Poulan PO17542LTX manual Tractor, Blade Removal See Fig, To Sharpen Blade See Fig

Page 16

MAINTENANCE

TRACTOR

Always observe safety rules when performing any main- tenance.

BRAKE OPERATION

If tractor requires more than five (5) feet to stop at highest speed in highest gear on a level, dry concrete or paved surface, then brake must be checked and adjusted. (See “TO ADJUST BRAKE” in the Service and Adjustments section of this manual).

TIRES

•Maintain proper air pressure in all tires (See “PRODUCT SPECIFICATIONS” section of this manual).

•Keep tires free of gasoline, oil, or insect control chemi- cals which can harm rubber.

•Avoid stumps, stones, deep ruts, sharp objects and other hazards that may cause tire damage.

NOTE: To seal tire punctures and prevent flat tires due to slow leaks, tire sealant may be purchased from your local parts dealer. Tire sealant also prevents tire dry rot and corrosion.

OPERATOR PRESENCE SYSTEM AND REVERSE OP- ERATION SYSTEM (ROS)

Be sure operator presence and reverse operation systems are working properly. If your tractor does not function as described, repair the problem immediately.

•The engine should not start unless the brake pedal is fully depressed, and the attachment clutch control is in the disengaged position.

CHECK OPERATOR PRESENCE SYSTEM

•When the engine is running, any attempt by the operator to leave the seat without first setting the parking brake should shut off the engine.

•When the engine is running and the attachment clutch is engaged, any attempt by the operator to leave the seat should shut off the engine.

•The attachment clutch should never operate unless the operator is in the seat.

CHECK REVERSE OPERATION (ROS) SYSTEM

•When the engine is running with the ignition switch in the engine "ON" position and the attachment clutch engaged, any attempt by the operator to shift into reverse should shut off the engine.

•When the engine is running with the ignition switch in the ROS "ON" position and the attachment clutch en- gaged, any attempt by the operator to shift into reverse should NOT shut off the engine.

ROS "ON" POSITION

ENGINE "ON" POSITION

 

(NORMAL OPERATING)

828

BLADE CARE

For best results mower blades must be kept sharp. Replace bent or damaged blades.

CAUTION: Useonlyareplacementblade approved by the manufacturer of your tractor. Using a blade not approved by the manufacturer of your tractor is hazardous, could damage your tractor and void your warranty.

BLADE REMOVAL (See Fig. 8)

•Raise mower to highest position to allow access to blades.

•Remove blade bolt, lock washer and flat washer securing blade.

•Install new or resharpened blade with trailing edge up towards deck as shown.

IMPORTANT: TO ENSURE PROPER ASSEMBLY, CENTER HOLE IN BLADE MUST ALIGN WITH STAR ON MANDREL ASSEMBLY.

•Reassemble blade bolt, lock washer and flat washer in exact order as shown.

•Tighten blade bolt securely (27-35 Ft. Lbs. torque).

IMPORTANT: BLADE BOLT IS HEAT TREATED. IF BOLT NEEDS REPLACING, REPLACE ONLY WITH APPROVE BOLT SHOWN IN THE REPAIR PARTS.

TRAILING

 

MANDREL

EDGE UP

BLADE

ASSEMBLY

 

 

CENTER

HOLE

STAR

BLADE BOLT

FIG. 8

TO SHARPEN BLADE (See Fig. 9)

NOTE: We do not recommend sharpening blade - but if you do, be sure the blade is balanced.

Care should be taken to keep the blade balanced. An un- balanced blade will cause excessive vibration and eventual damage to mower and engine.

•The blade can be sharpened with a file or on a grind- ing wheel. Do not attempt to sharpen while on the mower.

•To check blade balance, you will need a 5/8" diameter steel bolt, pin, or a cone balancer. (When using a cone balancer, follow the instructions supplied with balancer.)

NOTE: Do not use a nail for balancing blade. The lobes of the center hole may appear to be centered, but are not.

16

Page 15 Page 17
Image 16
Page 15 Page 17
Contents PO17542LTX ModelGeneral Operation Safe Operation Practices for Ride-On MowersII. Slope Operation III. Children ServiceIV. Towing Table of Contents Contents of Hardware Pack Tools Required for Assembly Install Seat See FigBefore Removing Tractor from Skid Attach Steering Wheel See FigCheck Battery See Fig Check Tire Pressure Check Deck LevelnessCheck for Proper Position of ALL Belts Check Brake SystemOperation Know Your Tractor HOW to USE Your Tractor Reverse Operation System ROS To Operate Mower See FigTo Operate on Hills To TransportBefore Starting the Engine Check Engine OIL LevelADD Gasoline To Start Engine See FigMowing Tips Maintenance Schedule Lubrication ChartGeneral Recommendations Before Each USETractor Blade Removal See FigTo Sharpen Blade See Fig Check Operator Presence SystemBattery EngineBelts Transaxle CoolingCleaning Clean AIR ScreenAIR Filter MufflerTo Install Mower See Fig To Remove Mower See FigTo Level Mower Housing Belt InstallationTo Replace Mower Blade Drive Belt See Fig Belt RemovalTo Check Brake To Replace Motion Drive Belt See FigTransaxle Gear Shift Lever NEUTRAL- Adjustment See Fig To Start Engine with a Weak Battery See FigTo Adjust Steering Wheel ALIGN- Ment Front Wheel TOE-IN/CAMBERTo Adjust Throttle Control Cable To Adjust Choke ControlTo Adjust Carburetor To Replace Headlight BulbOther Fuel SystemEngine OIL CylindersTroubleshooting Points Problem Cause CorrectionEngine dies when Limited Warranty L5V 3E4Service Notes Suggested Guide for Sighting Slopes for Safe Operation Parts and Service Changere DE Pièces LES ET L’ENTRETIEN Degrés Dentretien Notes Garantie cette de exclus sont normal l’entretien et AutoriséInitiale d’achat date la de compter à jours 90 dix Dépannage DE Guide Défectueux estRalenti Entreposage MoteurRéglages ET Révision MoteurCarrossage AVANT/ Roues DES ConvergenceDI LA DE L’ALIGNEMENT Régler Pour Vitesses DE Boîte LA DE MentgechanCourroie LA Remplacer Pour Transmission DE MENTNETRAÎD’ENFreins LES Vérifier Pour 20 .FIGCourroie Acer Rempl Pour DE Boîtier LE Niveau DE Mettre PourTondeuse DE Lame DE MENTNETRAÎD’EN SedeutonFig la Voir Tondeuse LA Installer Pour Reglages ET RevisionTracteur Tondeuse LA Enlever PourLigne EN Installé D’ESSENCE Filtre Entretien’ALLUMAGE Bougie AIR À FiltreTransmission LA DE Refroidissement LubrificationTrapézoïdales Courroies 11 .FIGFig la Voir Lame LA Enlever Fig la Voir Lame LA AffilerEN Fonctionnement DE Système ET Recommandations LES GénéralesLubrification DE Tableau Utilisation Chaque AvantTonte DE Conseils UtilisationUtilisé resoiceslac à et terrain au convient qui vitesse Moteur LE Démarrer DE Avant Moteur LE Démarrer Pour’ESSENCE Réservoir LE Remplir Moteur DU D’HUILE Niveau LE VérifierAccessoires Autres ET Charrettes DES Remorquer PourTracteur LE Transporter Pour Pentes LES Dans Utiliser PourGAZ DES Commande LA Utiliser Pour Teurtrac E R T O V R E S I L I T U T N E M M O CFig la Voir Arrêter Pour Fig la Voir Mentnetionsta DE Frein LE Engager Pour02829 Moteur Montage LA DE Tracteur LE Retirer Pour Desmancom DESCON Pour Mentnetionfonc Tionsec LA Voir Rouler Faisant LE EN EtteFig la Voir Siège LE Installer DU Tracteur LE Sortir PourTracteur Votre DE Getamon LE Pour Exigés Outils LES Palette LAMontar SIN Piezas Client DU Responsabilités SommaireProduit DE Spécifications Entretien RemorquageEnfants Général EntretienPentes LES Dans FonctionnementGénéral Fonctionnement Tracteurs des sécurité toute en l’utilisation pour ConseilsAUX Imprimé

PO17542LTX specifications

The Poulan PO17542LTX is a lawn tractor designed for homeowners seeking a reliable, efficient, and easy-to-use mower for their lawns. This machine combines power with innovative features, making it an excellent choice for maintaining medium to large-sized yards. With a focus on performance, durability, and comfort, the PO17542LTX stands out in the crowded market of lawn care equipment.

One of the primary features of the Poulan PO17542LTX is its robust engine. Equipped with a 17.5-horsepower Briggs & Stratton engine, this tractor provides ample power to tackle thick grass and rough terrain. The engine's performance is complemented by an automatic transmission, allowing for smooth operation without the need for manual gear shifting. This feature is particularly beneficial for users who want to navigate their lawns with ease.

The mower deck on the PO17542LTX is another highlight, measuring 42 inches in width. This size allows for efficient cutting while maneuvering around obstacles such as trees and garden beds. The cutting height can be easily adjusted, providing 6 different height settings to ensure users can achieve the desired lawn appearance, whether they prefer a closely trimmed look or a taller grass.

A noteworthy technology present in this lawn tractor is its easy-access serviceability. The design of the PO17542LTX allows users to quickly reach vital components, making maintenance and repairs straightforward. This focus on user-friendliness also extends to the control panel, which features simple controls that anyone can understand, enhancing the overall experience.

Comfort is a key characteristic of the Poulan PO17542LTX. It features a cushioned seat that allows users to mow for extended periods without discomfort. The ergonomically designed steering wheel makes it easier to navigate tight areas and sharp corners. Additionally, the tractor’s compact design improves maneuverability, making it suitable for various landscapes.

In terms of durability, the PO17542LTX is built to last. Constructed with high-quality materials, it can withstand the rigors of regular use while maintaining its performance over time. This makes it an investment that homeowners can rely on for years.

Overall, the Poulan PO17542LTX offers a blend of power, comfort, and usability, making it an ideal choice for homeowners looking to maintain their lawns efficiently and effectively. With its robust features and technologies, it ensures a pleasant mowing experience that can easily handle a variety of lawn care tasks.
Top Page Image Contents