MAINTENANCE
ENGINE COOLING FINS (See Fig. 13)
Remove any dust, dirt or oil from engine cooling fins to prevent engine damage from overheating.
•Remove screws from blower housing and lift housing and dipstick tube assembly off engine.
•Cover oil fill opening to prevent entry of dirt.
•Use compressed air or stiff bristle brush to thoroughly clean engine cooling fins.
•To reassemble, reverse above procedure.
SCREWS
BLOWER HOUSING
SCREWS
AIR SCREEN
DIPSTICK TUBE
ASSEMBLY
| SPARK |
ENGINE COOLING FINS | PLUG |
FIG. 13
AIR FILTER (See Fig. 14)
Your engine will not run properly using a dirty air filter. Replace
Service air cleaner more often under dusty conditions.
•Pull up on air filter cover handle and rotate towards engine.
•Remove cover.
•Carefully remove air filter cartridge and
•Clean base carefully to prevent debris from falling into carburetor.
NOTE: If very dirty or damaged, replace cartridge.
•Place new
•Align tabs on cover with slots in blower housing and replace cover.
•Hook handle on cover and push down on handle to close.
IMPORTANT: Petroleum solvents, such as kerosene, are not to be used to clean the cartridge. They may cause deterioration of the cartridge. Do not oil cartridge. Do not use pressurized air to clean cartridge.
HANDLE
COVER
CARTRIDGE
TABS
BASE
SLOTS
FIG. 14
MUFFLER
Inspect and replace corroded muffler and spark arrester (if equipped) as it could create a fire hazard and/or dam- age.
SPARK PLUGS
Replace spark plugs at the beginning of each mowing season or after every 100 hours of operation, whichever occurs first. Spark plug type and gap setting are shown in “PRODUCT SPECIFICATIONS” section of this manual.
IN-LINE FUEL FILTER (See Fig. 15)
The fuel filter should be replaced once each season. If fuel filter becomes clogged, obstructing fuel flow to carburetor, replacement is required.
•With engine cool, remove filter and plug fuel line sec- tions.
•Place new fuel filter in position in fuel line with arrow pointing towards carburetor.
•Be sure there are no fuel line leaks and clamps are properly positioned.
•Immediately wipe up any spilled gasoline.
CLAMP
CLAMP
FUEL FILTER
FIG. 15
CLEANING
•Clean engine, battery, seat, finish, etc. of all foreign matter.
•Keep finished surfaces and wheels free of all gasoline, oil, etc.
•Protect painted surfaces with automotive type wax.
We do not recommend using a garden hose or pressure washer to clean your tractor unless the engine and trans- mission are covered to keep water out. Water in engine or transmission will shorten the useful life of your tractor. Use compressed air or a leaf blower to remove grass, leaves
18and trash from tractor and mower.