Poulan 424008 manual Mowing Tips, ADD Gasoline, To Start Engine See Fig

Page 12

OPERATION

ADD GASOLINE

Fill fuel tank to bottom of filler neck. Do not overfill. Use fresh, clean, regular unleaded gasoline with a minimum of 87 octane. (Use of leaded gasoline will increase carbon and lead oxide deposits and reduce valve life). Do not mix oil with gasoline. Purchase fuel in quantities that can be used within 30 days to assure fuel freshness.

CAUTION: Wipe off any spilled oil or fuel. Do not store, spill or use gasoline near an open flame.

IMPORTANT: WHEN OPERATING IN TEMPERATURES BELOW 32°F(0°C), USE FRESH, CLEAN WINTER GRADE GASOLINE TO HELP INSURE GOOD COLD WEATHER STARTING.

CAUTION:Alcoholblendedfuels(calledgasohol or using ethanol or methanol) can attract mois- ture which leads to separation and formation of acids during storage. Acidic gas can damage the fuel system of an engine while in storage. To avoid engine problems, the fuel system should be emptied before storage of 30 days or longer. Drain the gas tank, start the engine and let it run until the fuel lines and carburetor are empty. Use fresh fuel next season. See Storage Instructions for additional information. Never use engine or carburetor cleaner products in the fuel tank or permanent damage may occur.

TO START ENGINE (See Fig. 4)

When starting the engine for the first time or if the engine has run out of fuel, it will take extra cranking time to move fuel from the tank to the engine.

Sit on seat in operating position, depress clutch/brake pedal and set parking brake.

Place gear shift lever in neutral (N) position.

Move attachment clutch to “DISENGAGED” position.

Move throttle control to choke () position.

NOTE: Before starting, read the warm and cold starting procedures below.

Insert key into ignition and turn key clockwise to “START” position and release key as soon as engine starts. Do not run starter continuously for more than fifteen seconds per minute. If the engine does not start after several attempts, move throttle control to fast position, wait a few minutes and try again. If engine still does not start, move the throttle control back to the choke ( ) position and retry.

WARM WEATHER STARTING (50° F and above)

When engine starts, move the throttle control to the fast position.

The attachments and ground drive can now be used. If the engine does not accept the load, restart the engine and allow it to warm up for one minute using the choke as described above.

COLD WEATHER STARTING ( 50° F and below)

When engine starts, allow engine to run with the throttle control in the choke () position until the engine runs roughly, then move throttle control to fast position. This may require an engine warm-up period from several sec- onds to several minutes, depending on the temperature.

The attachments can also be used during the engine warm-up period.

NOTE: If at a high altitude (above 3000 feet) or in cold temperatures (below 32 F) the carburetor fuel mixture may need to be adjusted for best engine performance. See “TO ADJUST CARBURETOR” in the Service and Adjustments section of this manual.

MOWING TIPS

Mower should be properly leveled for best mowing per- formance. See "TO LEVEL MOWER HOUSING" in the Service and Adjustments section of this manual.

The left hand side of mower should be used for trimming.

Drive so that clippings are discharged onto the area that has been cut. Have the cut area to the right of the machine. This will result in a more even distribution of clippings and more uniform cutting.

When mowing large areas, start by turning to the right so that clippings will discharge away from shrubs, fences, driveways, etc. After one or two rounds, mow in the opposite direction making left hand turns until finished (See Fig. 8).

FIG. 8

If grass is extremely tall, it should be mowed twice to reduce load and possible fire hazard from dried clip- pings. Make first cut relatively high; the second to the desired height.

Do not mow grass when it is wet. Wet grass will plug mower and leave undesirable clumps. Allow grass to dry before mowing.

Always operate engine at full throttle when mow- ing to assure better mowing performance and proper discharge of material. Regulate ground speed by se- lecting a low enough gear to give the mower cutting performance as well as the quality of cut desired.

When operating attachments, select a ground speed that will suit the terrain and give best performance of the attachment being used.

12

Image 12
Contents PXT16542 Safety Rules Safe Operation Practices for Ride-On MowersGeneral Operation II. Slope OperationService General ServiceIII. Children IV. TowingTable of Contents Unassembled Parts Assembly Tools Required for AssemblyTo Remove Tractor from Carton Before Removing Tractor from SkidInstall Seat See Fig Check Tire PressureCheck Deck Levelness Check for Proper Position of ALL BeltsOperation Know Your Tractor HOW to USE Your Tractor Before Starting the Engine To Operate on HillsTowing Carts and Other Attachments To TransportMowing Tips ADD GasolineTo Start Engine See Fig Maintenance Lubrication ChartPowdered Graphite Type Lubricant Sparingly Battery TractorBlade Care Blade Removal See FigCleaning EngineService and Adjustments To Install Mower See FigTo Level Mower Housing To Remove Mower See FigBelt Installation To Replace Mower Blade Drive Belt See FigTo Check Brake Belt RemovalTo Adjust Steering Wheel Alignment Front Wheel TOE-IN/CAMBERTo Adjust Throttle Control Cable To Adjust CarburetorTo Replace Headlight Bulb Interlocks and RelaysStorage OtherFuel System Engine OILTroubleshooting Problem Cause CorrectionTo run when oper Battery will notWhen turning ExcessiveOnly Ride UP and Down Hill Not Across Hill Degrees MAX Fold Alon THI Dotted Line REE LopeOutdoor Products Customer Service Dept HOPCanada contact Stevens Creek Road Terry Fox Way Augusta, GA 30907 USADept Service Customer Products Outdoor Canada Au AutoriséGarantie cette de exclus sont normal l’entretien et Degrés MAX Dépannage DE Guide Correction Cause ProblèmePuissance de Entreposage Réglages ET Révision Carburateur LE Régler PourFig la Voir Calandre LA ET Capot LE Enlever Pour Fig la Voir Vitesses DE Boîte LA DE MentgechanDE Levier DU Neutre AU Réglage Direction DE Volant LA DE L’ALIGNEMENT Régler PourFreins LES Vérifier Pour Tondeuse DE Lame DE D’ENTRAÎNEMENTCourroie Acer Rempl Pour DE Boîtier LE Niveau DE Mettre Pour Sedeuton14 .FIG 16 et 15 .Fig les Voir Lautre À Côté DUN RéglageEntretien MoteurFig la Voir Lame LA Enlever Trapézoïdales CourroiesLames DES Entretien PneusUtilisation Chaque Avant Lubrification DE TableauMoteur de d’huile niveau le Vérifiez Utilisation Tonte DE Conseils’ESSENCE Réservoir LE Remplir Dhiver Spéciale ET Propre FRAÎCHE, L’ESSENCE DEAccessoires Autres Moteur DU D’HUILE Niveau LE VérifierTracteur LE Transporter Pour Arrière Marche EN FonctionnementGAZ DES Commande LA Utiliser Pour T O S I L I T U02829 Moteur Montage Frein DE Système LE VérifierPlace EN Correctement Sont Courroies LES Toutes SI VérifierDE Tracteur LE Retirer Avant Fig la Voir Batterie LA VérifierTionrecdi DE Volant LE Fixer Carton LE DeballerMontar SIN Piezas SiègeSommaire Enfants EntretienRemorquage Général EntretienAvertissement Pentes LES Dans FonctionnementTracteurs des sécurité toute en l’utilisation pour Conseils Général FonctionnementPelouse DE Tracteur PXT16542