USE Throttle Control D See Fig HOW to USE Your TractorTo SET Parking BRAKESee Fig Stopping See FigTo USE Cruise Control -J See Fig To Adjust Mower Cutting Height See FigTo Adjust Gauge Wheels See Fig To Move Forward and Backward See FigTo Operate on Hills Before Starting the EngineReverse Operation System ROS To Transport See FigsAutomatic Transmission Warm UP ADD GasolineTo Start Engine See Fig Purge TransmissionMowing Tips Schedule MaintenanceMaintenance General RecommendationsTires BatteryTractor Brake OperationEngine Spark Plugs CleaningEngine OIL Filter MufflerTo Remove Mower See Fig Service and AdjustmentsTo Install Mower See Fig Install belt on engine pulley M, in belt keepers G Turn nut right Turn nut left To raise mower To lower mower To Level MowerTo Replace Motion Drive Belt See Fig Belt InstallationTo Replace Mower Blade Drive Belt See Fig To Check BrakeTo Attach Jumper Cables To Start Engine with a Weak Battery See FigFront Wheel TOE-IN/CAMBER To Remove Wheel for Repairs See FigTo Replace Headlight Bulb To Adjust Throttle Control CableTo Adjust Choke Control To Adjust CarburetorEngine OIL StorageOther Fuel SystemProblem Cause Correction Troubleshooting PointsEngine dies when L5V 3E4 Limited WarrantyService Notes Fold Along This Dotted Line Degree Slope Only Ride UP and Down Hill Not Across Hill Degrees MAXParts and Service Changere DE Pièces LES ET L’ENTRETIEN Degrés MAX Dentretien Remarques Initiale d’achat date la de compter à jours 90 dix AutoriséGarantie cette de exclus sont normal l’entretien et Connexions les et interrupteurs les câblage, le Vérifiez Dépannage DE GuideLame de mandrin le Remplacez Tordu est lame de mandrin Un Entreposage Carburateur LE Régler Pour Starter DU Commande LA Régler PourGAZ DES Commande Reglages ET Revision28 .FIG Fig la Voir Tionsraparé LES Pour Roues LES Enlever PourAvant Roue LA DE PINCEMENT/CARROSSAGE 29 .FIGTondeuse DE Lame DE Mentnetraî Réglages ET RévisionFig la Voir D’ENTRAÎNEMENT Courroie LA Remplacer Pour FIG LA Voir23 .FIG Tondeuse LA Niveau LE Ajuster Pour25 .FIG 24 .FIGPlace en bien est courroie la que vous-Assurez Important 21 .FIG 19 .FIG20 .FIG 18 .FIG17.FIG Courroie LA ET Tondeuse LA InstallerFig Voir Tondeuse LA Enlever PourMoteur DE D’HUILE Filtre EntretienFig la Voir ’ALLUMAGE BougieTransmission LA DE Refroidissement AIR À Filtre’AIR Tamis LE Nettoyer Sionmistrans LA DE Moteur FluideEN Fonctionnement DE Système ET Fig la Voir Lame LA EnleverUtilisation Chaque Avant Lubrification DE Tableau12 .FIG Avant ET Réinstallation LA Après Purgée ÊtreUtilisation Transmission LA PurgerMoteur DU D’HUILE Niveau LE Vérifier E T O MO P ’ESSENCE Réservoir LE RemplirMAR EN Fonctionnement DE Système Accessoires Autres ET Charrettes DES Remorquer Pour11 et 3 .Fig les Voir Fig la Tondeuse LA Utiliser PourVitess DE Régulateur LE Utiliser CommentFig la Voir Arrêter Pour 4 .FIG GAZ DES Commande LA Utiliser PourS I L I T U Fig la Voir Mentnetionsta DE Frein LE Engager PourMoteur de vitesse la commander de permet GAZ DES Commande D Froid moteur un démarrer de permet Détrangleur Commande’EMBRAYAGE PA LA DE Tracteur LE Retirer Pour MontageDesmancom des tionfonc la et Tionsec la Voir Conduisant LE EN TeletR E T T a B I F I R É Montées NON PiécesToncar DU Tracteur LE Sortir Pour Sommaire ’ESSENCE DE Sûre Manipulation Général EntretienTracteurs des sécurité toute En l’utilisation pour ConseilsTracteurs des sécurité toute en l’utilisation pour Conseils PentesLES Dans Fonctionnement AUX Imprimé

CO20H46YT specifications

The Poulan CO20H46YT is a powerful riding lawn mower designed to provide a reliable and efficient mowing experience for homeowners with medium to large lawns. This impressive machine comes with a variety of features and technologies that enhance its performance, comfort, and ease of use.

At the heart of the Poulan CO20H46YT is a robust 20HP Briggs & Stratton engine, known for its durability and high performance. This engine delivers ample power to tackle thick grass and uneven terrain, ensuring that mowing is completed quickly and efficiently. Coupled with a hydrostatic transmission, the mower offers smooth and precise control, allowing users to adjust speed effortlessly while navigating around obstacles.

One of the standout features of the Poulan CO20H46YT is its 46-inch cutting deck. This wide cutting deck allows for a larger mowing area with each pass, reducing the overall time spent mowing. The deck is equipped with a system that enables users to easily adjust the cutting height, accommodating various grass types and mowing preferences. With several height settings available, homeowners can achieve the perfect lawn finish.

Furthermore, the mower incorporates an innovative air induction technology, which enhances airflow throughout the deck. This ensures a clean cut and contributes to a healthier lawn by promoting even grass growth. The blades are designed to give a precise cut while also effectively mulching the grass for improved nutrient recycling.

Comfort and ease of operation are also central to the design of the Poulan CO20H46YT. The ergonomic seat and steering wheel provide a comfortable driving experience, allowing users to mow for extended periods without discomfort. Additionally, the ride-on mower features an easy-to-use control panel, making it simple to operate the various settings.

Another important characteristic of the CO20H46YT is its sturdy construction. Built to withstand the rigors of frequent use, the mower features a durable frame and high-quality components, ensuring longevity and reliability. Regular maintenance is made easier with accessible engine parts, allowing users to keep their mower in peak condition.

In summary, the Poulan CO20H46YT combines power, efficiency, and comfort, making it an excellent choice for homeowners seeking a quality riding lawn mower. With its robust engine, adjustable cutting deck, advanced technologies, and user-friendly design, it is well-equipped to handle the demands of lawn care, delivering exceptional results every time.