Poulan PBA19542LT manual Check Tire Pressure, Check Deck Levelness, Check Brake System

Page 8

ASSEMBLY

TO DRIVE TRACTOR OFF SKID (See Op- eration section for location and function of controls)

Be sure all the above assembly steps have been com- pleted.

Check engine oil level and fill fuel tank with gasoline.

Sit on seat in operating position, depress clutch/brake pedal and set the parking brake.

Place gear shift lever in neutral (N) position.

Press lift lever plunger and raise attachment lift lever to its highest position.

Remove key from bag and start the engine (see "TO START ENGINE" in the Operation section of this manual). After engine has started, move throttle control to idle (slow) position.

Depress clutch/brake pedal into full "BRAKE" position and hold. Move gearshift lever to 1st gear.

Slowly release clutch/brake pedal and slowly drive tractor off skid.

Apply brake to stop tractor, set parking brake and place gearshift lever in neutral position.

Turn ignition key to "STOP" position.

Continue with the instructions that follow.

CHECK TIRE PRESSURE

The tires on your tractor were overinflated at the factory for shipping purposes. Correct tire pressure is important for best cutting performance.

Reduce tire pressure to PSI shown on tires.

CHECK DECK LEVELNESS

For best cutting results, mower housing should be prop- erly leveled. See “TO LEVEL MOWER HOUSING” in the Service and Adjustments section of this manual.

CHECK FOR PROPER POSITION OF ALL BELTS

See the figures that are shown for replacing motion and mower blade drive belts in the Service and Adjustments section of this manual. Verify that the belts are routed correctly.

CHECK BRAKE SYSTEM

After you learn how to operate your tractor, check to see that the brake is operating properly. See “TO CHECK BRAKE” in the Service and Adjustments section of this manual.

CHECKLIST

BEFORE YOU OPERATE YOUR NEW TRACTOR, WE WISH TO ASSURE THAT YOU RECEIVE THE BEST PER- FORMANCE AND SATISFACTION FROM THIS QUALITY PRODUCT.

PLEASE REVIEW THE FOLLOWING CHECKLIST:

All assembly instructions have been completed.

No remaining loose parts in carton.

Battery is properly prepared and charged.

Seat is adjusted comfortably and tightened securely.

All tires are properly inflated. (For shipping purposes, the tires were overinflated at the factory).

Be sure mower deck is properly leveled side-to-side/ front-to-rear for best cutting results. (Tires must be properly inflated for leveling).

Check mower and drive belts. Be sure they are routed properly around pulleys and inside all belt keepers.

Check wiring. See that all connections are still secure and wires are properly clamped.

Before driving tractor, be sure freewheel control is in “transmission engaged” position (see “TO TRANS- PORT” in the Operation section of this manual).

WHILE LEARNING HOW TO USE YOUR TRACTOR, PAY EXTRA ATTENTION TO THE FOLLOWING IMPORTANT ITEMS:

Engine oil is at proper level.

Fuel tank is filled with fresh, clean, regular unleaded gasoline.

Become familiar with all controls, their location and function. Operate them before you start the engine.

Be sure brake system is in safe operating condition.

Be sure Operator Presence System and Reverse Op- eration System (ROS) are working properly (See the Operation and Maintenance sections in this manual).

It is important to purge the transmission before op- erating your tractor for the first time. Follow proper starting and transmission purging instructions (See “TO START ENGINE” and “PURGE TRANSMISSION” in the Operation section of this manual).

8

Image 8
Contents Model PBA19542LTSafety Rules Safe Operation Practices for Ride-On MowersGeneral Operation II. Slope OperationIV. Towing ServiceIII. Children Table of Contents Unassembled Parts Steering WheelSeat KeysAssembly Tools Required for AssemblyTo Remove Tractor from Carton Before Removing Tractor from SkidInstall Seat See Fig Check Battery See FigCheck Tire Pressure Check Deck LevelnessCheck for Proper Position of ALL Belts Check Brake SystemOperation Know Your Tractor HOW to USE Your Tractor To Operate on Hills To Operate Mower See FigReverse Operation System ROS Before Starting the Engine To TransportCheck Engine OIL Level ADD GasolineMowing Tips Maintenance General RecommendationsBefore Each USE Check Brake Operation Check Tire PressureTractor Blade Removal See FigTo Sharpen Blade See Fig Check Operator Presence SystemEngine Cleaning Clean AIR ScreenAIR Filter MufflerService and Adjustments To Install Mower See FigTo Level Mower Housing To Remove Mower See FigRecheck side-to-side adjustment Belt Installation To Check BrakeTo Replace Mower Blade Drive Belt See Fig To Replace Motion Drive Belt See FigTransaxle Gear Shift Lever NEUTRAL- Adjustment See Fig To Start Engine with a Weak Battery See FigTo Adjust Steering Wheel ALIGN- Ment Front Wheel TOE-IN/CAMBERTo Adjust Throttle Control Cable To Adjust CarburetorTo Replace Headlight Bulb Interlocks and RelaysStorage OtherFuel System Engine OILTroubleshooting Points Problem Cause CorrectionEngine dies when Outdoor Products Customer Service Dept HOPCanada contact Stevens Creek Road Terry Fox Way Augusta, GA 30907 USAService Notes Suggested Guide for Sighting Slopes for Safe Operation Parts and Service Changere DE Pièces LES ET L’ENTRETIEN Degrés Suivant LES UNE Pliez EST Ceci’ENTRETIEN Remarques Garantie cette de exclus sont normal l’entretien et Dept Service Customer Products Outdoor Canada AuAutorisé Dépannage DE Guide Conducteur le lorsqueLame de mandrin le Remplacez Tordu est lame de mandrin Un Tracteur EntreposageMoteur Reglages ET Revision MoteurRossage -AVANT/CAR Roues DES Convergence LA DE L’ALIGNEMENT Régler PourFig la Voir Vitesses DE Boîte LA DE MentgeCourroie Acer Rempl Pour Fig la Voir’EN Courroie LA Remplacer Pour Tondeuse DE Boîtier LE Niveler Pour 19 .FIG18 .FIG 17 .FIGTracteur 15 .FIGEntretien ’ALLUMAGE BougieAIR À Filtre ’AIR Tamis LE NettoyerSionmistrans LA DE Moteur Fluide Transmission LA DE RefroidissementFig la Voir Lame LA Affiler Trapézoïdales CourroiesFig la Voir Lame LA Enlever EN Fonctionnement DE Système ETRecommandations LES GénéralesLubrification DE Tableau Utilisation Chaque AvantAvec marcher le-faites moteur, le démarrez vous Quand UtilisationTondre DE Conseils Moteur LE Démarrer DE Avant MAR EN Fonctionnement DE Système Pentes LES Dans Utiliser PourFonction DE Système DU Utilisation GAZ DES Commande LA Utiliser Pour Teurtrac Votre Utiliser CommentReculer Pour ET Avancer Pour Fig la Voir Arrêter PourLSW02838 ’EMBRAYAGE Montage Desmancom des tionfonc la etTionsec la Voir Conduisant LE EN Lette PA LA DE Tracteur LE Retirer PourFig la Voir Siège LE Installer Votre Monter CommentDesman Com des fonction la et mentceplalemToncar DU Tracteur LE Sortir PourPalette LA Montées NON Piéces Pente-GuideSommaire Client DU ResponsabilitésProduit DE Spécifications CCA .MIN AMP/HREntretien RemorquageEnfants Général EntretienTES PEN LES Dans FonctionnementGénéral Fonctionnement Tracteurs des sécurité toute en l’utilisation pour ConseilsAUX Imprimé ModèleCom.poulan.www web site notre Visitez

PBA19542LT specifications

The Poulan PBA19542LT is a versatile and powerful tool designed to meet the demands of both homeowners and professionals for yard care and maintenance. This battery-powered lawn care equipment combines convenience with performance, making it a go-to option for tackling various outdoor tasks with ease.

One of the standout features of the PBA19542LT is its 42V lithium-ion battery that provides an impressive runtime. This technology ensures that users have enough power to complete their tasks without the hassle of cords or the need for frequent recharging. The battery is designed to efficiently manage energy use, offering consistent performance until it requires a recharge, allowing for longer periods of use on a single charge.

This model is equipped with a robust brushless motor, which enhances its overall performance. The brushless motor operates more efficiently than traditional motors, reducing wear and tear, allowing for a longer lifespan. It provides a quiet operation, making it suitable for residential areas and times when noise should be minimized.

The Poulan PBA19542LT also features an adjustable cutting height system. This allows users to customize the height of the cut according to their preferences or the specific requirements of their lawn. With a simple adjustment, it can handle different types of grass and terrain, providing a tailored mowing experience.

Another notable characteristic of this lawn care tool is its lightweight design. Weighing significantly less than many gas-powered counterparts, the PBA19542LT allows for ease of maneuverability, reducing fatigue during extended use. Ergonomically designed handles provide comfort and control, ensuring a pleasant user experience while navigating around flower beds or other landscape features.

Additionally, the PBA19542LT incorporates user-friendly features, such as quick-release battery access, making swapping batteries or charging them more convenient. The compact design also allows for easy storage when not in use.

In summary, the Poulan PBA19542LT is an innovative, battery-powered lawn maintenance tool that offers a blend of power, efficiency, and user convenience. With its brushless motor, adjustable cutting heights, lightweight construction, and reliable battery technology, it stands out in the market for those seeking efficient and effective lawn care. Ideal for residential use, it meets the evolving needs of homeowners looking to maintain their outdoor spaces with minimal hassle.