Poulan PBA195H42LT manual To Replace Headlight Bulb, Interlocks and Relays, To Replace Fuse

Page 23

SERVICE AND ADJUSTMENTS

REPLACING BATTERY (See Figs. 26 and 27)

WARNING: Do not short battery terminals by allowing a wrench or any other object to contact both terminals at the same time. Before connect- ing battery, remove metal bracelets, wristwatch bands, rings, etc. Positive terminal must be connected first to prevent sparking from acci- dental grounding.

Lift seat pan to raised position.

Disconnect BLACK battery cable first then RED battery cable and carefully remove battery from tractor.

Install new battery with terminals in same position as old battery.

First connect RED battery cable to positive (+) terminal with hex bolt and keps nut as shown. Tighten securely. Slide terminal cover over terminal.

Connect BLACK grounding cable to negative (-) ter- minal with remaining hex bolt and keps nut. Tighten securely.

SEAT PAN

FIG. 26

TERMINAL

KEPS

NUT

COVER

 

HEX

BOLT

POSITIVE (RED)

NEGATIVE

CABLE

(BLACK) CABLE

FIG. 27

TO REPLACE HEADLIGHT BULB

Raise hood.

Pull bulb holder out of the hole in the backside of the grill.

Replace bulb in holder and push bulb holder securely back into the hole in the backside of the grill.

Close hood.

INTERLOCKS AND RELAYS

Loose or damaged wiring may cause your tractor to run poorly, stop running, or prevent it from starting.

Check wiring. See electrical wiring diagram in the Repair Parts section.

TO REPLACE FUSE

Replace with 20 amp automotive-type plug-in fuse. The fuse holder is located behind the dash.

TO REMOVE HOOD AND GRILL ASSEMBLY (See Fig. 28)

Raise hood.

Unsnap headlight wire connector.

Stand in front of tractor. Grasp hood at sides, tilt toward engine and lift off of tractor.

To replace, reverse above procedure.

HOOD

HEADLIGHT

WIRE

CONNECTOR

03075

FIG. 28

ENGINE

TO ADJUST THROTTLE CONTROL CABLE

The throttle control has been preset at the factory and adjustment should not be necessary. If adjustment is nec- essary, see engine manual.

TO ADJUST CHOKE CONTROL

The choke control has been preset at the factory and ad- justment should not be necessary. If adjustment is neces- sary, see engne manual.

TO ADJUST CARBURETOR

Your carburetor is not adjustable. If your engine does not operate properly due to suspected carburetor problems, take your tractor to an authorized service center for repair and/or adjustment.

23

Image 23
Contents Lawn Tractor Model PBA195H42LTII. Slope Operation Safety RulesSafe Operation Practices for Ride-On Mowers General OperationIV. Towing ServiceIII. Children Table of Contents Slope Sheet Unassembled PartsSteering Wheel SeatBefore Removing Tractor from Skid AssemblyTools Required for Assembly To Remove Tractor from CartonCheck Battery See Fig Install Seat See FigCheck Brake System Check Tire PressureCheck Deck Levelness Check for Proper Position of ALL BeltsOperation Know Your Tractor HOW to USE Your Tractor To Operate on Hills To Operate Mower See FigReverse Operation System ROS ADD Gasoline Before Starting the EngineTo Transport See Figs Check Engine OIL LevelNing Mowing TipsPurge Transmission Automatic Transmission Warm UPBefore Each USE MaintenanceLubrication Chart General RecommendationsCheck Operator Presence System TractorBlade Removal See Fig To Sharpen Blade See FigEngine Muffler CleaningClean AIR Screen AIR FilterTo Remove Mower See Fig Service and AdjustmentsTo Install Mower See Fig To Level Mower HousingBelt Removal Belt InstallationTo Replace Mower Blade Drive Belt See Fig To Replace Motion Drive Belt See Fig To Check and Adjust Brake See FigTransaxle Motion Control Lever Neutral Adjustment See Fig To Adjust BrakeFront Wheel TOE-IN/CAMBER Transmission REMOVAL/REPLACEMENTTo Adjust Steering Wheel ALIGN- Ment To Start Engine with a Weak Battery See FigTo Replace Headlight Bulb To Adjust Throttle Control CableTo Adjust Choke Control To Adjust CarburetorEngine OIL StorageOther Fuel SystemProblem Cause Correction Troubleshooting PointsEngine dies when L5V 3E4 Limited WarrantyService Notes Suggested Guide for Sighting Slopes for Safe Operation Parts and Service Changere DE Pièces LES ET L’ENTRETIEN UNE Pliez EST Ceci Degrés Suivant LESDentretien Notes Garantie cette de exclus sont normal l’entretien et AutoriséConducteur le lorsque Dépannage DE GuideLame de mandrin le Remplacez Tordu est lame de mandrin Un Tracteur EntreposageMoteur Moteur Reglages ET RevisionLA DE L’ALIGNEMENT Régler Pour LA DE ENLEVEMENT/REMPLACEMENTRossage AVANT/CAR Roues DES ConvergenceTransmission DE Mentnetraî Fig la Voir’EN Courroie LA Remplacer Pour Frein LE Régler ET Contrôler PourTondeuse DE Lame DE MENTNETRAÎD’EN Courroie Acer Rempl PourLautre À Côté DUN Réglage Tondeuse DE Boîtier LE Niveler Pour15 .FIG ’AIR Tamis LE Nettoyer Entretien’ALLUMAGE Bougie AIR À FiltreTrapézoïdales Courroies Sionmistrans LA DE Moteur FluideTransmission LA DE Refroidissement Fig la Voir Lame LA AffilerEN Fonctionnement DE Système ET Fig la Voir Lame LA EnleverUtilisation Chaque Avant Recommandations LESGénérales Lubrification DE TableauQueti UtilisationTondre DE Conseils Transmission LA PurgerMoteur LE Démarrer DE Avant Pentes LES Dans Utiliser Pour Et 4 .Fig les VoirEN Fonctionnement DE Système Tracteur LE Transporter PourFig la Voir Mentnetionsta DE Frein LE Engager Pour GAZ DES Commande LA Utiliser PourTeurtrac Votre Utiliser Comment Fig la Voir Arrêter PourLSW02838 ’EMBRAYAGE Tionsec la Voir Conduisant LE EN Telet MontageNI DE EST Tondeuse LA SI Vérifier Desmancom des tionfonc la etCom des fonction la et mentceplalem Fig la Voir Siège LE InstallerVotre Monter Comment DesmanToncar DU Tracteur LE Sortir PourPalette LA Daptateur Montées NON PiécesUidepente CCA .MIN AMP/HR SommaireClient DU Responsabilités Produit DE SpécificationsGénéral Entretien EntretienRemorquage EnfantsTracteurs des sécurité toute en l’utilisation pour Conseils TESPEN LES Dans Fonctionnement Général FonctionnementAUX Imprimé PBA195H42LT ModèleCom.poulan.www web site notre Visitez