Poulan PBA19542LTX manual To Check Brake, To Replace Mower Blade Drive Belt See Fig, Belt Removal

Page 21

SERVICE AND ADJUSTMENTS

TO CHECK BRAKE

If tractor requires more than five (5) feet to stop at highest speed in highest gear on a level, dry concrete or paved surface, then brake must be serviced.

You may also check brake by:

1.Park tractor on a level, dry concrete or paved surface, depress clutch/brake pedal all the way down and en- gage parking brake.

2.Place gear shift lever in neutral (N) position.

The rear wheels must lock and skid when you try to manu- ally push the tractor forward. If the rear wheels rotate, then the brake needs to be serviced. Contact a qualified service center.

TO REPLACE MOWER BLADE DRIVE BELT (See Fig. 20)

The mower blade drive belt may be replaced without tools. Park the tractor on level surface. Engage parking brake.

BELT REMOVAL -

Remove mower from tractor (See “TO REMOVE MOWER” in this section of this manual).

Work belt off both mandrel pulleys and idler pulleys.

Pull belt away from mower.

BELT INSTALLATION -

Install new belt in reverse order of removal.

Make sure belt is in all pulley grooves and inside all belt guides.

Install mower in reverse order of removal instruc- tions.

MANDREL

IDLER

PULLEY

PULLEYS

MANDREL

 

PULLEY

 

FIG. 20

TO REPLACE MOTION DRIVE BELT (See Fig. 22)

Park the tractor on level surface. Engage parking brake. For assistance, there is a belt installation guide decal on bottom side of left footrest.

BELT REMOVAL -

Remove mower (See “TO REMOVE MOWER” in this section of manual).

NOTE: Observe entire motion drive belt and position of all belt guides and keepers.

Remove belt from stationary idler and clutching idler.

Remove belt downward from around engine pulley.

Pull belt slack toward rear of tractor. Carefully remove belt upwards from transmission input pulley and over cooling fan blades.

Remove belt from center span keeper and pull belt away from tractor.

BELT INSTALLATION -

Carefully work new belt down around transmission cooling fan and onto the input pulley.

Slide belt into the center span keeper.

Pull belt toward front of tractor and roll around the top groove of engine pulley.

Install belt through stationary idler and clutching idler.

Make sure belt is in all pulley grooves and inside all belt guides and keepers.

Install mower (See “TO INSTALL MOWER” in this section of manual).

ENGINE

PULLEY

CLUTCHING

IDLER

STATIONARY

IDLER

TRANSMISSION

 

INPUT PULLEY

CENTER SPAN

 

KEEPER

FIG. 22

21

Image 21
Contents Lawn Tractor Model PBA19542LTXSafe Operation Practices for Ride-On Mowers Safety RulesGeneral Operation II. Slope OperationService III. ChildrenIV. Towing Table of Contents Steering Wheel Unassembled PartsSeat KeysTools Required for Assembly AssemblyTo Remove Tractor from Carton Before Removing Tractor from SkidCheck Battery See Fig Install Seat See FigCheck Deck Levelness Check Tire PressureCheck for Proper Position of ALL Belts Check Brake SystemOperation Know Your Tractor HOW to USE Your Tractor To Operate Mower See Fig Reverse Operation System ROSTo Operate on Hills To Transport Before Starting the EngineCheck Engine OIL Level ADD GasolineMowing Tips General Recommendations MaintenanceBefore Each USE Check Brake Operation Check Tire PressureBlade Removal See Fig TractorTo Sharpen Blade See Fig Check Operator Presence SystemEngine Clean AIR Screen CleaningAIR Filter MufflerTo Install Mower See Fig Service and AdjustmentsTo Level Mower Housing To Remove Mower See FigRecheck side-to-side adjustment To Check Brake Belt InstallationTo Replace Mower Blade Drive Belt See Fig To Replace Motion Drive Belt See FigTo Start Engine with a Weak Battery See Fig Transaxle Gear Shift Lever NEUTRAL- Adjustment See FigTo Adjust Steering Wheel ALIGN- Ment Front Wheel TOE-IN/CAMBERTo Adjust Carburetor To Adjust Throttle Control CableTo Replace Headlight Bulb Interlocks and RelaysOther StorageFuel System Engine OILProblem Cause Correction Troubleshooting PointsEngine dies when HOP Outdoor Products Customer Service DeptCanada contact Stevens Creek Road Terry Fox Way Augusta, GA 30907 USAService Notes Suggested Guide for Sighting Slopes for Safe Operation Parts and Service Changere DE Pièces LES ET L’ENTRETIEN UNE Pliez EST Ceci Degrés Suivant LES’ENTRETIEN Remarques Dept Service Customer Products Outdoor Canada Au AutoriséGarantie cette de exclus sont normal l’entretien et Conducteur le lorsque Dépannage DE GuideLame de mandrin le Remplacez Tordu est lame de mandrin Un Entreposage MoteurTracteur Moteur Reglages ET RevisionLA DE L’ALIGNEMENT Régler Pour Rossage -AVANT/CAR Roues DES ConvergenceFig la Voir Vitesses DE Boîte LA DE MentgeFig la Voir ’EN Courroie LA Remplacer PourCourroie Acer Rempl Pour 19 .FIG Tondeuse DE Boîtier LE Niveler Pour18 .FIG 17 .FIG15 .FIG Tracteur’ALLUMAGE Bougie EntretienAIR À Filtre ’AIR Tamis LE NettoyerTransmission LA DE Refroidissement Sionmistrans LA DE Moteur FluideFig la Voir Lame LA Affiler Trapézoïdales CourroiesEN Fonctionnement DE Système ET Fig la Voir Lame LA EnleverGénérales Recommandations LESLubrification DE Tableau Utilisation Chaque AvantUtilisation Tondre DE ConseilsAvec marcher le-faites moteur, le démarrez vous Quand Moteur LE Démarrer DE Avant Pentes LES Dans Utiliser Pour Fonction DE Système DU UtilisationMAR EN Fonctionnement DE Système Teurtrac Votre Utiliser Comment GAZ DES Commande LA Utiliser PourReculer Pour ET Avancer Pour Fig la Voir Arrêter PourLSW02838 ’EMBRAYAGE Desmancom des tionfonc la et MontageTionsec la Voir Conduisant LE EN Lette PA LA DE Tracteur LE Retirer PourVotre Monter Comment Fig la Voir Siège LE InstallerDesman Com des fonction la et mentceplalemDU Tracteur LE Sortir Pour Palette LAToncar Pente-Guide Montées NON PiécesClient DU Responsabilités SommaireProduit DE Spécifications CCA .MIN AMP/HRRemorquage EntretienEnfants Général EntretienPEN LES Dans Fonctionnement TESGénéral Fonctionnement Tracteurs des sécurité toute en l’utilisation pour ConseilsLTX19542PBA Modèle Com.poulan.www web site notre VisitezAUX Imprimé