Poulan BB185H42LT manual Table of Contents

Page 4

PRODUCT SPECIFICATIONS

Gasoline Capacity

2.0 Gallons

and Type:

Unleaded Regular

 

 

Oil Type (API-SG-SL):

SAE 30 (above 32°F)

 

SAE 5W-30 (below 32°F)

Oil Capacity:

W/Filter:

3.5 Pints

 

W/O Filter:3.0 Pints

Spark Plug:

Champion RC12YC

(Gap: .030")

 

 

 

 

 

Ground Speed (MPH):

Forward:

5.5

 

Reverse:

2.4

 

 

 

Tire Pressure:

Front:

14 PSI

 

Rear:

10 PSI

 

 

Charging System:

3 Amps Battery

 

5 Amps Headlights

 

 

 

Battery:

AMP/HR:

28

 

Min. CCA:

230

 

Case Size:

U1R

 

 

Blade Torque:

27-35 FT. LBS.

CONGRATULATIONS on your purchase of a new tractor. It has been designed, engineered and manufactured to give you the best possible dependability and performance.

Should you experience any problem you cannot easily rem- edy, please contact your nearest authorized service center/ department. We have competent, well-trained technicians and the proper tools to service or repair this tractor.

Please read and retain this manual. The instructions will enable you to assemble and maintain your tractor properly. Always observe the “SAFETY RULES”.

CUSTOMER RESPONSIBILITIES

Read and observe the safety rules.

Follow a regular schedule in maintaining, caring for and using your tractor.

Follow the instructions under “Maintenace” and “Stor- age” sections of this owner’s manual.

WARNING: This tractor is equipped with an internal com- bustion engine and should not be used on or near any unimproved forest-covered, brush-covered or grass-covered land unless the engine’s exhaust system is equipped with a spark arrester meeting applicable local or state laws (if any). If a spark arrester is used, it should be maintained in effective working order by the operator.

A spark arrester for the muffl er is available through your nearest authorized service center/department.

TABLE OF CONTENTS

SAFETY RULES

2-3

PRODUCT SPECIFICATIONS

4

CUSTOMER RESPONSIBILITIES

4

ASSEMBLY

6-8

OPERATION

9-14

MAINTENANCE SCHEDULE

15

MAINTENANCE

15-18

SERVICE AND ADJUSTMENTS

19-23

STORAGE

24

TROUBLESHOOTING

25-26

WARRANTY

27

4

Image 4
Contents BB185H42LT Always Wear EYE Protection During OperationSafety Rules Safe Operation Practices for Ride-On MowersGeneral Operation II. Slope OperationService General ServiceIII. Children IV. TowingTable of Contents Steering Wheel Seat Unassembled PartsSlope Sheet Assembly Tools Required for AssemblyTo Remove Tractor from Carton Before Removing Tractor from SkidCheck Battery See Fig Check Tire Pressure Check Deck LevelnessCheck for Proper Position of ALL Belts Check Brake SystemOperation Know Your Tractor HOW to USE Your Tractor To Adjust Gauge Wheels See Fig Using the Reverse Operation SystemTo Operate Mower See Fig Reverse Operation System ROSBefore Starting the Engine To Transport See FigsCheck Engine OIL Level ADD GasolinePurge Transmission Mowing TipsAutomatic Transmission Warm UP Maintenance Lubrication ChartService Dates General RecommendationsBlade Removal See Fig TractorTo Sharpen Blade See Fig Engine Cleaning Service and Adjustments To Install Mower See FigTo Level Mower Housing To Remove Mower See FigTo Replace Mower Blade Drive Belt See Fig Belt InstallationBelt Removal To Check and Adjust Brake See Fig Transaxle Motion Control Lever Neutral Adjustment See FigTo Adjust Brake To Replace Motion Drive Belt See FigTransmission REMOVAL/REPLACEMENT To Adjust Steering Wheel ALIGN- MentTo Start Engine with a Weak Battery See Fig Front Wheel TOE-IN/CAMBERTo Adjust Throttle Control Cable To Adjust Choke ControlTo Adjust Carburetor To Replace Headlight BulbStorage OtherFuel System Engine OILTroubleshooting Points Problem Cause CorrectionEngine dies when Limited Warranty Policy Suggested Guide for Sighting Slopes for Safe Operation Only Ride UP and Down Hill Not Across Hill Degrees MAXParts and Service