Poulan 424634 Install Seat See Fig, Check Tire Pressure, Check Deck Levelness, Check Brake System

Page 7

ASSEMBLY

INSTALL SEAT (See Fig. 3)

Adjust seat before tightening adjustment bolt.

•Remove adjustment bolt, lock washer and flat washer securing seat to cardboard packing and set aside for assembly of seat to tractor.

•Pivot seat upward and remove from the cardboard pack- ing. Remove the cardboard packing and discard.

•Place seat on seat pan so head of shoulder bolt is positioned over large slotted hole in pan.

•Push down on seat to engage shoulder bolt in slot and pull seat towards rear of tractor.

•Pivot seat and pan forward and assemble adjustment bolt, lockwasher and flat washer loosely. Do not tighten Lower seat into operating position and sit on seat.

•Slide seat until a comfortable position is reached which allows you to press clutch/brake pedal all the way down.

•Get off seat without moving its adjusted position.

•Raise seat and tighten adjustment bolt securely.

 

SEAT

SHOULDER

 

 

 

 

BOLT

SEAT

 

 

PAN

 

 

FLAT WASHER

 

 

LOCK WASHER

 

 

ADJUSTMENT

 

02465

BOLT

 

 

Fig. 3

NOTE: You may now roll your tractor off the skid. Follow the instructions below to remove the tractor from the skid.

WARNING: Before starting, read, understand and follow all instructions in the Operation section of this manual. Be sure tractor is in a well-ventilated area. Be sure the area in front of tractor is clear of other people and objects.

TO ROLL TRACTOR OFF SKID (See Operation section for location and function of controls)

•Raise attachment lift lever to its highest position.

•Releaseparkingbrakebydepressingclutch/brakepedal.

•Place gearshift lever in neutral (N) position.

•Roll tractor forward off skid.

•Remove banding holding the deflector shield up against tractor.

Continue with the instructions that follow.

CHECK TIRE PRESSURE

The tires on your tractor were overinflated at the factory for shipping purposes. Correct tire pressure is important for best cutting performance.

•Reduce tire pressure to PSI shown on tires.

CHECK DECK LEVELNESS

For best cutting results, mower housing should be properly leveled. See “TO LEVEL MOWER HOUSING” in the Service and Adjustments section of this manual.

CHECK FOR PROPER POSITION OF ALL BELTS

See the figures that are shown for replacing motion and mower blade drive belts in the Service and Adjustments sec- tion of this manual. Verify that the belts are routed correctly.

CHECK BRAKE SYSTEM

After you learn how to operate your tractor, check to see that the brake is operating properly. See “TO CHECK BRAKE” in the Service and Adjustments section of this manual.

✓CHECKLIST

BEFORE YOU OPERATE YOUR NEW TRACTOR, WE WISH TO ASSURE THAT YOU RECEIVE THE BEST PER- FORMANCE AND SATISFACTION FROM THIS QUALITY PRODUCT.

PLEASE REVIEW THE FOLLOWING CHECKLIST:

✓All assembly instructions have been completed.

✓No remaining loose parts in carton.

✓Battery is properly prepared and charged.

✓Seat is adjusted comfortably and tightened securely.

✓All tires are properly inflated. (For shipping purposes, the tires were overinflated at the factory).

✓Be sure mower deck is properly leveled side-to-side/ front-to-rear for best cutting results. (Tires must be properly inflated for leveling).

✓Check mower and drive belts. Be sure they are routed properly around pulleys and inside all belt keepers.

✓Check wiring. See that all connections are still secure and wires are properly clamped.

WHILE LEARNING HOW TO USE YOUR TRACTOR, PAY EXTRA ATTENTION TO THE FOLLOWING IMPORTANT ITEMS:

✓Engine oil is at proper level.

✓Fuel tank is filled with fresh, clean, regular unleaded gasoline.

✓Become familiar with all controls, their location and function. Operate them before you start the engine.

✓Be sure brake system is in safe operating condition.

✓Be sure Operator Presence System and Reverse Op- eration System (ROS) are working properly (See the Operation and Maintenance sections in this manual).

7

Page 6 Page 8
Image 7
Page 6 Page 8
Contents PXT16542 II. Slope Operation Safety RulesSafe Operation Practices for Ride-On Mowers General OperationIV. Towing ServiceGeneral Service III. ChildrenTable of Contents Unassembled Parts Before Removing Tractor from Skid AssemblyTools Required for Assembly To Remove Tractor from CartonCheck for Proper Position of ALL Belts Install Seat See FigCheck Tire Pressure Check Deck LevelnessOperation Know Your Tractor HOW to USE Your Tractor To Transport Before Starting the EngineTo Operate on Hills Towing Carts and Other AttachmentsADD Gasoline Mowing TipsTo Start Engine See Fig Lubrication Chart MaintenancePowdered Graphite Type Lubricant Sparingly Blade Removal See Fig BatteryTractor Blade CareEngine CleaningTo Remove Mower See Fig Service and AdjustmentsTo Install Mower See Fig To Level Mower HousingBelt Removal Belt InstallationTo Replace Mower Blade Drive Belt See Fig To Check BrakeFront Wheel TOE-IN/CAMBER To Adjust Steering Wheel AlignmentInterlocks and Relays To Adjust Throttle Control CableTo Adjust Carburetor To Replace Headlight BulbEngine OIL StorageOther Fuel SystemProblem Cause Correction TroubleshootingExcessive To run when operBattery will not When turningSuggested Guide for Sighting Slopes for Safe Operation Stevens Creek Road Terry Fox Way Augusta, GA 30907 USA Outdoor Products Customer Service DeptHOP Canada contactAutorisé Dept Service Customer Products Outdoor Canada AuGarantie cette de exclus sont normal l’entretien et Degrés MAX Correction Cause Problème Dépannage DE GuidePuissance de Entreposage Carburateur LE Régler Pour Réglages ET RévisionFig la Voir Calandre LA ET Capot LE Enlever Pour Direction DE Volant LA DE L’ALIGNEMENT Régler Pour Fig la VoirVitesses DE Boîte LA DE Mentgechan DE Levier DU Neutre AU RéglageTondeuse DE Lame DE D’ENTRAÎNEMENT Freins LES Vérifier PourCourroie Acer Rempl Pour 16 et 15 .Fig les Voir Lautre À Côté DUN Réglage DE Boîtier LE Niveau DE Mettre PourSedeuton 14 .FIGMoteur EntretienPneus Fig la Voir Lame LA EnleverTrapézoïdales Courroies Lames DES EntretienLubrification DE Tableau Utilisation Chaque AvantMoteur de d’huile niveau le Vérifiez Dhiver Spéciale ET Propre FRAÎCHE, L’ESSENCE DE UtilisationTonte DE Conseils ’ESSENCE Réservoir LE RemplirArrière Marche EN Fonctionnement Accessoires AutresMoteur DU D’HUILE Niveau LE Vérifier Tracteur LE Transporter PourT O S I L I T U GAZ DES Commande LA Utiliser Pour02829 Moteur Sont Courroies LES Toutes SI Vérifier MontageFrein DE Système LE Vérifier Place EN CorrectementCarton LE Deballer DE Tracteur LE Retirer AvantFig la Voir Batterie LA Vérifier Tionrecdi DE Volant LE FixerSiège Montar SIN PiezasSommaire Général Entretien EnfantsEntretien RemorquageGénéral Fonctionnement AvertissementPentes LES Dans Fonctionnement Tracteurs des sécurité toute en l’utilisation pour ConseilsPelouse DE Tracteur PXT16542

424634 specifications

The Poulan 424634 is an impressive lawn care tool designed for both amateur gardeners and professional landscapers. This particular model is a gas-powered string trimmer that offers a combination of power, versatility, and ease of use, making it a must-have for maintaining lawns, gardens, and outdoor spaces.

One of the standout features of the Poulan 424634 is its robust 2-cycle engine. This engine delivers a significant amount of power, ensuring that the trimmer can handle even the toughest jobs. The engine provides reliable performance, making it perfect for cutting through thick grass, weeds, and brush. Additionally, the model is designed for easy starting, minimizing frustration and downtime, which is a crucial factor for professionals who need to work efficiently.

The Poulan 424634 incorporates a unique Easy Start system. This technology allows users to start the trimmer with minimal effort, thanks to its specially designed priming system. This feature is particularly beneficial for those who may not be familiar with gas-powered equipment, as it reduces the learning curve associated with starting and operating a trimmer.

Equipped with a dual line head, the Poulan 424634 provides optimal cutting performance. The dual line feature means that users can create a wider trimming path, significantly improving productivity. This design not only enhances efficiency but also reduces the number of passes needed to achieve a clean cut on edges and around flower beds.

The trimmer is also built with user comfort in mind. The ergonomic handle reduces user fatigue, allowing for extended periods of use without discomfort. The adjustable length feature ensures that users of various heights can find a comfortable grip, promoting better control while trimming.

Furthermore, the Poulan 424634 is designed for durability and longevity. Its high-quality materials are resistant to wear and tear, ensuring that the trimmer can withstand rigorous use over time. This durability makes it a cost-effective choice for those looking to invest in reliable outdoor maintenance equipment.

In summary, the Poulan 424634 stands out due to its powerful 2-cycle engine, Easy Start technology, dual line head, ergonomic design, and durability. Whether you are a homeowner or a professional landscaper, this trimmer provides the performance and convenience needed to keep outdoor spaces in pristine condition.
Top Page Image Contents