Poulan PBGT22H54 manual Front Wheel TOE-IN/CAMBER, To Remove Wheel for Repairs See Fig

Page 24

SERVICE AND ADJUSTMENTS

G

H

B

A

C

J

D

E

F

02953 electric

FIG. 33

TO CHECK BRAKE

If tractor requires more than fi ve (5) feet to stop at highest speed in highest gear on a level, dry concrete or paved surface, then brake must be serviced.

You may also check brake by:

•Park tractor on a level, dry concrete or paved surface, depress brake pedal all the way down and engage parking brake.

•Disengage transmission by placing freewheel control in “transmission disengaged” position. Pull freewheel control out and into the slot and release so it is held in the disengaged position.

The rear wheels must lock and skid when you try to manu- ally push the tractor forward. If the rear wheels rotate, then the brake needs to be serviced. Contact a qualifi ed service center.

FRONT WHEEL TOE-IN/CAMBER

Your new tractor front wheel toe-in and camber is set at the factory and is normal. The front wheel toe-in and camber are not adjustable. If damage has occurred to affect the factory set front wheel toe-in or camber, contact a qualifi ed service center.

TO REMOVE WHEEL FOR REPAIRS (See Fig. 34)

•Block up axle securely.

•Remove axle cover, retaining ring and washers to allow wheel removal (rear wheel contains a square key - Do not lose).

•Repair tire and reassemble.

•On rear wheels only: align grooves in rear wheel hub and axle. Insert square key.

•Replace washers and snap retaining ring securely in axle groove.

•Replace axle cover.

NOTE: To seal tire punctures and prevent fl at tires due to slow leaks, tire sealant may be purchased from your local parts dealer. Tire sealant also prevents tire dry rot and corrosion.

WASHERS

RETAINING

RING

AXLE COVER

SQUARE KEY (REAR

WHEEL ONLY)

FIG. 34

TO START ENGINE WITH A WEAK BATTERY (See Fig. 35)

WARNING: Lead-acid batteries gen- erate explosive gases. Keep sparks, flame and smoking materials away from batteries. Always wear eye protection when around batteries.

If your battery is too weak to start the engine, it should be recharged. (See "BATTERY" in the MAINTENANCE sec- tion of this manual).

If “jumper cables” are used for emergency starting, follow this procedure:

IMPORTANT: YOUR TRACTOR IS EQUIPPED WITH A 12 VOLT SYSTEM. THE OTHER VEHICLE MUST ALSO BE A 12 VOLT SYSTEM. DO NOT USE YOUR TRACTOR BATTERY TO START OTHER VEHICLES.

TO ATTACH JUMPER CABLES -

•Connect one end of the RED cable to the POSITIVE

(+)terminal of each battery(A-B), taking care not to short against tractor chassis.

•Connect one end of the BLACK cable to the NEGATIVE (-) terminal (C) of fully charged battery.

•Connect the other end of the BLACK cable (D) to good chassis ground, away from fuel tank and battery.

TO REMOVE CABLES, REVERSE ORDER -

•BLACK cable first from chassis and then from the fully charged battery.

•RED cable last from both batteries.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

WEAK OR DEAD

 

 

 

 

 

 

 

FULLY CHARGED

BATTERY

 

 

 

 

 

 

 

BATTERY

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

FIG. 35

24

Page 23 Page 25
Image 24
Page 23 Page 25
Contents PBGT22H54 Always Wear EYE Protection During OperationSafety Rules Safe Operation Practices for Ride-On MowersGeneral Operation II. Slope OperationService III. ChildrenIV. Towing Table of Contents Unassembled Parts Mower Mower Front WheelSlope Sheet KeysAssembly Tools Required for AssemblyTo Remove Tractor from Carton Unpack CartonInstall Mower and Drive Belt First Install ANTI-SWAY BAR S7/16 Check Tire Pressure Check Deck LevelnessCheck for Proper Position of ALL Belts Check Brake SystemOperation Know Your Tractor Reverse Operation System ROS on PositionHOW to USE Your Tractor StoppingTo Adjust Mower Cutting Height See Fig To Adjust Gauge Wheels See FigSystem Characteristics To USE Cruise Control -J See FigService REMINDER/HOUR Meter Using the Reverse Operation SystemReverse Operation System ROS To Operate on HillsBefore Starting the Engine Check Engine OIL LevelADD Gasoline To Start Engine See FigMowing Tips Maintenance Lubrication ChartBattery TractorBrake Operation TiresEngine Cleaning Engine OIL FilterMuffler Spark PlugsService and Adjustments To Install MowerTractor See Fig To Remove MowerTurn nut right Turn nut left To raise mower To Replace Mower Blade Drive Belt To Check BrakeTo Replace Motion Drive Belt To Start Engine with a Weak Battery See Fig Front Wheel TOE-IN/CAMBERTo Remove Wheel for Repairs See Fig To Attach Jumper CablesTo Adjust Throttle Control Cable To Adjust Choke ControlTo Adjust Carburetor To Replace Headlight BulbStorage OtherFuel System Engine OILTroubleshooting Points Engine dies when Page Limited Warranty Suggested Guide for Sighting Slopes for Safe Operation Only Ride UP and Down Hill Not Across Hill Degrees MAXParts and Service

PBGT22H54 specifications

The Poulan PBGT22H54 is a versatile and robust lawn tractor designed to meet the needs of homeowners looking for an efficient solution for their mowing tasks. With a powerful engine and a range of features, this model stands out in the crowded market of riding mowers.

At the heart of the PBGT22H54 is a reliable Briggs & Stratton engine that delivers ample power for mowing even the toughest grass. This 22-horsepower engine ensures a smooth operation, providing the torque necessary for effective cutting. The tractor is equipped with a hydrostatic transmission, allowing for effortless speed control. This feature enables users to operate the machine at their desired pace without the need for manual shifting, making it intuitive and user-friendly.

One of the key characteristics of the Poulan PBGT22H54 is its 54-inch cutting deck, crafted for efficiency and precision. The wide cutting path allows for fewer passes over the lawn, drastically reducing mowing time. Additionally, the deck height can be easily adjusted, enabling users to choose the optimal cutting height to suit various types of grass and desired finishes. The reinforced deck construction ensures durability, making it capable of withstanding the rigors of regular use.

The tractor also boasts a comfortable, adjustable seat designed for extended use, minimizing fatigue during longer mowing sessions. The ergonomic design of the steering wheel enhances control, making maneuverability easier around obstacles in the yard, such as trees and flower beds.

The Poulan PBGT22H54 incorporates innovative technologies, including the ability to mulch or bag clippings, providing versatility in lawn care. The optional mulching kit recycles grass clippings, returning valuable nutrients to the soil, whereas the bagging option ensures a tidy finish.

In terms of maintenance, the tractor is designed for ease of servicing. Accessing the engine and other vital components is straightforward, allowing for faster oil changes and routine inspections.

Overall, the Poulan PBGT22H54 is an excellent choice for homeowners seeking a reliable, feature-rich lawn tractor. With its powerful engine, wide cutting deck, and user-friendly design, mowing becomes an efficient and enjoyable task, ensuring that your lawn receives the best care possible.
Top Page Image Contents