Assembly/Pre-Operation

Your new tractor has been assembled at the factory with the exception of those parts left unassembled for shipping purposes. To ensure safe and proper operation of your tractor all parts and hardware you assemble must be tightened securely. Use the correct tools as necessary to insure proper tightness. Review the video cassette before you begin.

TOOLS REQUIRED FOR ASSEMBLY

A socket wrench set will make assembly easier. Standard wrench sizes you need are listed below.

(1)	3/4" wrench	(1)	Pliers
(2)	7/16" wrench	(1)	Utility knife
(1)	Tire pressure	gauge

When right or left hand is mentioned in this manual, it means, from your point of view, when you are in the operating posi- tion (seated behind the steering wheel).

TO REMOVE TRACTOR FROM CARTON

UNPACK CARTON

1.Remove all accessible loose parts and parts boxes from carton.

2.Cut along dotted lines on all four pan- els of carton. Remove end panels and lay side panels ﬂat.

3.Check for any additional loose parts or cartons and remove.

BEFORE REMOVING TRACTOR FROM SKID

ATTACH STEERING WHEEL

1.Remove locknut and large ﬂat washer from steering shaft.

2.Position front wheels of the tractor so they are pointing straight forward.

3.Slide the steering sleeve over the steering shaft.

4.Align tabs and press steering sleeve extension into bottom of steering wheel.

5.Position steering wheel so cross bars are horizontal (left to right) and slide onto steering wheel adapter.

6.Secure steering wheel to steering shaft with locknut and large ﬂat washer previously removed. Tighten securely.

7.Snap steering wheel insert into center of steering wheel.

8.Remove protective materials from trac- tor hood and grill.

IMPORTANT: Check for and remove any staples in skid that may puncture tires where tractor is to roll off skid.

Steering Wheel

Insert

Lock Nut

Large Flat

Washer

Steering

Wheel

Steering

Wheel

Adaptor

Steering
Wheel Extention	Tabs
	Tabs

Steering

Shaft

Steering

Sleeve

	143
2
0

HOW TO SET UP YOUR TRACTOR CHECK BATTERY

1. Lift hood to raised position.

NOTE: If this battery is put into service after month and year indicated on label (label located between terminals) charge battery for minimum of one hour at 6-10 amps. (See "BATTERY" in Maintenance section of this manual for charging instruc- tions).

Label

02173