SERVICE AND ADJUSTMENTS
TO REPLACE MOWER BLADE DRIVE BELT (See Fig. 17)
The mower blade drive belt may be replaced without tools. Park the tractor on level surface. Engage parking brake.
BELT REMOVAL -
•Place attachment clutch in “DISENGAGED” position.
•Move attachment lift lever forward to lower mower to its lowest position.
•Roll belt off engine pulley.
•Work belt off both mandrel pulleys and idler pulleys.
•Pull belt away from mower.
BELT INSTALLATION -
•Work new belt around both mandrel pulleys and idler pulleys.
•Install new belt into engine pulley groove.
•Make sure belt is inside the belt keeper at the idler and on both sides of the wire belt keeper as shown.
IMPORTANT: CHECK BELT FOR PROPER ROUTING IN ALL MOWER PULLEY GROOVES.
BELT KEEPER | WIRE BELT KEEPER |
| |
MANDREL |
|
PULLEY |
|
| ENGINE |
| PULLEY |
IDLER |
|
PULLEYS |
|
MANDREL |
|
PULLEY | 02844 |
|
FIG. 17
TO CHECK BRAKE
If tractor requires more than five (5) feet to stop at highest speed in highest gear on a level, dry concrete or paved surface, then brake must be serviced.
You may also check brake by:
1.Park tractor on a level, dry concrete or paved surface, depress clutch/brake pedal all the way down and en- gage parking brake.
2.Place gear shift lever in neutral (N) position.
The rear wheels must lock and skid when you try to manu- ally push the tractor forward. If the rear wheels rotate, then the brake needs to be serviced. Contact a qualified service center.
TO REPLACE MOTION DRIVE BELT (See Fig. 18)
Park the tractor on level surface. Engage parking brake. For assistance, there is a belt installation guide decal on bottom side of left footrest.
BELT REMOVAL -
•Remove mower (See “TO REMOVE MOWER” in this section of manual).
NOTE: Observe entire motion drive belt and position of all belt guides and keepers.
•Remove belt from stationary idler and clutching idler.
•Remove belt downward from around engine pulley.
•Pull belt slack toward rear of tractor. Remove belt upwards from transaxle pulley by deflecting belt keep- ers.
•Remove belt from center span keeper and pull belt away from tractor.
BELT INSTALLATION -
•Carefully work new belt down between transaxle belt keepers and onto the input pulley.
•Slide belt into the center span keeper.
•Pull belt toward front of tractor and roll around the top groove of engine pulley.
•Install belt through stationary idler and clutching idler.
•Make sure belt is in all pulley grooves and inside all belt guides and keepers.
•Install mower (See “TO INSTALL MOWER” in this sec- tion of manual).
ENGINE |
PULLEY |
CLUTCHING |
IDLER |
STATIONARY |
IDLER |
CENTER SPAN |
KEEPER |
TRANSAXLE |
PULLEY |
FIG. 18
21