Poulan 418793 Before Starting the Engine, Service REMINDER/HOUR Meter, Check Engine OIL Level

Page 15

OPERATION

Transmission Engaged

Transmission Disengaged

FIG. 21

SERVICE REMINDER/HOUR METER

Service reminder shows the total number of hours the engine has run and flashes to indicate that the engine or mower needs servicing. When service is required, the service reminder will flash for two hours. To service engine and mower, see the Maintenance section of this manual.

NOTE: Service reminder runs when the ignition key is in any position but "STOP". For accurate reading, be sure key remains in the "STOP" position when engine is not running.

TOWING CARTS AND OTHER ATTACHMENTS

Tow only the attachments that are recommended by and comply with specifications of the manufacturer of your trac- tor. Use common sense when towing. Too heavy of a load, while on a slope, is dangerous. Tires can lose traction with the ground and cause you to lose control of your tractor.

BEFORE STARTING THE ENGINE

CHECK ENGINE OIL LEVEL

The engine in your tractor has been shipped, from the factory, already filled with summer weight oil.

Check engine oil with tractor on level ground.

Remove oil fill cap/dipstick and wipe clean, reinsert the dipstick and screw cap tight, wait for a few seconds, remove and read oil level. If necessary, add oil until “FULL” mark on dipstick is reached. Do not overfill.

For cold weather operation you should change oil for easier starting (See “OIL VISCOSITY CHART” in the Maintenance section of this manual).

To change engine oil, see the Maintenance section in this manual.

ADD GASOLINE

Fill fuel tank to bottom of filler neck. Do not overfill. Use fresh, clean, regular unleaded gasoline with a minimum of 87 octane. (Use of leaded gasoline will increase carbon and lead oxide deposits and reduce valve life). Do not mix oil with gasoline. Purchase fuel in quantities that can be used within 30 days to assure fuel freshness.

CAUTION: Wipe off any spilled oil or fuel. Do not store, spill or use gasoline near an open flame.

IMPORTANT: WHEN OPERATING IN TEMPERATURES BELOW32°F(0°C), USE FRESH, CLEAN WINTER GRADE GASOLINE TO HELP INSURE GOOD COLD WEATHER STARTING.

CAUTION: Alcohol blended fuels (called gasohol or using ethanol or methanol) can attract moisture which leads to separation and formation of acids during storage. Acidic gas can damage the fuel system of an engine while in storage. To avoid engine problems, the fuel system should be emptied before storage of 30 days or longer. Drain the gas tank, start the engine and let it run until the fuel lines and carburetor are empty. Use fresh fuel next season. See Storage Instructions for additional information. Never use engine or carburetor cleaner products in the fuel tank or permanent damage may occur.

TO START ENGINE (See Fig. 13)

When starting the engine for the first time or if the engine has run out of fuel, it will take extra cranking time to move fuel from the tank to the engine.

Be sure freewheel control is in the transmission en- gaged position.

Sit on seat in operating position, depress brake pedal and set parking brake.

Move attachment clutch to “DISENGAGED” position.

Move throttle control to fast position

Pull choke control out for a cold engine start attempt. For a warm engine start attempt the choke control may not be needed.

NOTE: Before starting, read the warm and cold starting procedures below.

Insert key into ignition and turn key clockwise to “START” position and release key as soon as engine starts. Do not run starter continuously for more than fifteen seconds per minute. If the engine does not start after several attempts, push choke control in, wait a few minutes and try again. If engine still does not start, pull the choke control out and retry.

WARM WEATHER STARTING (50° F and above)

When engine starts, slowly push choke control in until the engine begins to run smoothly. If the engine starts to run roughly, pull the choke control out slightly for a few seconds and then continue to push the control in slowly.

15

Image 15
Contents PBGT26H54X II. Slope Operation Safety RulesSafe Operation Practices for Ride-On Mowers General OperationService III. ChildrenIV. Towing Table of Contents Keys Unassembled PartsMower Mower Front Wheel Slope SheetUnpack Carton AssemblyTools Required for Assembly To Remove Tractor from CartonFirst Install ANTI-SWAY BAR S Install Mower and Drive BeltAssembly Check Brake System Check Tire PressureCheck Deck Levelness Check for Proper Position of ALL BeltsOperation CG F Know Your TractorHOW to USE Your Tractor To SET Parking Brake See FigStopping See Fig To USE Choke Control D See Fig To Adjust Mower Cutting Height See FigTo Adjust Gauge Wheels See Fig To USE Throttle Control See FigTo Operate on Hills Using the Reverse Operation SystemTo Operate Mower See Fig Reverse Operation System ROSADD Gasoline Service REMINDER/HOUR MeterBefore Starting the Engine Check Engine OIL LevelMowing Tips Purge TransmissionAutomatic Transmission Warm UP Schedule MaintenanceMaintenance General RecommendationsTires BatteryTractor Brake OperationEngine Spark Plugs CleaningEngine OIL Filter MufflerTo Level Mower Service and AdjustmentsTo Install Mower To Remove Mower See FigTighten adjust nut To Replace Mower Blade Drive Belt Mower Drive Belt InstallationTo Remove Wheel for Repairs See Fig To Check BrakeTo Replace Motion Drive Belt Front Wheel TOE-IN/CAMBERTo Remove CABLES, Reverse Order To Start Engine with a Weak Battery See FigReplacing Battery See Fig To Attach Jumper CablesTo Replace Headlight Bulb To Adjust Throttle Control CableTo Adjust Choke Control To Adjust CarburetorEngine OIL StorageOther Fuel SystemTroubleshooting Points Engine dies when Limited Warranty Fold Along This Dotted Line Degree Slope Only Ride UP and Down Hill Not Across Hill Degrees MAXParts and Service Changere DE Pièces LES ET L’ENTRETIEN Pliez EST Degrés Suivant LESHOP Connexions les et interrupteurs les câblage, le Vérifiez Dépannage DE GuideLame de mandrin le Remplacez Tordu est lame de mandrin Un Entreposage Carburateur LE Régler Pour Starter DU Commande LA Régler PourGAZ DES Commande LA DE Câble LE Régler Pour Reglages ET RevisionFig la Voir Batterie LA Replacer RougePositif Noir Négatif CâbleCourroie Acer Rempl Pour Fig la Voir Tionsraparé LES Pour Roues LES Enlever PourAvant Roue LA DE PINCEMENT/CARROSSAGE23 32 .FIG LA DE Lame LA DE D’ENTRAÎNEMENTCourroie a L Acer Rempl Pour Tondeuse28 .FIG 31 .FIG29 .FIG 30 .FIGTondeuse LA Enlever Pour Tondeuse LA Installer PourFig la Voir Tondeuse LA Niveau LE Ajuster PourMoteur DE D’HUILE Filtre Ligne EN Installe Dessence FiltreEntretien ’ALLUMAGE BougieSionmistrans LA DE Moteur Fluide AIR À Filtre’AIR Tamis LE Nettoyer LubrificationEN Fonctionnement DE Système ET Fig la Voir Lame LA EnleverUtilisation Chaque Avant Lubrification DE Tableau22 .FIG Avant ET Réinstallation LA Après Purgée ÊtreUtilisation Transmission LA Purger’ESSENCE Réservoir LE Remplir Moteur LE Démarrer PourVoir Tondeuse LA Utiliser Pour 21 et 13 .Fig les VoirROS Arrière CHE -MAR EN Fonctionnement DE Système 20 .FigReculer Pour ET Avancer Pour GAZ DES Commande LA Utiliser PourFig la Voir J Vitess DE Régulateur LE Utiliser Comment Jauge DE Roues LES Régler Pour15 .FIG Fig la Voir Arrêter PourFig la Voir Mentnetionsta DE Frein LE Engager Pour 16 .FIG13 .FIG Froid moteur un démarrer de permet Détrangleur Commande N’EMBRAYAGE NI DE EST Tondeuse LA SI Vérifier MontageLa sur bras du l’orifice Placez Châssis AU Tondeuse 11 .FIG 10 .FIGSupport le derrière situé bielle la de l’orifice par Du gauche la à Commencez E Avant Bielle LA Fixez ’avantLa insérez tondeuse, la de droit côté le par commençant En Courroie LA ET Tondeuse LA InstallerROULIS-ANTI Barre LA D’ABORD Installez Figs les Voir D’ENTRAÎNEMENTPAL LA DE Tracteur LE Retirer Pour LA DE Tracteur LE Retirer PourArrières esllieB Montées NON PiécesClés Pente-Guide Roue TondeuseSL-SG-API U1R DimensionSommaire CCA .MIN AMP/HR’ESSENCE DE Sûre Manipulation Général EntretienTracteurs des sécurité toute En l’utilisation pour ConseilsTracteurs des sécurité toute en l’utilisation pour Conseils Jardin DE Tracteur PBGT26H54X Modèle Lopérateur DE Manuel